MODELFA 410TX
Network Card
Installation Guide
Instructions in this guide are for users of Windows® 95 who are installing the Model FA410TX Network Card. For instructions on installing and verifying the Windows 95 network driver, refer to “Install the Windows 95 Network Driver” on the other side of this guide.
These three easy steps provide information for installing your Model FA410TX Network Card:
1.Verify Package Contents
2.Install the Network Card
3.Connect the Network Cables
As a last step, be sure to fill out and send in your warranty card.
Model FA410TX Network Card Installation Giude
Unpack the contents of the package and make sure that you have everything.
Model FA410TX
Network Card
RJ-45 adapter cable
Category 5 10/100 Mbps
UTP cable (provided with
Model FA410TXC Network
Card)
Drivers and
Diagnostics Disk
Installation guide, Warranty & Owner Registration Card
8085FA
Verify PC Requirements
The instructions given in this guide are for using the NETGEAR™ Model FA410TX Network Card in a PC that has a Microsoft® Windows 95 operating system.
Model FA410TX Network Card Installation Giude
The Model FA410TX Network Card is hot swappable, which means it can be inserted into a PC that is either turned off or powered on.
1.Insert the Model FA410TX Network Card into the PCI slot as illustrated in the figure.
Some PCs have two PCI slots. The Model FA410TX Network Card can be inserted into either slot.
2.Insert the RJ-45 adapter cable into the connector on the edge of the network card.
3.Turn on the power to the PC, if you have chosen to install the card with the power turned off.
Model FA410TX
Network Card and
RJ-45 adapter
cable
8086FA
Model FA410TX Network Card Installation Giude
Using the UTP cable that is supplied, connect any port on the hub to the port on the network card.
Note: One of the ports on NETGEAR hubs is switchable between Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable port on a NETGEAR hub to connect to a PC or the network card, make sure the Normal/Uplink push button is set to Normal.
PC with network |
Power adapter |
Notebook PC |
card installed |
|
|
|
|
|
|
|
|
RJ-45 connectors
Hub
Model FA410TX
Network Card with
RJ-45 adapter cable
Category 5 10/100 Mbps UTP cables*
*Use the cable provided or any Category 5 UTP cable. Maximum length = 100 meters (300 feet)
Model FA410TX Network Card Installation Giude