Lightolier F7000-28 User Manual

Size:
152.42 Kb
Download

Lighting Systems F7000-28

1BHF PG

' 4FSJFT -JHIU5-FOT8BMM .PVOU

3.25”

5

4

6

(8.26cm)

1.63”

(4.14cm)

1

9.60” (24.38cm)

Ordering Information

Family Series Type Lamps Color Wattage Voltage Length

FW7

 

 

7

 

 

6

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7 = Wedge

 

 

6 = Wedge lens

 

1 = 1 Lamp

 

 

AL = Aluminum

 

1

= 28W

 

1 = 120v

 

 

4 = 4’ (121.92cm)

 

 

 

 

 

 

 

 

 

 

 

 

WH = White

 

2

= 54W

 

2 = 277v

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3 = 28W Dimming

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4

= 28W EM

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5 = 54W Dimming

 

 

 

 

 

Complete Ordering Instructions below.

 

 

 

 

 

 

 

 

 

 

 

6

= 54W EM

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Features

1.Housing: Single piece of high purity extruded aluminum, a portion from recycled material.

2.Housing End: Die-castaluminum, welded in place.

3.End Cap: Die-castaluminum. Encloses the end of the run.

4.Lamps: F28T5 or F54T5HO as specified. By others. Installed from the ceiling side of the luminaire.

5.Ballast: Electronic. Meets ANSI starting,end-of-lifeprotection and sound rating specifications. Low THD.

6.Lens: Two-piececompound lens consisting ofinjection-molded,bidirectional prismatic acrylic with an extruded, linear prismatic acrylic lower layer.

Electrical

Connections: Pre-wiredwith 18 gauge wires and polarized cannon plug connectors for simultaneous mechanical/electrical connection.

Emergency Battery Pack: 90 minute operation, 700 lumens for 54W and 520 lumens for 28W.

Dimming: Advance Mark X standard (no additional wires required); use compatible dimmer. Dimming ballasts using additional control wires (eg LutronHi-LumeorECO-10,Osram) can be used; consult factory and use X4 or X5 power feeds

with additional leads, as appropriate. Ballast not to exceed 1.25” (3.18cm) wide by 1.20” (3.05cm) high.

iGEN: F7000 accepts iGEN (DALI) with supplemental2-wirecontrol technology. Use with X5 power feed.

Power Tray: Code-gauge,die-formedsteel,pre-paintwhite enamel finish; secured byquarter-turnfasteners for easy access to wiring. Holds ballasts, sockets, and wiring. Accepts ballasts up to 1.25” (3.18cm) wide by 1.20” (3.05cm) high.

Factory installed ballast disconnect allows the ballast to be disconnected from and reconnected to incoming power under load without turning the entire circuit off.

Finish

Powder-coated,baked enamel, white or aluminum, as specified.

Mounting

Each module includes two wall-mountingbrackets. Bracket hole pattern accommodates junction box (single gang box rotated 90 degrees) or other appropriate mounting method using customer supplied fasteners.

Ordering Instructions

Individual Fixtures:

1.Order one MODULE.

2.Order one END SET.

Continuous Rows:

1.Order the appropriate number of MODULES for the complete run.

2.Order one END SET.

Finish

Powder coated White or Aluminum baked enamel. Custom colors are available, consult factory.

Labels

UL , cUL and I.B.E.W.

Job Information

Type:

Job Name:

Cat. No.:

Lamp(s):

Notes:

"JSQPSU 3PBE 'BMM 3JWFS ." t t 'BY

We reserve the right to change details of design, materials and finish.

XXX MJHIUPMJFS DPN ½ 1IJMJQT (SPVQ t E0808

Lighting Systems F7000-28

1BHF PG

' 4FSJFT -JHIU5-FOT8BMM .PVOU

Performance

CANDLEPOWER CURVE

180

017

016

 

 

015

 

 

 

 

 

 

 

 

140

 

 

 

130

 

 

 

120

 

 

 

110

 

 

 

100

 

 

 

90

275

 

 

80

550

 

 

70

 

 

60

 

 

 

825

 

 

50

 

 

 

40

1100

 

20

30

0

10

 

 

 

REPORT NO.: ITL54696.IES

LAMPS: 1-F54T5

LUMENS: 5000 each

EFFICIENCY: 81.6%

CAT. NO.: FW7751WH214

 

 

CANDLEPOWER

 

 

ZONE

0

22

45

67

90

DEG.

