Product and Cut-out Dimensions
F 1911 Vi 36” Freezer (Integrated, left-hinge)
K 1901 Vi 36” Refrigerator (Integrated, right-hinge)
Page 1 of 5
O
E
W
Caution
The appliance is very heavy. Use caution when unpacking and opening the door, danger of tipping.
Location Codes
E- 5 foot – 120 Volt – 15 A 3-wire molded plug power supply connects lower left rear. O- Standard NEMA 5-15 Outlet – locate less than 9” above finished floor
W- ¼” flexible water line – tape to floor (F1911Vi only)
Notes
Merging kit 38996010USA KSK1002 Side-by-side kit must be used when combining units. (Please review the manual) RemoteVision Module needs to be installed prior to install.
All installations must be done in accordance with local codes.
Sides of adjoining cabinets should be filled (flush to frame) to insure proper fit and finish.
Drawing is not to scale Specification Sheets OJS 11112011
Product and Cut-out Dimensions
F 1911 Vi 36” Freezer (Integrated, left-hinge)
K 1901 Vi 36” Refrigerator (Integrated, right-hinge)
Page 2 of 5
Custom Panel Installations
These units do not come equipped with a front panel. They are designed to accept a custom door panel supplied by the cabinet maker. Miele has a unique panel integration system which allows the panels to align with the surrounding cabinets. (See installation section of the manual)
Panel size is determined in the following manner per individual unit:
Panel details for Individual Units
Width: |
35 ¾” in all cases |
|
Thickness: |
Minimum ¾” outside frame |
|
Height: |
Determined using the |
|
|
following calculation: |
|
|
Panel Height = HOC – TKH |
|
|
|
|
|
HOC= Total height of cabinet |
|
|
or side panel |
|
|
TKH= Toe-kick height |
|
Maximum hinge capacity: |
200 Pounds |
|
Maximum panel weight: |
67 Pounds |
|
|
|
|
|
|
|
|
|
Adjoining |
|
Extended |
Panel Notes |
||
|
cabinet |
|
Panel |
If the adjoining cabinets are taller than the height of |
||
|
|
|
|
|
machine (HOM) the front panel may be extended |
|
|
|
|
Machine |
|
||
|
|
|
|
accordingly. Simply maintain the toe-kick height and |
||
|
|
|
|
|
extend the panel for the required distance. |
|
|
|
|
|
|
|
|
Notes
Merging kit 38996010USA KSK1002 Side-by-side kit must be used when combining units. (Please review the manual)
Front panel gap kit 38996050USA used to join two custom panels on one unit. |
|
RemoteVision Module needs to be installed prior to install. |
|
All installations must be done in accordance with local codes. |
|
Drawing is not to scale |
Specification Sheets OJS 11112011 |
Loading...