Mazda 0000-8E-G01 Instructions Manual

GENUINE ACCESSORIES

INSTALLATION INTRUCTIONS

PART NUMBER:

0000 - 8E - G01

PACKAGE CONTENTS

CRADLE (QTY.2)

NUT (QTY.2) WASHER (QTY.2) SCREW (QTY.2)

HITCH NUT (QTY.1) LOCK WASHER (QTY.1) HITCH BOLT (QTY.1)

2 BIKE CARRIER, HITCH

WORLD STRAP (QTY.4)

CARRIER MAST

(QTY.1)

CABLE LOCK

(QTY.1)

APPLICABLE MODELS:

1996>MPV
2001>TRIBUTE

LOCK POST

(QTY.1)

“C” CLIP

(QTY.1)

HITCH NUT HOLDER (QTY.1)

HITCH LOCK (QTY.1)

BOLT (QTY.2) CLEAR SLEEVE (QTY.1) WASHER (QTY.2) NUT (QTY.2)

0

BEFORE INSTALLATION

READ THESE WARNINGS:

• HITCH LOAD IS LIMITED TO THREE BIKES WITH THE
ADDITION OF ONE CRADLE.

• OFF-ROAD DRIVING IS NOT RECOMMENDED AND COULD
RESULT IN DAMAGE TO YOUR VEHICLE OR YOUR BIKES.

CARRIER BASE (QTY.1)

KEY (QTY.2)

TOOLS REQUIRED

2 ADJUSTABLE-END WRENCHES

3/4 INCH SOCKET WRENCH

FLATHEAD SCREWDRIVER

1032601C-1/4

PART #1032601 REV.C

1

PUSH BASE ONTO
CARRIER MAST.

2

ALIGN HOLES IN MAST AND BASE.

AT CENTER HOLE NEAR END: INSERT BOLT
AND WASHER. ATTACH ANOTHER WASHER
AND NUT TO BOLT.

3

TIGHTEN WITH
ADJUSTABLE
WRENCHES.

TIGHTEN WITH
ADJUSTABLE-END
WRENCHES.

SECURE WIRE
ONTO END OF
HITCH PIN.

4

WARNING:

DO NOT

OVERTIGHTEN

THIS BOLT!

8

• POSITION FLAT SURFACE OF HITCH NUT
INTO HITCH NUT HOLDER.

• SLIDE INTO CARRIER’S HITCH END.

• BOLT SHOULD ENTER AT
OF NUT, NOT THE HOLDER.

INSERT SECOND BOLT
INTO ADJACENT HOLE.

POSITION CLEAR SLEEVE SO
BOLT CAN PASS THROUGH.
ATTACH NUT.

65

ROUNDED SURFACE

INSERT PIN INTO
HOLES IN PLATES AND
THROUGH MAST.

97

ATTACH BASE TO HITCH.

INSTALL HITCH BOLT AND LOCK-WASHER.

INSERT HITCH BOLT AND
WASHER FROM LEFT TO RIGHT.

1032601C-2/4

USE A 3/4 INCH SOCKET
WRENCH AND TIGHTEN.

THE HOLE IN HITCH MUST

ALIGN TO HOLE IN

CARRIER BASE.

1110

ATTACH THE HITCH LOCK,
LOCK THE CARRIER TO THE VEHICLE.

• INSERT THE KEY, LOCK THE HITCH LOCK.

• CLOSE THE LOCK CAP.