Omega AHPE152W, AHPE222W User Manual

0 (0)
]
OPERATION, MAINTENANCE
AND SAFETY INSTRUCTIONS
FOR OMEGA ALTISE PANEL CONVECTION HEATERS
AHPE222W & AHPE152W
OMEGA ALTISE
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT: Read the safety precautions of this booklet carefully before attempting to assemble, install, operate or
maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage. If you are unsure about anything regarding your heater or these instructions, please contact Omega Altise on 1300
1. Read all instructions carefully before using the panel convection heater.
2. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons.
3. Remov e the packa ge and ensur e that the h eater is u ndamaged . In case o f doubt d o not use the heater an d contact Omega Altise Service. Do not let children play with any parts of the package.
4. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
5. Before you use the heater, check if the voltage marked on the rating label corresponds to the mains in your home.
6. When first operated, a slight burning smell may be experienced. This is normal.
7. Avoid using extension cords as the extension cord may overheat and cause a risk of fire.
8. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use the control panel or castor supports when moving the heater (when not wall mounted). Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 1 meter from the front & top of the heater and keep them at least 0.5 meters from the sides and rear. Do not cover.
9. Do not pull the power cord to disconnect with the power source. Always grasp the plug to pull it out.
10. Do not insert any objects into the heater as it may cause an electric shock or fire or damage to the heater. Do not block or tamper with the heater in any manner while it is in operation. To prevent a possible fire, do not block the air inlet or outlet in any manner. Do not place on soft surfaces, like a bed or long pile carpet, where openings may become blocked.
11. Do not leave the heater unattended. Always unplug the heater when not in use. Always let the heater cool down before moving or storing away.
12. The heater has hot parts inside. It must NOT be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmospheres. This heater is intended for general indoor domestic use ONLY.
13. This heater is not intended for use in wet or damp locations, such as a bathroom or any area containing a bath, shower, wash basin or close to water or damp items. Never locate a heater where it may fall into a bathtub or other water container. It must be positioned or installed so that the controls cannot be touched by a person in a bath or shower. Do not immerse the power cord in any liquid (including water).
14. This heater is for use indoors only.
15. This heater includes an overheat protection safeguard that will turn the unit off should it overheat. If this occurs, remove the plug from the mains socket & allow to cool for 45 minutes, at which point it can be restarted. Check for the reason for the overheating, such as blocked vents, prior to starting up again.
16. Never install or use the heater directly below a wall socket.
17. When fixing on a wall, the heater must be level, securely fixed & at the correct height (check with local authorities if unsure). There must be at least 150mm between it and any barrier/wall to the sides, bottom or top to prevent overheating or damage.
18. Always use the heater with the castors supplied on level floors or attached to a wall with the supplied brackets.
WARNING: The Main Power Switch and the On/Off switch should not be used as the sole means of
WARNING: To avoid danger of electric shock, unplug from outlet when not in use and before cleaning. If the
795 572 in Australia or (09) 415 600 in New Zealand before operating your appliance.
disconnecting power. Always unplug the power cord before servicing or moving the unit.
supply cord is damaged, it must be replaced by a special cord or assembly available from an authorized person. In order to avoid overheating, do not cover the heater. The heater must NOT be located immediately below a socket outlet. Do not use the heater in the immediate surrounding of a bath, shower or swimming pool.
OMEGA ALTISE
CONTROL FUNCTIONS
A. POWER INDICATOR 1. TEMPERATURE SELECT BUTTON B1. NUMERIC DISPLAY B. LED DISPLAY 2. POWER/SET BUTTON B2. LOW POWER INDICATOR
3. UP BUTTON B3. HIGH POWER INDICATOR
4. DOWN BUTTON B4. HEATER RUNNING INDICATOR B5. TEMPERATURE SET INDICATOR B6. TIMER SET INDICATOR
GETTING STARTED
1. Carefully remove the heater from packaging and the carton, and unwind the cord to its full length.
2. Either fit the castors & place the heater onto a stable, flat and dry surface, or fit the mounting brackets to a stable wall & hang from the wall in a dry position away from open or running water. See installation sections for details.
3. Turn the heater off at the power switch (on the right hand side of the unit). Plug the cord set into a 220-240V~A.C. 50Hz electrical outlet. Turn the power on at the electrical outlet.
4. Turn the heater on at the power switch (on the right hand side of the unit). The power indicator will light up (but no LED display) indicating the unit is in “stand-by mode”. If the LED is lit up, press the “power/set” button for 3 seconds to put it into “stand-by mode”. The heater is now ready for use. Refer to the operating instructions section further in this manual for the full operation of your heater. The power indicator will remain lit until the power switch on the heater side is turned off or the heater is unplugged from the electrical outlet.
NOTE: When the heater element is working, the indicator B4 will be lit. Once the heater has reached its required temperature, the element is turned off & the indicator B4 also turns off. NOTE: Heater must have castors fitted or be attached to a wall before use.
OMEGA ALTISE
Loading...
+ 5 hidden pages