MXIC MX23L8000MC-20, MX23L8000MI-15, MX23L8000TC-15, MX23L8000TC-20, MX23L8000TC-12 Datasheet

MX23L8000

8M-BIT MASK ROM (8 BIT OUTPUT)

FEATURES

•Bit organization

-1M x 8 (byte mode)

•Fast access time

-Random access: 150ns (max.) for 2.7~3.6V

120ns (max.) for 3.0~3.6V

•Current

-Operating: 20mA

-Standby: 5uA

•Supply voltage

-2.7V~3.6V

•Package

-32 pin SOP (450mil)

-32 pin TSOP (8mm x 20mm)

PIN CONFIGURATION

32 SOP

A19							VCC
				32
A16		2		31			A18
A15		3		30			A17
A12		4		29			A14
A7		5		28			A13
A6		6	MX23L8000	27			A8
A5		7		26			A9
A4		8		25			A11
A3		9		24			OE
A2		10		23			A10
A1		11		22				CE
A0		12		21			D7
D0		13		10			D6
D1		14		19			D5
D2		15		18			D4
VSS		16		17			D3

32 TSOP

ORDER INFORMATION

Part No.	Access Time	Package
MX23L8000MC-12	120ns	32 pin SOP
MX23L8000MC-15	150ns	32 pin SOP
MX23L8000MC-20	200ns	32 pin SOP
MX23L8000MI-15	150ns	32 pin SOP
		(Industrial)
MX23L8000MI-20	200ns	32 pin SOP
		(Industrial)
MX23L8000TC-12	120ns	32 pin TSOP
MX23L8000TC-15	150ns	32 pin TSOP
MX23L8000TC-20	200ns	32 pin TSOP
MX23L8000TI-15	150ns	32 pin TSOP
		(Industrial)
MX23L8000TI-20	200ns	32 pin TSOP
		(Industrial)

PIN DESCRIPTION

	Symbol				Pin Function
	A0~A19				Address Inputs
	D0~D7				Data Outputs
					Chip Enable Input
		CE
					Output Enable Input
	OE
	VCC				Power Supply Pin
	VSS				Ground Pin
	NC				No Connection

				32
A11		1				OE
A9		2		31		A10
				30
A8		3				CE
A13		4		29		D7
A14		5		28		D6
A17		6		27		D5
A18		7		26		D4
VCC		8	MX23L8000	25		D3
A19		9		24		VSS
A16		10		23		D2
A15		11		22		D1
A12		12		21		D0
A7		13		20		A0
A6		14		19		A1
A5		15		18		A2
A4		16		17		A3
P/N:PM0335										REV. 1.8, JUL. 16, 2001
					1

		MX23L8000
ABSOLUTE MAXIMUM RATINGS
Item	Symbol	Ratings
Voltage on any Pin Relative to VSS	VIN	-0.3V to 3.9V
Ambient Operating Temperature	Topr	-40°C to 85°C
Storage Temperature	Tstg	-65°C to 125°C

DC CHARACTERISTICS (Ta = -40°C ~ 85°C, VCC = 2.7V~3.6V)

Item	Symbol	MIN.	MAX.	Conditions
Output High Voltage	VOH	VCC-0.2V	-	IOH = -0.4mA
Output Low Voltage	VOL	-	0.4V	IOL = 1.6mA
Input High Voltage	VIH	2.1V	VCC+0.3V
Input Low Voltage	VIL	-0.3V	0.4V
Input Leakage Current	ILI	-	5uA	0V, VCC
Output Leakage Current	ILO	-	5uA	0V, VCC
Operating Current	ICC1	-	20mA	tRC=150ns, all output open
Standby Current (TTL)	ISTB1	-	1mA
				CE=VIH
Standby Current (CMOS)	ISTB2	-	5uA
				CE> VCC - 0.2V
Input Capacitance	CIN	-	10pF	Ta = 25°C, f = 1MHZ
Output Capacitance	COUT	-	10pF	Ta = 25°C, f = 1MHZ

AC CHARACTERISTICS (Ta = -40°C ~ 85°C, VCC = 2.7V~3.6V)

Item	Symbol	23L8000-12			23L8000-15			23L8000-20
		MIN.	MAX.		MIN.	MAX.		MIN.	MAX.
Read Cycle Time	tRC	120ns	-		150ns	-		200ns	-
Address Access Time	tAA	-	120ns	-		150ns		-	200ns
Chip Enable Access Time	tACE	-	120ns	-		150ns		-	200ns
Output Enable Time	tOE	-	60ns	-		70ns		-	100ns
Output Hold After Address	tOH	0ns	-		0ns	-		0ns	-
Output High Z Delay	tHZ	-	20ns	-		20ns		-	20ns

Note:Output high-impedance delay (tHZ) is measured from OE or CE going high, and this parameter guaranteed by design over the full voltage and temperature operating range - not tested.

P/N:PM0335

REV. 1.8,JUL. 16, 2001

2

MX23L8000

AC Test Conditions

Input Pulse Levels	0.4V~2.4V
Input Rise and Fall Times	10ns
Input Timing Level	1.4V
Output Timing Level	1.4V
Output Load	See Figure

IOH (load)=-0.4mA

DOUT

IOL (load)=1.6mA

C<100pF

Note:No output loading is present in tester load board.

Active loading is used and under software programming control.

Output loading capacitance includes load board's and all stray capacitance.

TIMING DIAGRAM

RANDOM READ

ADD	ADD	ADD		ADD
	tACE	tRC
CE
	tOE
OE
		tAA	tOH	tHZ
DATA		VALID	VALID	VALID
	Note:CE, OE are enable

P/N:PM0335

REV. 1.8,JUL. 16, 2001

3