AWG 102
Operating and installation instructions
External motors
AWG 102
MG 100
DDG 102
ABLG 200
Roof vent kit
DDF 125/150
To avoid the risk of accidents or
damage to the appliance it is
essential to read these operating instructions
before it is installed or used for the first time.
G
M.-Nr. 06 017 040
Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
AWG 102 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
MG 100 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
DDG 102 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
ABLG 200 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
DDF 125/150 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Extraction ducting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Condensate trap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Contents
2
Disposal of the packing material
The transport and protective packing
has been selected from materials which
are environmentally friendly for disposal
and can normally be recycled.
Ensure that any plastic wrappings,
bags etc. are disposed of safely and
kept out of the reach of babies and
young children. Danger of suffocation!
Rather than just throwing these
materials away, please ensure that they
are recycled.
Disposal of your old appliance
Old appliances contain materials which
can be reclaimed or recycled. Please
contact your dealer, your local waste
collection centre or scrap merchant
about potential recycling schemes.
Ensure that the appliance presents no
danger to children while being stored
for disposal.
See the appropriate section in the
Warning and safety instructions.
Caring for the environment
3
This appliance conforms to current
safety requirements. Inappropriate
use can, however, lead to personal
injury and damage to property.
Before installation and before using
for the first time, read the operating
instructions carefully. They contain
important information on safety,
installation, use and maintenance of
the appliance. This way you will
avoid the risk of accidents and
damage to the appliance.
Keep these operating instructions in
a safe place and ensure that all
users are familiar with the contents.
Pass them on to any future owner of
the appliance.
Correct usage
The appliance is intended for
domestic use only. The
manufacturer cannot be held liable for
damage caused by incorrect or
improper use of the appliance.
Technical safety
Before connecting the appliance to
the mains supply, make sure that
the voltage and frequency details given
on the data plate correspond with the
on-site electricity supply, otherwise the
appliance could get damaged. If in any
doubt, consult a qualified electrician.
The electrical safety of this
appliance can only be guaranteed
when continuity is complete between
the appliance and an effective earthing
system which complies with local and
national safety regulations. It is most
important that this basic safety
requirement is present and regularly
tested and where there is any doubt the
household wiring system should be
inspected by a qualified electrician.
The manufacturer cannot be held liable
for the consequences of an inadequate
earthing system (e.g. electric shock).
Installation work and repairs may
only be carried out by suitably
qualified and competent persons to
ensure safety.
Repairs and other work by unqualified
persons could be dangerous and the
manufacturer will not be held liable.
This equipment is not designed for
maritime use or for use in mobile
installations such as caravans, aircraft
etc. However it may be suitable for
such usage subject to a risk
assessment of the installation being
carried out by a suitably qualified
engineer.
Warning and Safety instructions
4
The external motor is only
completely isolated from the
electricity supply when:
–
the cooker hood is switched off at the
wall socket (pull on the plug, not the
cable), or
–
the cable to the cooker hood is
disconnected, or
–
the fuse from the fused spur
connection unit is withdrawn, or
–
the screw-out fuse is removed (in
countries where this is applicable).
Installation
If the control cable needs to be
extended by more than the length
of the extension cable supplied,
equipotential bonding must be carried
out.
There is a connection point on the
external motor, marked with the earth
symbol -, to which the earth lead must
be attached.
All ducting, pipework and fittings
must be of non-flammable material.
These can be obtained from the Miele
Spare Parts department or from
builders' merchants.
The appliance must not be
connected to a chimney or vent
flue which is in use. Neither should it be
connected to ducting which ventilates
rooms with fireplaces.
N.B. AWG 102:
The external motor must be
installed vertically on the outside wall.
The extraction outlet must face
downwards.
N.B. ABLG 200:
If exhaust air is to be extracted into
a chimney or ventilation duct no longer
used for other purposes, seek
professional advice.
N.B. DDG 102, DDF 125/150:
The motor and the roof vent kit are
designed to be installed on tiled,
pantiled, slate or shingle roofs; the
slope of the roof must be at least 10°.
They are not suitable for flat roofs.
When choosing a suitable
installation location, make sure that
it is easily accessible and that
installation work can be carried out
without danger.
This is also important if the appliance
needs to be serviced.
Warning and Safety instructions
5
When using the cooker hood at the
same time as another heating
appliance which depends on the air in
the room, (e.g. gas, oil or coal fired
heaters, continuous flow or other water
heaters, gas cooker, gas hob or gas
oven) special care must be taken, as
the action of the cooker hood extracts
air from the room in which it is installed
and from neighbouring rooms, which
these types of heater need for
combustion.
