Mazda 0000-8F-Z20, 0000-8F-N11 Instructions Manual

GENUINE ACCESSORIES

1/14/08

1

INSTALLATION INSTRUCTIONS

PART NUMBERS:

0000-8F-Z20 DOCKABLE DVD KIT

DOCKABLE DVD KIT

DVD KIT CONTENTS

APPLICABLE MODELS:

2007 > CX9

TOOLS REQUIRED

PROTECTIVE CLOTH
CORDLESS DRILL

DRILL STOP

8 mm DRILL BIT
FIBER STICK

FELT MARKER
T-10 TORX BIT

#3 PHILLIPS SCREWDRIVER

UTILITY KNIFE
TORQUE WRENCH

GENUINE DOCKABLE DVD KIT

INSTALLATION INSTRUCTIONS

Thank you for purchasing a genuine Mazda accessory.
Before removal and installation, be sure to thoroughly read these instructions.
Please read the contents of this booklet in order to properly install and use the satellite
radio kit. Your safety depends on it.
Keep these instructions with your vehicle records for future reference.

• There are several WARNING and CAUTION sections in this booklet concerning

safety when installing. Always read and follow them in order to prevent injuries,
accidents, and possible damage to the vehicle.

WARNING: Indicates a situation in which serious injury or death could result if the

warning is ignored.

CAUTION: Indicates a situation in which bodily injury or damage to the vehicle

could result if the caution is ignored.

• If in any doubt, please ask your Mazda dealer to install the accessory in order to
prevent errors in installation.

• If you have any questions about the use of the accessory, ask your Mazda dealer for
proper advice before using it.

• Mazda and its suppliers are not responsible for injuries, accidents, and damage to
persons and property that arise from the failure of the dealer or installer to follow these
instructions.

• To ensure safety and reliability of the work, installation, removal and disposal work

done by an Authorized Mazda Dealership is recommended.

• Be careful not to lose removed parts, and be sure that they are kept free from

scratches, grease or other dirt.

PART NAME: DOCKABLE DVD INSTALL KIT
PART NUMBER: 0000 8F N11
VEHICLE: CX9

To the dealer

• Please turn over these instructions to the customer after installation.
To the customer

• Keep these instructions after installation. The instructions may be necessary for
installing other optional parts or removal of this accessory.

• Should the vehicle or this accessory be resold, always leave these instructions

with it for the next owner.

NOTE

WARNING

1/14/08

2

1/14/08

3

1/14/08

4

1.) MARKING AND CUTTING THE HEADLINER

1/14/08

5

1.) USING A FIBER STICK CAREFULLY REMOVE THE
HEADLINER PUSHPIN LOCATED BEHIND THE CENTER
DOMELIGHT.

2.) ALIGN THE TEMPLATE ON THE CENTER DOME

LIGHT AND REINSTALL THE PUSHPIN TO HOLD THE
TEMPLATE IN PLACE.

1/14/08

6

1/14/08

7

1/14/08

8