PANASONIC SA-PM17, CR16 Service Manual

5 (2)

1CR16 MECHANISM DISASSMBLY/ASSEMBLY PROCEDURE

1.1.Procedure for removing CD loading mechanism

1.2.2.Replacement for the disc tray

1.Turn off by pressing power SW in the body.

2.Pull out AC plug after the indication of [GOOD-BYE], then disassemble the body.

3.Disassemble the body, and take out CD loading mechanism.

4.Perform disassembly according to the following procedure for disassembly.

1.2.CR16 mechanism disassembly procedure

1.2.1.Gera for servicing (as jig) information

This unit has a gear which used for chacking items (open/close of disc tray, up/down operation of traverse unit by manually) when servicing. (For gear information, that is described on the items for disassembly procedures.)

For preparation of gear (for servicing), perform the procedures as follows.

In case of re-servicing the same set, the “ gear for servicing” may be took off because it had been used. So, the “gear for servicing” must be stored.

1.Remove the gear attachied to top cover of CD loading mechanism.

2. Insert the hexgonel wrench (2.5mm) into the gear.

1

2

1.2.3.Replacement for the traverse deck

Follow the (Step 1) - (Step 10) of item 1.2.2.

3

PANASONIC SA-PM17, CR16 Service Manual

1.2.4.Disassembly for CD loading unit

Follow the (Step 1) - (Step 10) of item 1.2.2.

Follow the (Step 1) - (Step 4) of item 1.2.3.

4

5

6

Loading...
+ 13 hidden pages