Link electronic 1151 User Manual

LINK ELECTRONICS, INC.
DigiFlex 1151
MADE IN THE USA
1000 SERIES DIGIFLEX
FEATURES
White ClipOp Amp. TechnologyEight Outputs, 7 LoopingDC Coupled±3dB Gain100 MHZ BandwidthDiff. Gain and Phase 0.1
The DigiFlex 1151 is a state-of-the-art analog video distribution amplifier with cable equalization and white clip. The 1151 provides high-performance analog video distribution in the LINK DigiFlex 1000 Frame. The advantage is obvious: both analog and digital distribution amplifiers can operate side­by-side in a single frame!
Utilizing the latest CMF Op-Amp technology, the 1151 combines wide bandwidth, low noise, and low power consumption. The video path is truly transparent, with differential phase and gain errors of <0.1° noise ratio exceeds 65dB. Frequency response is exceptionally flat beyond 40MHz and features a gentle roll-off to -3dB at 100MHz–perfect for analog HDTV. Eight outputs are provided on it’s companion rear cell, 1011. The 1011 has only 7 outputs if the input is specified looping.
and <0.1%, respectively. Video signal-to-
Mounting Frame Options
1000 - Single Power Supply, Holds 11 Modules 1000/2 - Dual Power Supply, Holds 10 Modules 7200 - Mounting Frame, Holds 1 Module
DC-coupled differential input is a standard feature, providing high common-mode rejection. Cable equalization is adjustable from the front card edge and can compensate for loss in coax cable up to 1000 feet of Belden 8281. Clamp is referenced to back porch. White clip is adjustable from the front card edge with a range of 100 IRE units ±30 IRE units.
The attention to detail in the design of the 1151 extends to the power supply, which features a simple switching regulator. While slightly more complex than a linear supply, this offers the highest possible efficiency. In addition, this unit is backed by a ten-year warranty including parts and labor
Two convenient mounting frames are available for the DigiFlex series products, 1000 and 7200.
LINK ELECTRONICS, INC. 2137 Rust Avenue Cape Girardeau, MO 63703-7668
Phone 573 334 4433
FAX 573 334 9255
DIGIFLEX 1151
White Clip Video Distribution Amplifier
INPUT:
Video Level: ............................................................ 1.0 Vp-p±3dB
Impedance: ......................................................... 75 ohms , bridging
Common Mode Range: .......................................................... 5Vp-p
Maximum DC In: .............................................................. ±5 VDC
CMRR: ....................................................................... 70dB
Return Loss, Non Looping Input: .......................................... >45dB @ 5 MHz
Return Loss, Looping Input: .............................................. >35dB @ 5 MHz
OUTPUTS:
Number: ...................................... Eight (8), BNC; option 7 outputs with looping
Level:................................................................ Unity Gain ±3dB
AMPLIFIER PERFORMANCE:
Frequency Response: ..................................................±0.5dB to 55 MHz
....................................................................±1dB to 60MHz
..................................................................3.0dB to 100 MHz
Differential Gain: ................................................ <0.1%, 10% to 90% APL
Differential Phase:................................................ <0.1°, 10% to 90% APL
Clamping Action:............................................... 40dB for 10% to 90% APL
.......................................................................6dB @60Hz
DC Gain Stability: ............................................................... 0.2%
Signal-to-Noise: ................................................................ >65dB
Hum: ........................................................... >70dB, below 1.0V p-p
Output Isolation: .................................................... > 45dB at 3.58 MHz
Return Loss: ........................................................... 50dB to 5 MHz
Tilt: ......................................................................... <0.4%
Ringing:...................................................................... <0.4%
High Freq. Overshoot: ........................................................... <0.4%
Coupling:................................................DC Servo, Average DC output =0
Harmonic Distortion: ................................................ SC @ 3.58Hz, 2Vp-p
............................................................. Less than 0.4% ( 48dB)
FRONT CONTROLS:
Gain Control:................................................. ±3dB continuous from unity
White Clip: ....................................................... 100 IRE ±30 IRE Units
Cable Equalizer: ................................................. Equalizes up to 1000 Ft
ENVIRONMENTAL:
Temperature:....................................................... 0° to 50° C, ambient
Humidity:................................................... 10% to 90% non-condensing
POWER:
DC Voltages:
+5 VDC: ................................................. 50mA
-5 VDC: .................................................. 50mA
MECHANICAL:
Height: ................................................ 3.5 inches
Width :.................................................... 1 Inch
Depth: ................................................. 10 Inches
Weight: ............................................... 7.1 Ounces
Mounting: ....................................Mounts in 1000 or 7200
LINK ELECTRONICS, INC.
2137 Rust Avenue
Cape Girardeau, MO 63703
Phone: 573 334 4433
FAX: 573 334 9255
PROFESSIONAL SERIES-­modular television system products--by
LINK
REARCELL 1011
1151/101002
Loading...