Mercedes-Benz C702, C902 Installation Manual
Accessories
Installation Instructions
Mobile phone bracket
Sony Ericsson C702 and C902
© 2008, Daimler AG
11/08
03F067-08
1
M+P-03F-7353
1
Validity
These installation instructions are valid for
vehicles equipped with a
• Mobile phone fitting with interface
(Code 386) or
• Mercedes-Benz mobile phone
(Code 388)
- Each in conjunction with a Sony Ericsson
mobile telephone C702 or C902.
Parts included
• (1) Mobile phone cradle
In the following text, this will be referred to
as "cradle".
General notes
Do not open up the cradle and do not make
any modifications on the cradle. Otherwise
the type approval will be rendered invalid.
Please contact a qualified specialist workshop if you encounter difficulties when
fitting the cradle. Mercedes-Benz recommends that you use a Mercedes-Benz
Service Centre for this purpose.
The manufacturer reserves the right to
change technical details from those shown
in the illustrations contained in these installation instructions.
These installation instructions also refer to
the COMAND and Audio Operating Instructions, the vehicle Owner's Manual and the
mobile phone operating instructions. Please
keep them handy for reference.
At high outside temperatures, the cradle can
become very hot when in operation, as is the
case with the vehicle interior itself.
2
The installation procedure is shown using
the Sony Ericsson C702 mobile telephone as
an example. Follow the same procedure to
install the Sony Ericsson C902 mobiletelephone.
Contents
Fitting the cradle 컄 4
Inserting the mobile telephone 컄 4
Switching to hands-free mode 컄 5
Downloading the phone book 컄 6
Operating instructions 컄 7
Speed-dial keys 컄 8
Removing the mobile phone 컄 9
Removing the cradle 컄 9
3
GRisk of accident
Please comply with the legal regulations of the country in which you are
driving when you use the mobile
phone inside the vehicle.
If it is legally permissible to use the
mobile phone while driving, only do
so when traffic conditions allow for
it. You may otherwise become distracted from the traffic, which may
lead to an accident in which you or
others may be injured.
For safety reasons, while driving,
only use the hands-free system to
make calls.
When you are using the mobile phone
via the hands-free system, drive with
extra caution, close all windows and
try to eliminate background noise.
Please pull over or park the car if
you do not wish to use the handsfree system to make a call. Do not
stop the vehicle or park where it is
prohibited to do so.
Place the telephone module into the
cradle only while the vehicle is at a
standstill. You could otherwise be
distracted and cause an accident.
4
Fitting the cradle
Slide the cradle (1) into the bracket (2) until
it audibly engages.
Inserting the mobile phone
Insert the mobile phone (3) in the cradle (1)
as shown.
Note
To minimise the waiting time, switch the
mobile phone on before inserting it in the
cradle. (Refer to the mobile phone operating
instructions.)
1
2
M+P-03F-7180
a/A
3
1
M+P-03F-7354
5
Switching to hands-free mode
When the mobile telephone is in hands-free
mode, a Bluetooth
®
headset cannot be
used.
To connect the mobile telephone to the
hands-free system of the vehicle, the following settings must be configured on the
mobile phone:
1. Go to Menu 씮 Settings
씮 Profiles 씮 In car 씮 Options
씮 View and edit.
2. Go to Accessory 씮 New Accessory 씮 Car handsfree.
The message Profile updated: In
car appears.
Note
In the Settings menu, select Flight
mode 씮 Don't show.
A small car symbol (arrow) appears on the
mobile phone display (3).
H
3
M+P-03F-7355
6
Transferring the phone book in COMAND
or audio system
Transferring the phone book is not possible
while in Flight mode. Therefore, this
mode should be deactivated. (Please refer to
the mobile telephone operating instructions.)
Do not remove the mobile phone from the
cradle during the telephone book transfer.
Note
It is not possible to access the phone book
on the SIM card via the vehicle's hands-free
system. The telephone entries of the SIM
card may have to be copied into the telephone book of the mobile telephone. (Please
refer to the mobile telephone operating
instructions.)
Editing and creating phone book entries is
not possible using COMAND or the audio
system.
7
Operating instructions
For information on operating the mobile
phone via the multi-function steering wheel
and configuring the run-on time, refer to the
COMAND or Audio Operating Instructions,
or the vehicle Owner's Manual.
The SIM PIN must be entered either on the
mobile phone, in COMAND or in the audio
system. Combined SIM PIN input is not
possible.
Press the æ or ç buttons to change
the volume during a telephone call.
If the mobile phone uses a pre-paid system,
depending on the provider, you might not be
able to make use of some of the hands-free
system functions.
Activating the number blocking feature is
only possible on the mobile phone. (Please
refer to the mobile phone operating instructions.)
If the mobile phone is inserted, it cannot be
switched off via the vehicle. Because of this,
switching to an available twin SIM card is
only possible if the mobile phone is switched
off manually.
It is recommended that you switch off the
mobile telephone's Bluetooth
®
function see the mobile telephone operating instructions.
You should not store too many text messages (SMS) in the Inbox of the mobile phone. (Please refer to the mobile phone
operating instructions.)
For further information about displaying text
messages in COMAND or the audio system,
please consult your Mercedes-Benz Service
Centre.
It is recommendable to switch off the mobile
phone at least once a months. (Please refer
to the mobile phone operating instructions.)
8
Speed-dial keys
Only for vehicles with mobile phone
fittings with interface (code 386) or
Mercedes-Benz mobile telephone
(code 388):
On some vehicle model series, it is possible
to access the memory keys 2 to 9 via the
buttons 2 to 9 in the COMAND or the
audio system. To do this, you must assign
the memory keys 2 to 9 according to your
preferences. (Please refer to the mobile
phone operating instructions.)
Note
The memory position is not displayed on
some types of mobile phone. The corresponding telephone number is displayed by pressing a key between 2 and 9. If you
want to store a different telephone number
in memory positions 2 through 9, these
should be renamed as needed on the mobile
phone.
9
Removing the mobile phone
Slide the locking tab (4) upwards and remove the mobile phone (3) from the cradle (1).
Removing the mobile phone cradle
Press the release button (5), slide the
cradle (1) downwards and remove.
a/A
4
3
1
M+P-03F-7356
1
5
M+P-03F-7246
Loading...