In order to ensure safe operation, and
to prevent gases given off by the
heating appliances from being drawn
back into the room when the extractor
and the heater are in operation
simultaneously, an underpressure in the
room of 0.04 mbar (4 pa) is the
maximum permissible.
Ventilation can be maintained by air
inlets which cannot be blocked, in
windows, doors and outside wall vents,
or by other technical measures, such
as ensuring that the extractor can only
be switched on when the heating
appliance is switched off or vice-versa.
Note: The overall ventilation condition of
the dwelling must be taken into
account.
If in any doubt, the advice of a
competent builder or, for gas, a “Corgi”
installer must be sought.
Disposal of your old appliance
Before discarding an old
appliance, switch off and
disconnect the control cable from the
cooker hood. Cut off the cable directly
behind the appliance to prevent
misuse. Cut off and render any plug
useless.
This should be done by a competent
person.
The manufacturer cannot be held
liable for damage caused by
non-compliance with these Warning
and safety instructions.
Warning and Safety instructions
6
The external motor is connected to the
cooker hood using a special control
cable and is operated by the control
panel on the cooker hood.
Connection of this appliance and of the
cooker hood to which it is connected
must be carried out in accordance with
DIN VDE 0100, and with local and
national safety regulations.
For extra safety it is advisable to install a
residual current device (RCD) with a trip
current of 30 mA (in accordance with
DIN VDE 0664, VDE 0100 Section 739).
The voltage, rated load and fusing are
given on the data plate on the
appliance housing.
Check that these match the household
mains supply.
The external motor is supplied with a
3 m long extension cable. If the
control cable needs to be extended
further, or if it is to be connected to a
fixed connection point, the
installation must be carried out in
accordance with VDE 0100 / 0700
Part 1, and with local and national
safety regulations.
Equipotential bonding must be
carried out.
There is a screw connection point on
the external motor marked with the
earth symbol -, to which the earth
lead must be attached.
This external motor has been designed
to be connected to a Miele cooker hood
only and must not be connected to a
cooker hood made by another
manufacturer.
Please also read the installation
instructions and electrical connection
pages of the instruction booklet
supplied with the cooker hood to which
the external motor is being connected.
Electrical connection
7
AWG 102
Rated load . . . . . . . . . . . . . . . . 165 W
Voltage. . . . . . . . . . . . . . . . . AC 230 V
Frequency . . . . . . . . . . . . . . . ~ 50 Hz
Fuse rating (UK) . . . . . . . . . . . . . 13 A
Control cable length . . . . . . . . . 0.75 m
Extension cable length . . . . . . . . . 3 m
Extraction power
unrestricted. . . . . . . 440 - 1000 m
3
/h
in practice* . . . . . . . . max. 820 m
3
/h
ABLG 200
Rated load . . . . . . . . . . . . . . . . 315 W
Voltage. . . . . . . . . . . . . . . . . AC 230 V
Frequency . . . . . . . . . . . . . . . ~ 50 Hz
Fuse rating (UK) . . . . . . . . . . . . . 13 A
Extension cable length . . . . . . . . . 3 m
Extraction power
unrestricted . . . . . . . . 230 -900 m
3
/h
in practice* . . . . . . . . max. 720 m
3
/h
MG 100
Rated load. . . . . . . . . . . . . . . . . . 330 W
Voltage . . . . . . . . . . . . . . . . . . AC 230 V
Frequency . . . . . . . . . . . . . . . . ~ 50 Hz
Fuse rating (UK). . . . . . . . . . . . . . . 13 A
Control cable length . . . . . . . . . . 0.75 m
Extension cable length . . . . . . . . . . 3 m
Extraction power
unrestricted . . . . . . . . . 240 - 850 m
3
/h
in practice* . . . . . . . . . max. 730 m
3
/h
DDG 102
Rated load. . . . . . . . . . . . . . . . . . 165 W
Voltage . . . . . . . . . . . . . . . . . . AC 230 V
Frequency . . . . . . . . . . . . . . . . ~ 50 Hz
Fuse rating (UK). . . . . . . . . . . . . . . 13 A
Control cable length . . . . . . . . . . 0.75 m
Extension cable length . . . . . . . . . . 3 m
Extraction power
unrestricted . . . . . . . . 440 -1 000 m
3
/h
in practice* . . . . . . . . . max. 820 m
3
/h
*Measured in the following
built-in situation:
cooker hood, 90° bend, 4 m extraction
ducting to external motor.
Technical data
8
Loading...