POWER-FIN®
BOILER
Submittal Sheet
PBE-Sub-05
POWER-FIN® GAS BOILER 1.5, 1.7, 2.0 MBH MODELS
JOB NAME ______________________________________________________________________
LOCATION ______________________________________________________________________
ARCH./ENGR.____________________________________________________________________
MECH. CONTRACTOR ___________________________________________________________
MODEL NO. _____________________________________________________________________
TYPE GAS ______________________________________________________________________
Btu/hr INPUT__________________________________Btu/hr OUTPUT____________________
NOTES
Standard Features
•87% Thermal Efficiency
•25 - 100% Infinitely Proportional Firing Rate
•Digital Display w/ Alarm & Status LED’s
•Variable Frequency Drive
•Digital Temperature Control Accurate to 1ºF
•Tamper Resistant Temperature Controls
•Alcromesh Burner with 5-Year Limited Warranty
•Low NOx Operation Exceeds the most
Stringent Air Quality Requirements
•Low Gas Pressure Operation
•Selectable Supply/Return Temperature Controls
•ASME Copper Finned TubeHeat Exchanger
•160 PSI Working Pressure
•Gasketless Heat Exchanger Design
•Pump Delay
•Glass-Lined Water Surfaces
•Low Gas Pressure Operation
•Zero Clearance to Combustible Materials
•Temperature and Pressure Gauge
•ASME Pressure Relief Valve
•Down Stream Test Cock
•Adjustable High Limit w/ Manual Reset
•Flow Switch
•Small Footprint
•24 Volt Circuit Breaker
•Freeze Protection
•Construction Air Filter
•10 Year Limited Warranty on Heat Exchanger (See warranty for details)
Optional Equipment
Place an X in the box by all options that apply
Alarm Bell
Contacts on any Failure Contacts for Air Louvers Cupro-Nickel Heat Exchanger
High Gas Pressure Switch w/ Manual Reset Low Gas Pressure Switch w/ Manual Reset Indoor/Outdoor Reset
Low Water Cut-Off Probe Type
Probe Type Manual Reset w/ Test
HARMONY SEQUENCER |
|
1-4 Unit Master Control Module |
SMP2100 |
5-12 Unit Extension Module |
SMP2101 |
Outdoor Air Sensor |
SMP2102 |
Harmony Sequencer Ordering Information
Sequencing of up to 4 Units requires the following:
1 - SMP3100 Master Control Module
Sequencing of 5 - 12 units requires the following:
1 - SMP3100 Master Control Module
and 1 - SMP3101 Extension Module
Firing Control Systems
M9 |
HSI (Standard) |
M13 |
GE GAP/FM/IRI |
M7 |
California Code |