Livarno 10270B/ JL-T009 User Manual [en, cs, de]

Loading...

LED  SOLAR LIGHT

LED  SOLAR LIGHT

LED  SOLÁRNÍ SVÍTIDLO

Assembly,  operating and safety instructions

Pokyny  k montáži, obsluze a bezpečnostní pokyny

LED-SOLARLEUCHTE

Montage -, Bedienungsund Sicherheitshinweise

IAN 105108

Before  reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device.

Před  čtením si otevřete stranu s obrázky a potom se seznamte se všemi funkcemi přístroje.

Klappen  Sie vor dem Lesen die Seite mit den Abbildungen aus und machen Sie sich anschließend mit allen Funktionen  des Gerätes vertraut.

GB

Assembly, operating and safety instructions

Page

5

CZ

Pokyny k montáži, obsluze a bezpečnostní pokyny

Strana

11

DE / AT / CH

Montage-, Bedienungsund Sicherheitshinweise

Seite

17

A

10270B

 

1

 

2

 

3

 

4

B

2

5

6

7

C

8

9

Introduction

 

 

Intended use.........................................................................................................................................

Page

6

Parts description...................................................................................................................................

Page

6

Scope of delivery.................................................................................................................................

Page

6

Technical Data.....................................................................................................................................

Page

6

Safety notices

 

 

Product-specific safety instructions......................................................................................................

Page

6

Safety instructions for rechargeable batteries....................................................................................

Page

7

Functionality..................................................................................................................................

Page

7

Start-up

 

 

Mounting the light................................................................................................................................

Page

7

Installing the light.................................................................................................................................

Page

7

Replacing the rechargeable battery...................................................................................................

Page

8

Charging..............................................................................................................................................

Page

8

Maintenance and Cleaning...............................................................................................

Page

8

Troubleshooting.........................................................................................................................

Page

8

Disposal.............................................................................................................................................

Page

9

Warranty and Service

 

 

Service address....................................................................................................................................

Page

9

Manufacturer.......................................................................................................................................

Page

9

GB 5

LED Solar Light

Introduction

Familiarise yourself with the device before using it for the first time. In addition, please carefully refer to the operating

instructions and the safety advice below. Use the product only as described and for the indicated purpose. Keep these instructions in a safe place. If you pass the device on to anyone else, please ensure that you also pass on all the documentation.

Intended use

The solar light is intended as outdoor ambient/decorative lighting. The integrated solar cell and the rechargeable battery allow usage independent from the electricity grid. Any modification to the product are considered improper use and may result in considerable hazards. The manufacturer will not accept liability for loss or damage arising from improper use. This device is not intended for commercial use.

Parts description

1Lamp shade

2Solar cell housing

3Light body

4Ground stake

5Solar cell

6ON / OFF switch

7Retaining screw

8Battery compartment

9Rechargeable battery

Scope of delivery

1 LED solar light

1Rechargeable NIMH battery, AA, 600 mAh, 1.2 V 

1 Instructions for assembly and use

Technical Data

Item/Model no.:

10270B / JL-T009

Dimensions

 

 

 

(without ground stake):

approx. 15 x 40 cm (ø x h)

Weight:

approx. 410 g

Rechargeable battery:

1 x NIMH, AA, 600 mAh,

 

1.2 V 

 

 

 

 

Illuminant:

4 x LED (not replaceable)

Rated output LED:

approx. 0.025 W per LED

Protection type:

IP44 (splash-proof)

Safety notices

PLEASE READ THE INSTRUCTIONS FOR USE PRIOR TO USE! PLEASE KEEP THE INSTRUCTIONS IN A SAFE PLACE! IF PASSING THIS PRODUCT ON TO A THIRD PARTY, INCLUDE ALL DOCUMENTS!

This device may be used by children age

8 years and up, as well as by persons with reduced physical, sensory or mental capacities, or lacking experience and/or knowledge, so long as they are supervised or instructed in the safe use of the device and understand the associated risks. Children should not be allowed to play with the device. Cleaning and user maintenance should not be performed by children without supervision.

Do not use the product if you detect any type of damage.

Switch the product off whilst storing in a dark environment to prevent draining the battery.

Product-specific safety instructions

Make sure the solar cell is free of dirt and free of snow and ice in winter. Otherwise the performance of the solar panel will diminish. Cold temperatures negatively impact the battery operating time. If the solar garden light will not be used for extended periods, e.g. in

6 GB

winter, it should be cleaned and stored in a dry, warm location.

The solar light is intended as an outdoor accent light.

Safety instructions for rechargeable batteries

RISK OF AC-

CIDENT AND DANGER TO LIFE FOR INFANTS AND CHILDREN!

Rechargeable batteries are not intended to be in the hands of children. Do not leave the batteries lying around. They may otherwise be swallowed by children or pets. If accidentally swallowed seek immediate medical attention.

