NuTone CP2TTAB, CP2TNSN, CP2SCSN, CP2PUSN, CP2OKSN Quick Start Manual

...
0 (0)

INSTALLATION & OPERATING INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS

WIRED / WIRELESS DOOR CHIME PUSHBUTTON

To register this product, visit: www.nutone.com

THIS PACKAGE INCLUDES:

nCast Metal Escutcheon

nWired Pushbutton

nWireless Pushbutton and Battery

nMounting Hardware

WIRED PUSHBUTTON INSTALLATION

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.

Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards.

When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

Use NuTone® 16 volt transformer with a minimum rating of 10 VA (purchase separately).

When stapling wires to studs or joists, do not allow staples to cut through wire insulation.

1.Select pushbutton location

and drill a straight and level 3/4” (19 mm) hole, 1”

(25 mm) deep.

2. Make sure that push button assembly (A) is inserted B fully into escutcheon (B).

(Figure 1) Install chime and transformer wires to pushbutton terminals.

3. Install escutcheon/

A

pushbutton assembly

 

into hole and secure with

FIGURE 1

hardware provided.

 

4.Restore power at service entrance and press pushbutton to sound chime.

WIRELESS PUSHBUTTON

INSTALLATION

The wireless pushbutton (C) is compatible with NuTone wireless chimes. (Purchase separately) Refer to installation instructions provided with wireless chime.

1. Open battery cover (D)

D

by sliding it in direction

indicated by arrow.

 

(Figure 2)

 

 

C

 

FIGURE 2

2. Install battery (E) into

 

wireless pushbutton.

E

(Figure 3)

 

+

-

 

FIGURE 3

3. Remove wired pushbutton mechanism from pushbutton / escutcheon assembly by turning pushbutton mechanism counterclockwise and pulling it out. (Figure 4)

2

1

FIGURE 4

4.

Insert wireless

 

 

pushbutton

 

 

mechanism and

 

 

twist clockwise.

 

 

(Figure 5)

 

5.

Test operation.

 

 

Hold wireless

 

 

pushbutton near

 

 

chime and press

1

 

pushbutton. If

 

 

 

chime does not

 

 

sound - see a.

 

 

through c. on

 

 

page 2.

 

2

FIGURE 5

1

NuTone CP2TTAB, CP2TNSN, CP2SCSN, CP2PUSN, CP2OKSN Quick Start Manual

If chime does not sound when wireless pushbutton is pushed:

 

 

BATTERY REPLACEMENT

 

 

 

a. Confirm that code settings on chime mechanism and

 

 

 

wireless pushbutton are the same. (Figure 6)

 

 

 

Wireless Chime

 

 

 

 

 

 

 

 

 

 

Replace batteries following door chime instructions.

WIRELESS PUSHBUTTON - EXAMPLE CODE SETTING

 

Wireless Pushbutton

 

 

 

 

 

CODE SET

 

 

 

Remove wireless pushbutton / escutcheon assembly from wall and follow

 

 

 

 

 

 

 

 

Step 1 in section titled “Wireless Pushbutton Installation”. Replace battery

 

 

 

 

SWITCHES 1-6

 

 

 

 

 

 

 

 

with one N Cell, 1.5V alkaline battery. Close battery cover and re-install

1

8

 

 

 

{

 

 

 

 

 

wireless pushbutton / escutcheon assembly with hardware.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ON

 

 

 

 

ADDITIONAL WIRELESS DOOR

 

{

 

 

 

 

 

 

 

 

CHIMES & PUSHBUTTONS

CODE SET

 

 

 

 

 

 

 

 

SWITCHES 1-6

 

1

2 3

4 5

6 7

8

 

When installing other Wireless Door Chime sets, select different code

 

 

 

 

 

SWITCHES 2, 4, 6

 

settings to avoid interference. If you want all chimes to ring at the same

 

 

 

 

 

 

time, set chimes to the same code settings.

 

 

 

 

 

IN OFF POSITION

 

 

 

 

 

 

 

TROUBLESHOOTING FOR WIRELESS

WIRELESS CHIME - EXAMPLE CODE SETTING

 

 

 

 

INSTALLATIONS

 

(Chime will have jumpers or switches)

 

 

 

 

 

WIRELESS

 

 

 

 

 

The range of the door chime depends on location, temperature and battery

 

 

CHIME

 

 

 

 

 

condition. If you are having problems with this product, please try the

 

 

JUMPERS {

 

 

 

 

 

solutions listed below.

 

 

 

 

 

 

 

Chime rings on its own:

 

 

JUMPERS REMOVED (OFF) FROM 2, 4, 6

 

• A neighbor may have a wireless chime set with the same code settings.

 

 

 

 

 

 

 

 

 

 

Change the chime and pushbutton code settings. (Figure 6)

 

 

WIRELESS

ON

 

 

 

 

Chime doesn’t sound:

 

 

 

 

 

 

 

• Make sure the pushbutton and the chime code settings are the same.

