User Manual / Manual del Usuario
©2012 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431. Sunbeam Products, Inc.is a subsidiary of Jarden Corporation (NYSE:JAH).
©2012 Sunbeam Products, Inc. operando bajo el nombre de Jarden Consumer Solutions. Todos los derechos reservados. Distribuido por Sunbeam Products, Inc. operando bajo el nombre de Jarden Consumer Solutions, Boca Raton, Florida 33431. Sunbeam Products, Inc. es una subsidiaria de Jarden Corporation (NYSE:JAH).
U.S. 1-800-MR COFFEE (1-800-672-6333) Canada 1-800-667-8623 Visit us at www.mrcoffee.com / Visítenos en www.mrcoffee.com
Printed in China/Impreso en China |
P.N. 144294 Rev A |
GCDS-MRC23174-VW |
BVMC-KG2_12ESM1 |
BVMC-KG2_11ESM1.indd 1-2 |
|
Single Serve Brewer / Cafetera individual BVMC-KG2
www.mrcoffee.com
2/1/12 2:50 PM
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should be followed, including the following:
1.Read all instructions before using.
2.Do not touch hot surfaces. Use handles and knobs when available. Scalding may occur if the decanter lid is removed during brewing cycles.
3.This appliance must be properly installed and located in accordance with these instructions before it is used.
4.The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electrical shock or injury to persons.
5.Do not place on or near a hot gas or electric burner, or in a heated oven.
6.Do not use outdoors.
7.To protect against fire, electric shock and injury, do not immerse cords, plugs or the appliance in water or any other liquid.
8.Use only water in this appliance! Do not put any other liquids or foods in the Water Reservoir.
9.Turn off and unplug the coffee brewer when not in use and before cleaning. Allow to cool before attaching or removing parts and before cleaning the appliance.
10.Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or is damaged in any manner. Contact your Mr. CoffeeTM Customer Service to arrange for replacement or repair.
11.Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
12.Close supervision is necessary when any appliance is used by or near children.
13.Do not open the brewer while brewing is in progress.
14.Do not use appliance for other than intended use.
2
BVMC-KG2_11ESM1.indd 3-4
CAUTION: There are two sharp needles that puncture the K-Cup® pack, one above the K-Cup® Pack Holder and the other in the bottom of the K-Cup® Pack Holder. To avoid risk of injury, do not put your fingers in the K-Cup® Pack Assembly Housing.
CAUTION: There is extremely hot water in the K-Cup® Pack Holder during the brew process. To avoid risk of injury, do not lift the Handle or open the K-Cup® Pack Assembly Housing during the brewing process.
WARNING: To reduce the risk of fire or electric shock, do not remove any service covers. There are no user serviceable parts inside the coffeemaker. Only authorized personnel should repair the
coffeemaker.
Please read ALL of the instructions in this manual carefully before you begin to use this appliance. Proper care and maintenance will ensure a long life and a trouble-free operation for this appliance. Please save these instructions and refer to them for cleaning and care tips.
save these instructions
3
2/1/12 2:50 PM
SPECIAL CORD SET INSTRUCTIONS
1.A short power supply cord is provided to reduce the hazards resulting from a person or pet becoming entangled in, or tripping over, a longer cord.
2.An extension cord may be purchased and used if care is exercised in its use.
3.If an extension cord is used, the marked electrical rating of the extension cord must be at least 10 amps and 120 volts. The resulting extended cord must be arranged
so that it will not drape over a countertop or tabletop where it can be pulled on by children or tripped over accidentally.
4.This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way.
This product is for household use only
4
BVMC-KG2_11ESM1.indd 5-6
Table of Contents
Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Special Cord Set Instructions. . . . . . . . . . . . . . . . . . . . . . . . . 4 Parts Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Set-Up & How to Brew . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Helpful Hints. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Setting The Clock and Delay Brew Time. . . . . . . . . . . . . . . . .10 Cleaning and Maintaining . . . . . . . . . . . . . . . . . . . . . . . . . . .11 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Service and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
Welcome and congratulations on the purchase of your new Mr. Coffee® Single Serve Brewer. Your new brewer will wake up with you in the morning and provide you breaks and treats during your hectic daily activities.
How you enjoy your Mr. Coffee® Single Serve Brewer is up to you!
5
2/1/12 2:50 PM
PARTS DIAGRAM
6
5 |
4 |
|
1 Brew Now / Off
2 Heating Indicator (Red)
3 Brewing Indicator (Green)
4 Drip Tray Plate
BVMC-KG2_11ESM1.indd 7-8
7 1
5 Drip Tray
6 Lift Handle & Insert
K-Cup® Pack
7 Hot Water Tank
6
2
3
set-up & how to brew
1.Place Brewer upright on a flat surface, remove protective sheet and plug into outlet.
