Size:
14.98 Kb
Download

ICE CUBERS T ICE DISPENSERST ICE STORAGE BINS

REACH-INREFRIGERATORS & FREEZERS

ISO 9001 Quality System Certified

INSTRUCTIONS FOR REPLACING COMPRESSOR IN COMPRESSOR ASSEMBLY 7620443 230V/60 HZ/3 PHASE

A-2200,A-1100,B-1100,C-1100SERIES MACHINES

E-1100SERIES MACHINES WITH BRISTOL

WITH BRISTOL REPLACEMENT COMPRESSOR

REPLACEMENT COMPRESSORS

The Bristol model M13A163**** compressor is set up as a

The Bristol model M13A163**** compressor is set up as a

direct field replacement for the Tecumseh AH7514A

direct field replacement for the Tecumseh AH7514A

compressor. The mounting foot

pattern on the Bristol is

compressor. The mounting foot pattern on the Bristol is

exactly the same as the Tecumseh.

To get the tubing to line

exactly the same as the Tecumseh. The Bristol should be

up, the Bristol compressor should be turned 90°. In the case

installed in the machine with the compressor terminal box to

of the 1100 series, the compressor terminal box will be back

the front of the machine. The process tube can be easily bent

against the ice machine’s bulkhead.

 

into position.

The A, B, and C vintage machines have 3/4” suction lines; the

The Bristol compressor is wired the same as the Tecumseh

Bristol is set up with 5/8”. A short piece of 5/8” tubing is

and will take the same nameplate refrigerant charge.

needed to be used as an adapter sleeve. It will fit the

 

compressor suction spud and can be slipped inside the 3/4”

 

existing tubing. All the other tubes are readily field adaptable.

 

The Bristol does use a different start capacitor, run capacitor, and start relay. These are supplied with service compressors. They must be changed at the time of installation.

The Bristol compressor is wired the same as the Tecumseh and will take the same nameplate refrigerant charge. It is important to change the drier whenever opening the refrigeration system. Check your Manitowoc Parts Manual for correct drier size.

If this Bristol compressor is replacing a Copeland Compressor, a lead wire conversion kit, 7621883, may be necessary. This is available through your local Manitowoc distributor.

This replacement compressor may be different than the original compressor and/or have slightly different tubing configurations. The suction line, discharge line, and/or suction service line at the compressor may need to be rerouted, when making this change-out.

8003184 Revised 10/26/95

MANITOWOC EQUIPMENT WORKS

Division of The Manitowoc Company, Inc. 2110 South 26th Street, P.O. Box 1720, Manitowoc, WI54221-1720U.S.A.( 414-682-0161FAX414-683-7879