 

 

 

CHIME

 

 

 

 

 

 

 

 

 

 

 

 

 

• Check the batteries in the chime and wireless pushbutton. (Figure 3, 6)

 

 

SWITCHES {

 

 

 

 

 

 

 

1

2 3 4

5

6

 

Batteries are OK, but chime does not work when installed:

 

 

 

 

 

 

 

 

 

SWITCHES 2, 4, 6 IN OFF POSITION

 

• Mounting the chime or pushbutton directly on metal, concrete or near

 

 

 

 

metal studs reduces the range.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FIGURE 6

 

• Do not mount the chime too close to ground level concrete slabs which

 

 

 

 

 

 

 

 

may also reduce the range. Mount the chime away from the floor.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• Try different locations for the chime closer to the pushbutton. Also, try

b. Verify proper installation batteries in chime mechanism and

 

to orient the chime at a different angle to increase the range. Range is

pushbutton. (Figure 3)

 

 

 

 

 

 

 

most effective to the sides of the pushbutton.

c. Check condition of batteries in chime mechanism and pushbutton.

 

Regulatory Information

Replace if required.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The user is cautioned that changes or modifications not expressly

6. Close battery cover on wireless pushbutton.

 

 

 

 

 

 

 

 

approved by the party responsible for regulatory compliance

7. To install wireless pushbutton / escutcheon assembly, drill a straight

 

could void the user’s authority to operate this equipment.

and level 3/4” diameter x 3-1/2” deep hole.

 

 

 

 

 

8. Insert wireless pushbutton / escutcheon assembly into hole and

 

WARRANTY

secure to wall using hardware provided.

 

 

 

 

 

 

 

 

 

 

 

More than one pushbutton can be used with NuTone wireless chimes.

 

 

Refer to Figure 7 to assign a door or tune to each wireless pushbutton.

 

NUTONE ONE YEAR LIMITED WARRANTY

 

 

 

 

 

 

 

 

 

 

WIRELESS PUSHBUTTON - ASSIGN TUNE(S) OR DOOR(S)

 

NuTone warrants to the original consumer purchaser of its products that such products

 

will be free from defects in materials or workmanship for a period of one year from the

 

 

 

 

 

 

 

 

 

 

 

 

1

8

 

 

 

 

 

 

date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED,

 

 

 

 

 

 

 

 

 

 

INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR

 

 

 

 

 

 

 

 

 

 

FITNESS FOR A PARTICULAR PURPOSE.

 

 

 

{

 

 

 

 

 

During this one-year period, NuTone will, at its option, repair or replace, without charge,

 

 

 

 

 

 

 

 

any product or part which is found to be defective under normal use and service.

 

CODE SET SWITCHES 7 & 8

 

 

 

 

 

 

 

 

 

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES,

 

 

 

 

 

 

 

 

 

 

ON

 

 

 

 

 

 

 

 

 

HALOGEN AND INCANDESCENT BULBS, FUSES, FILTERS, DUCTS, ROOF CAPS, WALL

 

 

 

 

 

 

 

 

 

CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover (a) normal

 

 

 

 

 

 

 

 

 

 

maintenance and service or (b) any products or parts which have been subject to misuse,

 

 

 

 

 

 

 

 

 

 

negligence, accident, improper maintenance or repair (other than by NuTone), faulty instal-

 

7

8

7

8

7

8

7

8

 

lation or installation contrary to recommended installation instructions.

Models

 

The duration of any implied warranty is limited to the one-year period as specified for the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

express warranty. Some states do not allow limitation on how long an implied warranty

LA203WH

 

 

 

 

 

 

 

 

 

lasts, so the above limitation may not apply to you.

 

 

 

 

 

 

 

 

 

NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE

LA203RWH

 

 

 

 

 

 

 

 

 

THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE

LA204WH

 

 

 

 

 

 

 

 

 

SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES

 

 

 

 

 

 

 

 

 

ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some

LA204RWH

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

states do not allow the exclusion or limitation of incidental or consequential damages, so

LA205WH

1 Note

2 Note

3 Note

4 Note

 

the above limitation or exclusion may not apply to you.

LA206WH

 

 

 

 

 

 

 

 

 

This warranty gives you specific legal rights, and you may also have other rights, which

LA522WH

 

 

 

 

 

 

 

 

 

vary from state to state. This warranty supersedes all prior warranties.

 

 

 

 

 

 

 

 

 

To qualify for warranty service, you must (a) notify NuTone at the address or telephone

LA532WH

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

number below, (b) give the model number and part identification and (c) describe the

LA533WH

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

nature of any defect in the product or part. At the time of requesting warranty service, you

 

 

 

 

 

 

 

 

 

 

must present evidence of the original purchase date.

LA600WH

Front

Back

Front

Back

 

Broan-NuTone LLC, 926 W. State Street, Hartford, Wisconsin 53027

 

 

 

 

 

 

 

FIGURE 7

 

www.nutone.com 888-336-6151

 

 

 

 

 

 

 

2

99528433B

 

 

 

 

 

 

 

 

 

Loading...
+ 2 hidden pages