®
3500 Pelco Way
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1(559) 292-1981
FAX +1(559) 348-1120
www.pelco.com
C1497M-A (2/02)
LD-DF5 Series
Lower Dome
DESCRIPTION
The LD-DF5 Series Lower Dome is designed specifically for the DF5 Series and DF5S Series
Fixed-Mount Domes. The window of the lower dome is made of acrylic and the trim ring is made of aluminum.
Models
LD-DF5-0 Hemispherical dome, smoked
LD-DF5-1 Hemispherical dome, clear, with liner
LD-DF5-2 Hemispherical dome, chrome
LD-DF5-3 Hemispherical dome, gold
LD-DF5-0F Flat window, smoked
LD-DF5-1F Flat window, clear
LD-DF5-2F Flat window, chrome
INSTALLATION
1. Snap the clip, that is, on the end of the trim ring leash into the hole on the lip of the back box.
2. If you have a clear dome, position the dome liner so the slot aligns with the camera lens.
3. Line up the snaps on the trim ring with |
|
the mounting screws on the back box. |
|
Snap the trim ring into the plastic snap |
Figure 1. Lower Dome Installation |
washers on the mounting screws. |
MAINTENANCE
Clean the acrylic dome as necessary to maintain a clear picture. Be careful not to scratch the surface of the dome.
Exterior Surface – Use a nonabrasive cleaning cloth and cleaning agent that is safe for acrylic plastic.
Interior Surface (Except Chrome or Gold) – Clean the same as the exterior surface.
Interior Surface (Chrome or Gold) – The inside surface of a chrome or gold dome is easily scratched. Use the following precautions to maintain the dome’s surface.
1.Always handle the dome from the outside of its circular flange.
2.Never touch the coated inside surface.
3.If dust or other contaminants accumulate, remove the debris with compressed air. Compressed air cans are available from photographic equipment or electronic supply dealers.
4.If heavy residue accumulates and cannot be removed with air pressure, rinse with water and immediately dry with air pressure so water spots will not remain. Avoid wiping the coated surface with direct hand pressure.
5.If internal wiping is necessary, avoid hand rubbing. Instead, make a wick as follows:
Use a very soft paper towel. Roll a section into a tightly wound tube. Tear the tube in half, and wet the fuzzy end of the wick with a solution of isopropyl alcohol diluted with water.
Hold the dome with its opening facing downward and wipe the interior of the dome with the wet end of the wick. Use a circular motion, starting from the outside and spiraling into the center. Use a new wick for each two passes over the dome.