Pelco RK101 User Manual

4 (1)

Installation/Operation

RK100 and RK101

Rack Mount Kits

C1967M-A (6/02)

Pelco World Headquarters • 3500 Pelco Way, Clovis, CA 93612-5699 USA • www.pelco.com

USA & Canada: Tel: 800/289-9100 • Fax: 800/289-9150

International: Tel: 1-559/292-1981 • Fax: 1-559/348-1120

Pelco RK101 User Manual

DESCRIPTION

The RK100 Rack Mount Kit provides rack mounting for the QD104 Series Quad Video Processor while the RK101 Rack Mount Kit does the same for the DX2000DH Data Hub. The RK100 and RK101 are similar except for minor differences in dimensions and the location of screw holes. These kits support the mounting of one or two units per rack.

INSTALLATION

The RK100 and RK0101 rack mount kits contain the following parts:

Qty Description

1V bracket

1Mounting block

2Short rack ear

1Long rack ear

4Screw, 10-32 x 0.75-inch Phillips, pan head screw (black)

4Screw, 6-32 x 0.312-inch Phillips, pan head screw

Single Mount

To rack mount one QD104 Series Quad Video Processor or one DX2000DH Data Hub, refer to Figure 1. (Only the quad is shown in the drawing. Installation of the data hub is similar.) Do the following:

1Remove the front and center screws from both sides of the unit’s cover. Use two of the screws and attach the short rack ear to either the left side or right side (illustration shows installed on left side) of the unit.

2Use the remaining two screws and attach the long rack ear to the opposite side (illustration shows installed on right side) of the unit.

3 Use the four black, Phillips, pan head screws (supplied) and mount the assembly to the rack.

1

2

3

3

Figure 1. Single Mount (Quad Unit Shown)

[ 2 ] Pelco Manual C1967M-A (6/02)

Loading...
+ 2 hidden pages