Onkyo SKW-208 User Manual

Powered Subwoofer

SKW-208

Instruction Manual

Thank you for purchasing an Onkyo powered subwoofer. Please read this manual thoroughly before using the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new powered subwoofer.

Please retain this manual for future reference.

Bedienungsanleitung

Herzlichen Glückwunsch zum Kauf eines aktiven Subwoofers von Onkyo.

Bitte lesen Sie sich diese Bedienungsanleitung vor Herstellen der Verbindungen und vor dem Einschalten vollständig durch. Wenn Sie sich an die in dieser Anleitung aufgeführten Tips halten, werden Sie schnell in der Lage sein, die Qualität des aktiven Subwoofers voll auszukosten.

Bitte heben Sie diese Bedienungsanleitung für später auf.

English

Contents

Important Safety Instructions........	En-2
Precautions .....................................	En-3
Supplied Accessories ....................	En-3
Controls ...........................................	En-4
Connections ....................................	En-5
Subwoofer effects...........................	En-5
Adjustments ....................................	En-6
Placement........................................	En-6
Troubleshooting..............................	En-6
Specifications .................................	En-6

Deutsch

Inhalt

Wichtige Sicherheitshinweise .......	De-1
Vorsichtsmaßnahmen.....................	De-2
Lieferumfang ...................................	De-2
Bedienelemente ..............................	De-3
Verbindungen..................................	De-4
Subwoofer-Effekte ..........................	De-4
Einstellungen ..................................	De-5
Aufstellung ......................................	De-5
Fehlersuche.....................................	De-5
Technische Daten ...........................	De-6

EnDe

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

WARNING		AVIS
RISK OF ELECTRIC SHOCK		RISQUE DE CHOC ELECTRIQUE
DO NOT OPEN		NE PAS OUVRIR

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient

magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over.

PORTABLE CART WARNING

S3125A

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Damage Requiring Service

Unplug the apparatus from the wall outlet and refer servicing to qualified service personnel under the following conditions:

A.When the power-supply cord or plug is damaged,

B.If liquid has been spilled, or objects have fallen into the apparatus,

C.If the apparatus has been exposed to rain or water,

D.If the apparatus does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the apparatus to its normal operation,

E.If the apparatus has been dropped or damaged in any way, and

F.When the apparatus exhibits a distinct change in performance this indicates a need for service.

16.Object and Liquid Entry

Never push objects of any kind into the apparatus through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock.

The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases shall be placed on the apparatus.

Don’t put candles or other burning objects on top of this unit.

17.Batteries

Always consider the environmental issues and follow local regulations when disposing of batteries.

18.If you install the apparatus in a built-in installation, such as a bookcase or rack, ensure that there is adequate ventilation.

Leave 20 cm (8") of free space at the top and sides and 10 cm (4") at the rear. The rear edge of the shelf or board above the apparatus shall be set 10 cm (4") away from the rear panel or wall, creating a fluelike gap for warm air to escape.

En-2

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal without the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not userserviceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering.

4.Power WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

For British models

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance with the following code:

Blue: Neutral Brown: Live

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IMPORTANT

The plug is fitted with an appropriate fuse. If the fuse needs to be replaced, the replacement fuse must approved by ASTA or BSI to BS1362 and have the same ampere rating as that indicated on the plug. Check for the ASTA mark or the BSI mark on the body of the fuse.

If the power cord’s plug is not suitable for your socket outlets, cut it off and fit a suitable plug. Fit a suitable fuse in the plug.

For European Models

Declaration of Conformity

We, ONKYO EUROPE ELECTRONICS GmbH LIEGNITZERSTRASSE 6, 82194 GROEBENZELL, GERMANY

declare in own responsibility, that the ONKYO product described in this instruction manual is in compliance with the corresponding technical standards such as EN60065, EN55013, EN55020 and EN61000-3-2, -3-3.

GROEBENZELL, GERMANY

K. MIYAGI

ONKYO EUROPE ELECTRONICS GmbH

Placement

•The subwoofer cabinet is made out of wood and is therefore sensitive to extreme temperatures and humidity, do not put it in locations subject to direct sunlight or in humid places, such as near an air conditioner, humidifier, bathroom, or kitchen.

•Do not put water or other liquids close to the subwoofer. If liquid is spilled over the subwoofer, the drive units may be damaged.

•Subwoofer should only be placed on sturdy, flat surfaces that are free from vibration. Putting it on uneven or unstable surfaces, where it may fall and cause damage, will affect the sound quality.

•Subwoofer is designed to be used in the upright vertical position only. Do not use it in the horizontal or tilted position.

•If the subwoofer is used near a turntable, CD player or DVD player, howling or slipping of sound may occur. To prevent this, move it away from the turntable, CD player or DVD player, otherwise lower the unit’s output level.

Supplied Accessories

• Pin connector cable 10 ft. (3 m)

• 4 floor pads for the subwoofer

*In catalogs and on packaging, the letter added to the end of the product name indicates the color of the SKW-208. Specifications and operation are the same regardless of color.

Using the Floor Pads for Subwoofer

	If the subwoofer is placed
	on a hard floor (wood,
	vinyl, tile, etc.) and play-
	back is very loud, the
	subwoofer’s feet may	Pad
	damage the flooring.

To prevent this, place the supplied pads underneath the subwoofer’s feet. The pads also provide a stable base for the subwoofer.

En-3

Controls

FRONT VIEW

a

aSTANDBY/ON indicator

Red: Subwoofer in standby mode Blue: Subwoofer on

The Auto Standby function will automatically set the SKW-208 to Standby mode when there is no input signal, or when the input signal is below a certain level.

Note:

If the Auto Standby function sets the SKW-208 to Standby mode even when an input signal is present, the input signal level is too low. In this case, increase the subwoofer output level on the amplifier or AV receiver connected to the SKW-208.

REAR PANEL

2 3 4

5 6

To AC outlet

bPOWER switch

Press this switch to the ON position to turn on the power. Press it to the OFF position to turn off the power.

cFREQUENCY knob

Use this knob to select the high-frequency range at which to cut off the signal to the subwoofer.

You can select any frequency between 50 Hz and 200 Hz, depending on the characteristics of the speaker system.

dPHASE switch

Use this switch to reverse the phase of the SKW-208. Normally, set the switch to the “NOR” position. Depending on the connected speakers or the installation environment of the SKW-208 however, the “REV” position may result in better sound. Select the switch position that produces a louder bass sound.

eOUTPUT LEVEL knob

Use this knob to adjust the volume of the subwoofer.

fLINE INPUT jack

Connect this jack to the SUBWOOFER PREOUT jacks on the amplifier etc.

En-4