CAUTION! EXPLOSION HAZARD! Use only rechargeable batteries of the recommended type.

Other rechargeable or single-use batteries could explode during charging.

FIRE HAZARD! Do not allow rechargeable batteries to short-circuit. Otherwise the rechargeable batter-

ies may overheat, become a fire hazard or explode.

CAUTION! EXPLOSION HAZARD! Never throw rechargeable batteries into fire or water.

Outdated or used rechargeable batteries may leak chemicals which damage the product. Remove, therefore, the rechargeable battery when the lamp is not required for any length of time.

WEAR PROTECTIVE GLOVES! If they come into contact with skin,

leaked or damaged rechargeable batteries could cause chemical burns; you should therefore wear suitable protective gloves at all times if such an event occurs. Only use rechargeable batteries of the correct size and and the recommended type (see section ”Technical Data”).

Ensure correct polarity, indicated in the battery compartment.

Functionality

The integrated solar cell of the article converts solar radiation into electrical energy and stores it in the NiMH rechargeable battery. Switches on the light as it begins to get dark. The built-in LED is an energy-saving illuminant with a very long life. The light duration depends on the amount of sunlight, the angle of light on the solar panel and the temperature (the battery capacity is temperature-de- pendent). A vertical angle of light at temperatures above the freezing point is ideal. The rechargeable battery will only achieve its maximum capacity after several charging and discharging cycles.

Start-up

Mounting the light

Rotate the solar cell housing 2 counterclockwise out of the lampshade 1 .

Set the ON/OFF switch 6 to the position marked „ON“ to allow the product to switch on in the dark.

Insert the solar cell housing 2 into the lampshade 1 and turn clockwise to secure.

Attach the lampshade 1 to the lamp body 3 .

Attach the ground stake 4 to the lamp body

3 with the tip pointing down.

Your solar light is now ready for use.

Installing the light

Push the assembled solar light far enough into the ground (lawn, flower bed) so it is stable. Make sure it is firmly positioned. Do not use any force when assembling or setting up the product, e.g. hammer blows. This will damage the product. In order to achieve the best result, set the solar garden lamp up in a place where the solar cell will get direct sunlight for as long as possible.

Make sure the solar cell is not impacted by other light sources, e.g. yardor street lighting, or the light will not switch on at twilight.

GB 7

In low light the light will automatically switch on, and automatically switch off in normal ambient light.

Replacing the rechargeable battery

The batteries should be replaced every 12 months to ensure optimum performance.

Remove the lampshade 1 from the lamp

body

3

.

 

 

 

 

Rotate the solar cell housing

 

 

counter-

2

clockwise out of the lampshade

 

 

.

1

Switch off the light using the ON/OFF switch 6 by setting the switch to the „OFF“ position. Remove the fixing screws 7 using a small cross-tip screwdriver.

Replace the old rechargeable battery 9 with a new one. Be sure to insert the batteries in the correct direction. This is shown inside the battery compartment 8 . Use only rechargeable batteries of the recommended type (see „Technical Data“).

Tighten the retaining screws 7 with a small cross-tip screwdriver. Slide the ON/OFF switch 6 to the „ON“ position.

Reattach the solar cell housing 2 to the lamp shade 1 . Then assemble the remaining parts of the lamp.

Charging

Please note, the solar garden light must be switched on when the battery is charging. The battery charging period using the solar cell depends on the intensity of the sunlight and the angle incidence of the light on the solar cell. Place the solar cell as perpendicular as possible to the angle of light incidence. In this way you will receive the highest light levels.

Maintenance and Cleaning

The LEDs cannot be replaced. The solar lamp is maintenance-free, except for any necessary change of battery.

Clean the solar lamp regularly with a dry, non-fluffing cloth. Use a slightly moist cloth to remove any stubborn dirt.

Troubleshooting

Note: the device contains sensitive electronic components. For this reason it is possible that it can be disrupted by radio transmitting equipment in the immediate vicinity. If you notice that the device is malfunctioning, remove any sources of interference from the area of the device.

Note: Electrostatic discharge can cause malfunctions. In the event of such malfunctions briefly remove and reinsert the rechargeable batteries.

Fault

Cause

Solution

The light will

Artificial sour-

Place the light in

not switch on

ces of light,

a location whe-

even though

e.g. street

re it will not be

the sun shone

lighting, inter-

affected by

on the lamp all

fere with the

other light

day.

lamp.

sources.

 

 

 

The light does

The recharge-

Replace the

not come on or

able battery

rechargeable

comes on only

is broken or

battery or mount

briefly.

there was not

the lamp in a

 

enough day-

place where it

 

light.

can receive

 

 

more sunlight.

 

 

 

8 GB

+ 17 hidden pages