Linear ACT-34D, ACT-31D User Manual

0 (0)
Linear ACT-34D, ACT-31D User Manual

ACT-31D

 

 

DESCRIPTION

PROGRAM TRANSMITTER INTO RECEIVER

 

The ACT-31D and ACT-34D are TRANS PROX devices that

Linear’s receivers that accept “Block Coding” can be

 

 

 

 

 

 

contain a radio transmitter as well as a proximity tag. Access

programmed to accept a user defined block of ID codes. The

ACT-34D

 

can be requested by pressing a TRANS PROX button to send

ACT-31D and ACT-34D TRANS PROXs are block coded. Each

 

a wireless signal to a Linear MegaCode receiver, or by

block of TRANS PROX is labeled with starting and ending

 

 

 

moving the unit within two inches of a proximity reader.

block code numbers, along with an optional facility code

 

ACT-31D

ACT-34D

The ACT-31D is a single-button miniature TRANS PROX

number. Refer to the receiver instructions for details on how

TRANS

PROX

 

that sends one wireless code. The ACT-34D is a four-button

to program the block and facility code numbers.

 

 

 

miniature TRANS PROX that sends four different wireless

For non Block Coded

single learning receivers, press

Integrated transmitter

 

codes, depending on which button is pressed.

the desired TRANS PROX button while the receiver is in

& proximity tag

 

In addition to each unit’s MegaCode radio transmission

programming mode to program that button into the receiver.

 

 

 

capabilities (factory set from over a million possible ID codes),

Refer to the access system instructions for details on how to

 

 

 

both units contain a built-in proximity tag. The proximity tag

program the proximity tag into the system.

Operation

 

 

is factory programmed to the same ID and facility code as

USE AS A

 

 

 

the transmitter using card access 26-bit Wiegand format.

 

 

 

PROXIMITY TAG

TRANS PROX

Instructions

 

The unit’s proximity tag functions with Linear’s Model AM-PR

 

 

 

 

 

proximity reader.

 

 

 

 

 

 

The TRANS PROXs are powered by two Type 2016 “coin cell”

LINEAR

 

 

USA & Canada (800) 421-1587 & (800) 392-0123

 

MODEL

USE AS A

 

 

batteries. A 2-part key ring is supplied with the units.

AM-PR

 

(760) 438-7000 - Toll Free FAX (800) 468-1340

 

 

TRANSMITTER

 

 

 

 

 

 

www.linearcorp.com

 

 

 

 

 

 

 

REPLACING BATTERIES

 

LINEAR LIMITED WARRANTY

 

 

 

 

 

This Linear product is warranted against defects in material and workmanship for twelve (12) months.

1 TWIST A COIN IN SLOT TO

2 REMOVE THE BACK OF THE CASE

3 REMOVE THE TWO

This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal

distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from

OPEN TRANSMITTER CASE

 

 

BATTERIES

their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or liabilities on

 

 

 

 

 

the part of Linear LLC for consequential damages arising out of or in connection with use or performance of

 

 

 

 

 

this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal,

 

 

 

 

 

installation, or reinstallation. All implied warranties, including implied warranties for merchantability and

 

 

 

 

 

implied warranties for fitness, are valid only until the warranty expires. This Linear LLC Warranty is in lieu

 

 

 

 

 

of all other warranties express or implied.

 

 

 

 

 

 

All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact

 

 

 

 

 

Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.

 

 

 

 

DISCARD BATTERIES

IMPORTANT !!!

 

 

 

 

Linear radio controls provide a reliable communications link and fill an important need in portable wireless

 

 

 

 

PROPERLY

signaling. However, there are some limitations which must be observed.

 

 

 

 

 

• For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15

4

 

 

 

5

devices. As such, they have limited transmitter power and therefore limited range.

 

 

 

• A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio

 

 

 

signals that occur on or near their operating frequencies, regardless of code settings.

 

 

 

 

 

SLIDE IN TWO NEW

 

 

 

• Changes or modifications to the device may void FCC compliance.

 

 

SNAP CASE

• Infrequently used radio links should be tested regularly to protect against undetected interference or

TYPE 2016 BATTERIES

 

 

 

 

TOGETHER

fault.

 

 

 

 

 

• A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor

 

 

 

 

 

BE SURE BOTH PLUS (+)

 

 

 

or dealer, and these facts should be communicated to the ultimate users.

SIDES ARE FACING AWAY

 

 

 

• This device complies with FCC Part 15 and Industry Canada Rules and Regulations. Operation is subject

 

 

 

to the following two conditions: (1) This device may not cause harmful interference, and (2) this device

FROM THE CIRCUIT BOARD

 

 

 

 

 

 

must accept any interference received, including interference that may cause undesired operation.

 

 

 

 

 

Copyright © 2008 Linear LLC

228330 B

Loading...