One Stop Gardens 47454 User Manual

0 (0)
Model 47454
ASSEMBLY AND OPERATING INSTRUCTIONS
FENCE CONTROL
WITH ADJUSTABLE SOLAR PANEL
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
Distributed exclusively by Harbor Freight Tools
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Copyright
©
2002 by Harbor Freight Tools
®
. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions or replacement parts, please call 1-800-444-3353.
SPECIFICATIONS TABLE
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, op-
erating, inspection, maintenance and cleaning procedures, parts list and assembly
diagram. Keep your invoice with this manual. Write the invoice number on the inside
of the front cover. Keep this manual and invoice in a safe and dry place for future
reference.
PRODUCT OVERVIEW
The Fence Control is designed to keep only animals confined to a specific area by
emitting an electrical shock. Do not use this product for any other purpose.
GENERAL SAFETY WARNINGS AND PRECAUTIONS
1. KEEP WORK AREA CLEAN AND DRY. Cluttered, damp, or wet work areas
invite injuries.
2. KEEP CHILDREN AWAY FROM WORK AREA. Do not allow children to handle
this product.
3. STORE IDLE EQUIPMENT. When not in use, tools and equipment should be
stored in a dry location to inhibit rust. Always lock up tools and equipment, and
keep out of reach of children.
4. DO NOT USE THIS PRODUCT IF UNDER THE INFLUENCE OF ALCOHOL OR
DRUGS. Read warning labels on prescriptions to determine if your judgement or
reflexes are impaired while taking drugs. If there is any doubt, do not attempt to
use this product.
5. USE EYE PROTECTION. Wear ANSI approved safety impact eyeglasses when
using this product. ANSI approved safety impact eyeglasses are available from
Harbor Freight Tools.
SKU 47454 PAGE 2
6. INDUSTRIAL APPLICATIONS MUST FOLLOW OSHA REQUIREMENTS.
ITEM DESCRIPTION
Input Voltage 8.7 VDC
Output Voltage 8 KV +/- 1.5 KV
Battery Type 6 Volt, DC, Lead Acid, 4.5 AH
Range of Fence Control 3 to 5 Miles (Single Strand Wire)
Solar Panel Type Angle Adjustable
Solar Panel Size 4-1/4” x 3-3/4”
Rated Wattage In Full Sunlight 1.3 Watts
Overall Dimensions 7-1/4” x 6-7/8” x 5-3/8”
Weight 3.65 Lbs.
REV 08e
7. STAY ALERT. Watch what you are doing at all times. Use common sense. Do
not use this product when you are tired or distracted from the job at hand.
8. CHECK FOR DAMAGED PARTS. Before using this product, carefully check that
it will operate properly and perform its intended function. Check for damaged
parts and any other conditions that may affect the operation of this product.
Replace or repair damaged or worn parts immediately.
9. REPLACEMENT PARTS AND ACCESSORIES: When servicing, use only
identical replacement parts. Only use accessories intended for use with this
product. Approved accessories are available from Harbor Freight Tools.
10. MAINTAIN THIS PRODUCT WITH CARE. Keep this product clean for better and
safer performance.
11. MAINTENANCE: For your safety, service and maintenance should be performed
regularly by a qualified technician.
12. USE THE RIGHT TOOL FOR THE JOB. Do not attempt to force a small tool or
attachment to do the work of a larger industrial tool. There are certain
applications for which this tool was designed. It will do the job better and more
safely at the rate for which it was intended. Do not modify this tool, and do not
use this tool for a purpose for which it was not intended.
13. WARNING: The warnings, precautions, and instructions discussed in this manual
cannot cover all possible conditions and situations that may occur. The operator
must understand that common sense and caution are factors, which cannot be
built into this product, but must be supplied by the operator.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1. CAUTION: FOR PERSONAL SAFETY, IT IS RECOMMENDED THAT ONLY A
QUALIFIED, CERTIFIED ELECTRICIAN INSTALL THE FENCE CONTROL.
2. MAINTAIN A SAFE WORKING ENVIRONMENT. Keep the work area well lit.
Make sure there is adequate surrounding workspace. Always keep the work area
free of obstructions, grease, oil, trash, and other debris. Do not use the Fence
Control in areas near flammable chemicals, dusts, and vapors.
3. THIS PRODUCT MUST BE GROUNDED. If for any reason the Fence Control
should malfunction, grounding reduces the risk of accidental electrical shock. A
properly installed ground rod (not provided) electrically connected to the Fence
Control ground terminal provides the necessary grounding of this product.
(See Figure B.)
SKU 47454 PAGE 3
REV 07g
4. DO NOT CONNECT ANY OTHER DEVICE, SUCH AS A POULTRY OR CATTLE
TRAINER, TO A FENCE THAT IS ALREADY CONNECTED TO THE FENCE
CONTROL. Should lightening strike the fence, its damaging electrical force will
be conducted to all other devices.
5. AVOID ACCIDENTAL ELECTRICAL SHOCK. Never install an electric fence
below high voltage power plant transmission lines. Never touch or attempt to
climb over a fence that is electrically charged. Never use more than one Fence
Control on the same fence. Install “Danger! Electric Fence! Risk of Electrical
Shock if Touched! signs in visible areas to identify the electrified wires. Inform
everyone who might possibly come in contact with the electrically charged fence
about its location. Instruct everyone who might possibly come in contact with the
electrically charged fence how to disconnect the Fence Control in case of
emergency.
6. FOR INCREASED PICKUP OF SOLAR ENERGY, select a location with full,
direct sunlight, where the Fence Control can receive at least eight hours of
sunlight each day. Shadowed locations will not allow the Battery (part #10) to
fully charge, and will reduce the hours of effective operation. Make sure to adjust
the Solar Panel (part #2) so that it faces directly at the sun at noontime each day
of the year. (See Figure A, and Assy. Diagram.)
7. ALWAYS KEEP THE SOLAR PANEL (part #2) CLEAN.
(See “Inspection, Maintenance, And Cleaning” section.)
8. DO NOT USE ANY MEANS OF CHARGING THE BATTERY (part #10) OTHER
THAN THE SOLAR PANEL (part #2) OR A CONSTANT-POTENTIAL-
CURRENT-LIMITED BATTERY CHARGER RATED AT 6V DC @ 4.5 AMPS
PER HOUR.
9. DO NOT OVERCHARGE THE BATTERY (part #10) WHEN USING A
CONSTANT-POTENTIAL-CURRENT-LIMITED BATTERY CHARGER. To use a
battery charging system other than the Solar Panel (part #2), the Battery must be
removed from the Fence Control. (See Figure C, and Assy. Diagram.)
10. DO NOT DISPOSE OF BATTERY (part #10) BY FIRE. Fire or intense heat can
cause an explosion. After the life of the Battery has expired, it should be
recycled or disposed of in accordance with procedures for the proper disposal of
waste products.
11. WARNING: This product contains or produces a chemical known to the State of
California to cause cancer and birth defects (or other reproductive harm).
(California Health & Safety Code 25249.5 et seq.)
12. WARNING: People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
SKU 47454 PAGE 4
Loading...
+ 7 hidden pages