OWNER’S MANUAL
28 Bottle Thermoelectric Wine Cooler
MODEL: AW-281E
Please read and save these instructions.
•Remove exterior and interior packing material.
•Check to make sure the following parts are included:
♦6 slide-out shelves
♦Door handle and 2 screws
♦Instruction manual
•Before connecting the appliance to the power supply^ let it stand upright for approximately 2 hours. This will reduce the possibility of raalftmction in the cooling system that may have occurred from handling during transportation.
•Clean the wine cooler's interior surface with lukewarm water using a soft cloth before using the wine cooler for the ffrst time.
•Place the appliance on a floor that is strong enough to support it when it is fully loaded. To level the wine refrigerator, adjust the front feet located on the bottom of the appliance-
•Keep the wine cooler away from direct sunlight and excess heat sources such as stoves, heaters, radiators, etc. Direct sunlight may affect the unit's acrylic coating and heat sources may increase electricity consumption. Extreme cold or hot ambient temperatures may also cause the appliance to perform improperly,
•This unit can be recessed. Please allow a 1” inch clearance all around the unit.
1. |
Door Hinge Cover |
7.. |
Light |
Switch |
2. |
Internal Light |
8. |
Control |
Panel |
3. |
Fan |
9* Magnetic Seal |
||
4. |
Wine Racks |
10. |
Glass Door |
|
5. |
Feet |
11. |
Door Handle |
|
6 . |
Water Reservoir |
12. |
Door Frame |
PowerInput