MITSUBISHI
REAR WHEEL DRIVE
AUTOMATIC TRANSMISSION
WORKSHOP MANUAL
This Workshop Manual contains procedures for removal, disassembly, inspection, adjustment, reassembly and installation, etc. for service mechanics.
All information, illustrations and product descriptions contained in this manual are current as at the time of publication. We, however, reserve the right to make changes at any time without prior notice or obligation.
FILING INSTRUCTION
Please keep these manual pages in the binder No. BN940001.
File these pages according to the signs “Added”, “Revised” and “Deleted” on the “List of effective pages” which are interpreted below.
Added: File the pages with this sign additionally in your manual.
Revised. Deleted: Replace the existing pages with the corresponding pages having this sign.
Missing sheets will be supplied upon request.
Automatic Transmission . . . . . . . . .23A. . .
R4AW2, V4AW2
Automatic Transmission . . . . . . . . .23B. . .
R4AW3, V4AW3
Automatic Transmission . . . . . . . . .23C. . .
V4AW4
Automatic Transmission . . . . . . . . .23D. . .
R4A51, V4A51
Automatic Transmission . . . . . . . . .23E. . .
V5A51
E Mitsubishi Motors Corporation July 2000 |
Pub. No. PWEE8920-J |
CONTENTS
The preceding page contains GROUP INDEX which lists the group title and group number.
PAGE NUMBERS
All page numbers consist of three sets of digits separated by a dash. The digits preceding the dash identify the number of the group and the second digits identify the section. The digits following the dash represent the consecutive page number within the section. The page numbers can be found on the top left or right of each page.
TEXT
Unless otherwise specified, each service procedure covers all models. Procedures covering specific models are identified by the model codes, destination or similar designation (engine type, transmission type, etc.)
SERVICE PROCEDURES
The service steps are arranged in numerical order and attentions to be paid in performing vehicle service are described in detail in SERVICE POINTS.
Denotes tightening torque
NOTE:
D Torque may also be shown in rectangles in the order of units (Nm, kgm and ft-lbs. from left) as follows.
33 3.3 23
D From January 1999 on, torque values are given only in SI unit.