Nilfisk C 100.5
Nilfisk C 110.3, C 110.3 X-TRA
User Manual
Index |
|
|
1 |
Safety precautions and warnings ............................................. |
3 |
2 |
Description ............................................................................... |
5 |
3 |
Before you start using your pressure washer........................... |
6 |
4 |
Operating your pressure washer .............................................. |
7 |
5 |
After using your pressure washer............................................. |
9 |
6 |
Maintenance........................................................................... |
10 |
7 |
Trouble shooting ..................................................................... |
12 |
8 |
Further information................................................................. |
13 |
9 |
Technical data ........................................................................ |
14 |
10 |
Declaration ............................................................................. |
14 |
1 Safety Precautions and Warnings
Symbols used to mark in- |
|
|
Before starting |
This symbol is |
structions |
|
|
up your high- |
used to mark safety |
|
|
|
pressure washer |
instructions that |
|
|
|
for the Þ rst time, |
must be ob- |
|
|
|
this instruction |
served to prevent |
|
|
|
manual must be |
damage to the ma- |
|
read through carefully. Save the |
chine and its performance. |
||
|
instructions for later use. |
|
||
|
|
|
|
This symbol in- |
|
|
|
Safety instructions |
dicates tips and |
|
|
|
marked with this |
instructions to |
|
|
|
symbol must be |
simplify work and to ensure a |
|
|
|
observed to pre- |
safe operation. |
|
vent danger to persons. |
|
||
Do not let people who have not been trained in the use of a high pressure washer nor read the instruction manual operate the machine.
This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with the appliance.
Before starting up your machine please check it carefully for any defects. If you Þ nd any, do not start up your machine and contact your NilÞ sk distributor.
Especially check:
The insulation of the electric cable should be faultless and without any cracks. If the electric cable is damaged, an authorized NilÞ sk distributor should replace it.
WARNING!
High pressure jets can be dangerous. Never direct the water jet at persons, pets, live electrical equipment or the machine itself.
Never try to clean clothes or footwear on yourself or other persons.
Hold the spray lance Þ rmly with both hands. The spray lance is affected by a thrust of up to 16.4 N during opeÐ
ration.
The operator and anyone in the immediate vicinity of the site of cleaning should take action to protect themselves from being struck by debris dislodged during operation.
Wear goggles and protection clothes during operation. This appliance has been designed for use with cleaning agents supplied or recommended by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the appliance.
Disconnect from electrical power supply before carrying out user maintenance.
To ensure the appliance
3
safety only use original spare parts from the manufacturer or approved by the manufacturer.
High pressure hoses, Þ ttings and couplings are important for the safety of the appliance. Only use hoses, Þ ttings and couplings recommended by the manufacturer.
Do not use the appliance if a supply cord or important parts of appliance are
damaged, e.g. safety device , high pressure hose and trigger gun.
The appliance is intended to clean cars and garden etc.. Appropriate ear protection has to be used.
Never use the machine in an environment where there could be a danger of explosion. If any doubt arises, please contact the local authorities.
It is not allowed to clean as- bestos-containing surfaces with high pressure.
This high pressure washer must not be used at temperatures below 0¡C.
WARNING!
Inadequate extension cables can be dangerous. Cables on drums should always be completely unwinded to prevent the cable from overheating.
If an extension cable is used, the plug and the socket must be waterproof and comply with the below-mentioned requirements for length and cable dimensions.
1.0 mm² |
max. |
12.5 m |
1.5 mm² |
max. |
20 m |
2.5 mm² |
max. |
30 m |
If the electric cable is damaged, it must be replaced by the manufacturer or his service agent or similarly qualiÞ ed person in order to avoid a hazard.
Mains power connection
The following should be observed when connecting the high pressure washer to the electric installation:
The electric installation shall be made by a certiÞ ed electrician and comply with IEC 364.
It is recommended that the electric supply to this appliance should include either a residual current device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms.
Water connection
Connection to the public mains according to regulations.
Inlet hose can be connected to the water mains with a max. inlet pressure of 10 bars.
This high pressure washer is
only allowed to be connected with the drinking water
mains, when an appropriate
backß ow preventer has been installed, Type BA according to EN 1717. The backß ow preventer can be ordered under number 106411177. The length of the hose between the back- ß ow preventer and the high pressure washer must be at least 10 metres to absorb pos-
sible pressure peaks (min diameter ½ inch).
Operation by suction (for example from a rainwater vessel) is carried out without backß ow preventer. Recommended suction set: 126411387.
As soon as water has ß own through the BA valve, this water is not considered to be drinking water any more.
IMPORTANT! Only use water without any impurities. If there is a risk of running sands in the inlet water (i.e. from your own well), an additional Þ lter should be mounted.
Safety devices
The unloader valve can reduce pressure if it exceeds pre-set values.
Locking device on spray gun (7a) (see illustration at the end of this manual):
The spray gun features a locking device. When the pawl is activated, the spray gun cannot be operated.
Thermal sensor:
A thermal sensor protects the motor against overloading. The machine will restart after a few minutes when the thermal sensor has cooled.
4
2 Description
2.1 Application |
This high-pressure washer has |
|
been developed for domestic |
|
use within: |
|
- Car, motorbike, boat, cara- |
|
van, trailer, patio/drive/flags- |
|
tones, woodwork, brickwork, |
|
barbecue, garden furniture, |
|
lawn mower |
2.2 Operation elements |
See illustration at the end of |
|
and model survey |
this manual. |
|
|
1 |
Start/stop switch |
|
2 |
Water inlet with Þ lter (2a) |
|
3 |
High pressure connection |
|
4 |
High pressure hose |
|
5 |
Electric cable |
|
6 |
Click & Clean spray lance |
|
7 |
Spray gun with lock (7a) |
|
8 |
Click & Clean Tornado¨ |
|
|
nozzle |
|
9 |
Click & Clean Powerspeed¨ |
|
|
nozzle |
Only use the high-pressure washer for purposes described in this manual.
The safety precautions must be observed to prevent damage to the machine, the surface to be cleaned or severe personal injuries.
10Foam sprayer
11Nozzle cleaning tool
12Lance and nozzle holder
13Model tag
14Holder for electric cable (not
standard on all models) 15. Hexagon key
Specifications: See model tag (13) of machine.
We reserve the right to alter the speciÞ cations.
5
3Before you start using your pressure washer
3.1Mounting of trolley handle (models with trolley handle)
1.Place the trolley handle on the machine.
2.Secure the handle by mounting the 2 screws. Use the enclosed hexagon key.
3.2Mounting of quick coupling
3.3Mounting of high pressure hose on spray gun
1.Screw the quick coupling tight on to the water inlet (2).
Note: The inlet
Þlter (2a) must always be Þ tted in the water inlet pipe to Þ lter out
sand, limestone and other impurities as these will damage the pump valves.
Caution: Failure to Þ t the Þ lter will invalidate the guarantee.
1.Attach the high pressure hose (4) to the spray gun (7). Detach the high pressure hose by pressing the pawl
(A).
6
Loading...