Genuine OKI®
Type C3 Toner Cartridges
Black, #41515208 • Cyan, # 41515207 • Magenta, #41515206 • Yellow, #41515205
Installation Instructions
1.Turn the printer off.
2.Pull up on the handle and open the top cover.
3.Locate the cartridge to be changed:
a.Pull the blue lock lever to the right (away from the open cover) as far as it will go.
b.Lift the cartridge then slide it toward the back (to clear the tube) and lift it out. Discard it in accordance with local regulations.
4.Unpack the new toner cartridge and shake it back and forth to distribute the toner.
5.Carefully remove the tape.
5.Lower the port end of the toner cartridge into the image drum, sliding the port (1) onto the tube (2) on the image drum.
6.Press the cartridge against the tube, then:
a.Lower the other end of the cartridge, aligning the white tab with the groove in the drum.
b.Push the blue lock lever to the left as far as it will go.
Caution!
Be sure to push the lock lever all the way back. If it is not pushed back and you close the cover, the lever could damage the LED printhead.
7.Use the LED lens cleaner supplied with the toner cartridge to clean the corresponding LED head.
8. Close the cover.
9. Turn the printer back on.
Important!
After the new toner is installed, the TONER LOW or TONER EMPTY message should disappear from the display. If it doesn't, try printing a page. If it still doesn't disappear, reinstall the toner cartridge.
Loading...