2.DO NOT remove or puncture the foil lid of the K-Cup® Pack.
3.Lift front handle of the brewer to insert a K-Cup® Pack.
4.Place chosen K-Cup® Pack into the K-Cup® Pack Assembly Housing.
CAUTION: There are two sharp needles that puncture the K-Cup® Pack, one above the K-Cup® Pack Holder and the other in the bottom of the K-Cup® Pack Holder.
To avoid risk of injury, do not put your fingers in the K-Cup® Pack Housing Assembly.
7
2/1/12 2:50 PM
5.Lower the handle completely and firmly to close the Lid and puncture the K-Cup® Pack.
6.Depress the water marking button and the hot water tank will open automatically.
7.Fill the Hot Water tank with filtered or bottled water up to the desired fill level without exceeding the max fill line.
Note: Any spills outside the fill area will flow to the drip tray.
8. Close the Hot Water Tank cover.
8
BVMC-KG2_11ESM1.indd 9-10
9.Place a coffee cup in the dispense area on the drip tray. Press the BREW NOW button.
NOTE: Drip Tray can be removed to accommodate larger mugs.
10. When the water reaches temperature, the HEATING light will go off and the brewing light will turn on.
NOTE: Pump will remain on for up to 90 seconds to complete brewing and drying the K-Cup® Pack.
11. Enjoy!
9
2/1/12 2:50 PM
Helpful Hints
•Initial Cleansing Brew – Before you use your Brewer for the first time, perform an initial cleansing brew by running clean water through the brew cycle without using a K-Cup® pack.
•One Cup at a Time – Your new Brewer makes one fresh beverage at a time. You’ll need to add fresh water each time you brew.
•The Right Water Makes a Difference – For the best tasting gourmet coffee, tea or hot cocoa, we recommend using bottled or filtered water. We do not recommend using distilled or reverse osmosis water. Water quality varies from place to place. If you notice an undesirable taste in your cup of coffee such as chlorine or other mineral taste, we recommend you consider using bottled water or water from a filtration system.
•Customize Your Flavor & Brew – With the choice of over 200 varieties of K-Cup® Packs, your Brewer gives you endless options to customize the flavor and strength that’s perfect for you. For a strong, intense cup, select an Extra Bold K-Cup® Pack (with up to 30% more ground coffee than regular varieties). Fill the Hot Water Tank with filtered or bottled water up to the FILL LEVEL indicator and brew normally.
•Brewing Into a Tall Mug – To brew into a tall mug, simply remove the Drip Tray Assembly and place the tall mug on the Drip Tray Base.
•The Drip Tray – Any liquid overflow (from your cup or the Cold Water Reservoir) will be caught in the Drip Tray. Be sure to empty the Drip Tray. The Drip Tray has a snug fit to ensure it stays put in transit.
•Clean Your Brewer Regularly – To keep your Brewer looking and performing its best, be sure to clean the external and internal components on a regular basis. See page 11 for more information.
•De-Scaling – Mineral content in water varies from place
10
BVMC-KG2_11ESM1.indd 11-12
to place. Depending on the mineral content of the water in your area, calcium deposits or scale may build up in your Brewer. Scale is non-toxic, but left unattended, it can hinder Brewer performance. De-scaling your Brewer helps
maintain the heating element and other internal parts of the Brewer that come in contact with water. See page 13 for more information.
•Storing – When storing your Brewer, carefully empty the Drip Tray and make sure the Internal Hot Water Tank is empty. Store your Brewer upright in a safe, dry, frost-free environment.
CLEANING AND MAINTAINING
YOUR SINGLE SERVE BREWER
Cleaning External Parts
IMPORTANT: Make sure the Brewer is unplugged before cleaning Regular cleaning of the Brewer’s external components is recommended.
1. Never immerse the Brewer in water or other liquids. The Housing and other external components may be cleaned with a soapy, damp, non-abrasive cloth.
2. The Drip Tray can accumulate liquids. The Drip Tray and Drip Tray Plate should be periodically inspected and cleaned with a damp soapy nonabrasive lint free cloth. The Drip Tray and Drip Tray Plate should not be put into the dishwasher. To remove the Drip Tray Assembly, simply slide
it toward you, keeping it level at all times to avoid spilling.
Cleaning the K-Cup® Pack Holder Assembly
1.Cleaning the Parts – The K-Cup® Pack Holder Assembly can be placed onto the top shelf of a dishwasher. NOTE: Use low temperature cycles in the dishwasher. To remove from the Brewer, lift the front face of the Brewer. Grasp the top of the K-Cup® Pack Holder with one hand while pushing up on the bottom of the K-Cup® Pack Holder from underneath with the other until it releases. After cleaning,
11
2/1/12 2:50 PM
Loading...