KinectIQ-Pro Tx and KinectIQ-Pro BT Dongle
User manual
KinectIQ-Pro BT Dongle
KinectIQ-Pro BT Dongle
KinectIQ-Pro BT Dongle :
Installation
RF specification :
Hardware Version: 0.3
Software Version: 16.6.9
Operating Temperature : 0C~40C
2402 MHz ~ 2480 MHz
Notice
This device comply with part15 of FCC rules.(FCC Part 15.19(a))
Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device & its accessories must accept any interference received, including interference that may cause
undesired operation.
Class B digital device or peripheral (FCC Part 15.105)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
Caution (FCC Part 15.21) : Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
RF EXPOSURE
This device complies with RF exposure requirement.
Cet appareil est conforme à l'exigence d'exposition RF.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et.
(2) l'utilisateur de l'appareil doit accepter tout brouillage radio electrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement.
Loading...