Size:
31.09 Kb
Download

K00333/K00334 TRAY SLIDE KIT 1/2/3 DOOR

Installation Instructions

TOP VIEWS OF CABINET SHOWING TRAY SLIDE PILASTER POSITIONS

1 Dr.

2 Dr.

 

Thumbscrew

3 Dr.

 

 

K00333 PARTS LIST

Item

Qty.

Part No.

Description

1

4

3203343

Wire Shelf Pilaster

2

16

6022201

Tray Slide

3

4

6022301

Tray Slide Pilaster

 

 

K00334 PARTS LIST

Item

Qty.

Part No.

Description

1

4

3203343

Wire Shelf Pilaster

2

16

6022201

Tray Slide

3

1

6022191

Tray Slide Pilaster - 2 Dr.

4

3

6022301

Tray Slide Pilaster

5

47”

9202503

Tape, Extruded

READ INSTRUCTIONS COMPLETELY BEFORE INSTALLATION

1. Remove all wire shelves from door opening. Remove existing pilasters by removing the thumbscrews at the top and lifting up and off the mounting studs.

2. (Use steps 2 and 3, when installing on bottom half.) Use top slotted holes on tray slide pilaster, as shown in Fig. 3. Press in and down to lock into place.

Manitowoc Ice, Inc.

2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720USA

8010553

Telephone 920-682-0161,Fax - Sales:920-683-7589,Service/Parts:920-683-7585,Other:920-683-7879

Sheet 1 of 2

Web Site - www.manitowocice.com

Rev. 04/01/99

3.Install your precut wire shelf pilasters to the top half of your cabinet above the tray slide pilaster. Note: when installing your wire shelf pilaster above the tray slide pilaster on the2-door,the top of the pilaster closest to the drain tube must be cut off to an overall length of 17.625” for clearance. The thumbscrews should be used to lock the shelf pilasters in place at the top of the cabinet.

4.(Use steps 4 and 5, when installing on top half.) Install your precut wire shelf pilasters to the bottom half of the cabinet first.

5.Install your tray slide pilasters using the bottom slotted holes on the pilaster, as shown in Fig. 4. Press in and down to lock into place. Use the thumbscrews to lock into place.

6.When installing a full cabinet door of tray slides, always start with the bottom and work up, making sure the top and bottom pilasters are flush where they meet.

7.Hang tray slides on tray slide pilaster with tap openings facing down (see Fig. 1). Insert shelf clips at desired levels. There should be no less than a minimum of 9” between the top wire rack or tray slide and evaporator drain pan.

NOTE: The2-doorkit is K00334. When installing this kit, the notched pilaster goes around the drain tube on the top back wall. The foam tape should be installed between the tray slide pilaster (on the pilaster) and the back wall of the cabinet (see Fig. 2).

Mounting Stud

 

 

Tray Slide

Cabinet

 

 

Foam Tape

Fig. 1

Tray Slide Pilaster

 

 

 

Drain

Mounting Stud

Bottom Half

Tube

 

 

Inside Set of

 

Slots are used

 

for Left/Right

 

Front Corner

 

Location

Fig. 2

Fig. 3

Fig. 4

 

Bottom Half

Top Half

Mounting Stud

Top Half

8010553 Sheet 2 of 2 Rev. 04/01/99