Linear ACT-31B, ACT-34B User Manual

			DESCRIPTION	PROGRAM TRANSMITTER INTO RECEIVER
		Linear’s MegaCode® series of digital transmitters are wireless		Refer to the instructions provided with the receiver to program
		radio controls designed for use with MegaCode format receivers. the transmitter into the receiver’s memory. With the receiver in
		The MegaCode radio format provides unparalleled security. Each		a programming mode, press the desired transmitter button to
	ACT-31B/34B	transmitter is pre-set at the factory to one of over 1,000,000		program that button into the receiver.
		codes.
	MINIATURE	The ACT-31B is a single-button transmitter that sends a unique
		code to a single device. The ACT-34B is a four-button miniature
	DIGITAL	transmitter that sends a unique code for each button. Typically, one
	TRANSMITTERS	button is used to operate a community access gate, another button
		can activate an individual’s garage door, the other two buttons can
	Operation	activate additional automatic doors or other devices.
		The transmitters are powered by two Type 2016 “coin cell” batteries.		Linear’s receivers that accept “Block Coding” can be programmed
	Instructions
		A 2-part key ring is supplied with the units.		to accept a user defined block of ID codes. These transmitters are
				block coded. Each block of transmitters is labeled with starting and
				ending block code numbers, along with an optional facility code
				number. Refer to the instructions for details on how to program the
	[phone] • FAX [phone]			block and facility code numbers.
	USA & Canada [phone] & [phone]
	Toll Free FAX [phone]
	www.linearcorp.com
		REPLACING BATTERY		LINEAR LIMITED WARRANTY
				This Linear product is warranted against defects in material and workmanship for twelve (12) months. The
	1 TWIST A COIN IN SLOT TO	2 REMOVE THE BACK OF THE CASE	3 REMOVE THE TWO	Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers
				who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this
	OPEN TRANSMITTER CASE		BATTERIES	product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s
				warranty, if any. There are no obligations or liabilities on the part of Linear Corporation for consequential
				damages arising out of or in connection with use or performance of this product or other indirect damages
				with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied
				warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only
				until Warranty Expiration Date as labeled on the product. This Linear Corporation Warranty is in lieu of all
				other warranties express or implied.
				All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact
				Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.
			DISCARD BATTERIES	IMPORTANT !!!
			PROPERLY	Linear radio controls provide a reliable communications link and fill an important need in portable wireless
				signaling. However, there are some limitations which must be observed.
	4		5	• For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15
				devices. As such, they have limited transmitter power and therefore limited range.
				• A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio
	SLIDE IN TWO NEW			signals that occur on or near their operating frequencies, regardless of code settings.
			SNAP CASE	• Changes or modifications to the device may void FCC compliance.
	TYPE 2016 BATTERIES
			TOGETHER	• Infrequently used radio links should be tested regularly to protect against undetected interference or
				fault.
	BE SURE BOTH PLUS (+)			• A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor
	SIDES ARE FACING AWAY			or dealer, and these facts should be communicated to the ultimate users.
				• This device complies with FCC Part 15 and Industry Canada Rules and Regulations. Operation is subject to the
	FROM THE CIRCUIT BOARD
				following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
				interference received, including interference that may cause undesired operation.
				Copyright © 2000 Linear Corporation	217397 A