Page 1
TPMS Installation Manual
(1) Dismount tire and sensor from the wheel. And clear valve stem hole in rim of
any corrosion or dirt.
p.s. The below steps (2)~(5) is just to verify if our sensor can be compatible with
your selected vehicle before installing into the tire.
(2) Please use the ATEQ, Bartec or other TPMS scan tools to check and verify
sensor
Page 2
1
(3) Vehicle Selection (Model, Year,…)
Page 3
2
(4) Tire Select (Choose the tire position)
(5) Trigger the sensor (press the TEST button)
If succeed, the “Pass” button be shone. Once it shows “Fail”, it could mean
the sensor can’t fit to the selected vehicle or other product issues.
(6) Push the valve stem thru the rim, install the washer and nut, then tighten the
nut to 36 in-lb (4 N.m)
Page 4
3
(7) Hold the sensor body against the rim and install then tighten the screw to
20 in-lb (2.2 N.m).
(8) Mount the tire back to vehicle.
Page 5
4
(9) Follow OE re-learn procedures
Please refer to the standard re-learn procedures issued by the selected carmakers.
(10) Finish
As long as the sign is removed from the dashboard , it means TPMS
installation is finished.
(11) FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to thee
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired.
Information to user
The users manual or instruction manual for an intentional or unintentional radiator shall caution the user
that changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. In cases where the manual is provided only in a form other
than paper, such as on a computer disk or over the Internet, the information required by this section may
be included in the manual in that alternative form, provided the user can reasonably be expected to have
the capability to access information in that form.
Page 6
5
TX-P001, TX-P002 Transmitter Specification
Frequency
315 / 433 MHz
Pressure Range
0 ~ 350 KPa / 0 ~ 800 KPa
(Varied by Vehicles Models)
Temperature Range
-40 ~125℃
Operating Humidity
Max. 95%
Operating Temperature
-40 ~105℃
Storage Temperature
-40 ~125℃
Dimensions (Valve Included)
78.5 (L) x 30.8 (W) x 19 (H) mm
Weight (Valve Included)
46 g
Adjustable Angle
0~40 Degrees
Loading...