 

CANDELAS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

0

 

510

510

510

510

510

5

 

519

519

520

516

510

15

 

523

523

519

508

492

25

 

508

505

497

479

455

35

 

477

474

458

435

405

45

 

431

427

406

378

340

55

 

375

367

341

307

264

65

 

304

296

267

228

181

75

 

223

216

185

142

92

85

 

151

141

106

62

18

90

 

132

120

85

42

0

95

 

164

153

129

104

38

105

 

378

383

366

341

186

115

 

656

652

624

504

351

125

 

894

874

775

650

506

135

 

988

960

887

774

646

145

 

1048

1022

957

870

767

155

 

1056

1039

999

928

860

165

 

1033

1020

996

957

921

175

 

972

967

967

959

952

180

 

950

950

950

950

950

ROOM CAVITY RATIO

COEFFICIENTS OF UTILIZATION

% EFFECTIVE CEILING CAVITY REFLECTANCE

 

 

80%

 

 

 

70%

 

 

 

50%

 

 

 

 

 

WALL REFLECTANCE

 

 

 

 

50

30

10

 

50

30

10

 

50

30

10

0

83

83

83

 

76

76

76

 

60

60

60

1

72

70

66

 

65

63

60

 

52

50

48

2

63

58

54

 

57

53

49

 

45

43

40

3

55

49

45

 

50

45

41

 

40

36

33

4

48

43

37

 

44

38

34

 

35

31

28

5

43

37

32

 

39

33

30

 

31

27

24

6

39

32

27

 

35

30

26

 

28

24

20

7

35

28

24

 

31

26

22

 

26

21

18

8

31

26

21

 

29

23

20

 

23

19

16

9

29

23

19

 

26

20

17

 

21

17

14

10

26

20

16

 

24

19

15

 

20

15

13

20% FLOOR CAVITY REFLECTANCE

DISTRIBUTION

 

 

 

 

Zone

Lumens

% Lamp %Luminaire

 

0 - 90

1279

25.5

31.0

90

- 180

2790

56.1

69.0

0

- 180

4069

81.6

100.0

Fixture Lengths & Mounting Reflected (Plan View)

 

 

 

1'-4"

 

 

 

(40.64cm)

2'-8"

 

2'-8"

2'-8"

(81.28cm)

 

(81.28cm)

(81.28cm)

4'-3"(129.54cm)

 

8'-3"(251.46cm)

 

 

 

16" (40.64cm)

1'-4"

1'-4"

 

3/4"

(40.64cm)

(40.64cm)

2'-8"

(1.91cm)

2'-8"

2'-8"

 

(81.28cm)

(81.28cm)

(81.28cm)

 

12'-3"(373.38cm)

6" (15.24cm)

1'-4"

 

1'-4"

1'-4"

 

JOINING DETAIL

(40.64cm)

 

(40.64cm)

(40.64cm)

 

2'-8"

2'-8"

2'-8"

2'-8"

 

GAP BETWEEN FIXTURES

(81.28cm)

(81.28cm)

(81.28cm)

(81.28cm)

 

 

 

16'-3"(495.30cm)

 

 

 

1'-4"

 

1'-4"

1'-4"

1'-4"

1-1/2"(2.31cm)

(40.64cm)

2'-8"

(40.64cm)

(40.64cm)

(40.64cm)

2'-8"

2'-8"

2'-8"

2'-8"

 

(81.28cm)

(81.28cm)

(81.28cm)

(81.28cm)

 

(81.28cm)

 

 

20'-3"(617.22cm)

 

3/8" (0.95cm)

 

 

 

 

 

 

 

 

 

 

END OF ROW DETAIL

Recommended mounting is a single gang outlet box rotated 90 degrees at the feed point. Remaining mounting points could be outlet boxes as well, or a couple

of holes per mounting point spaced 3-1/4”(8.26cm) at1-3/4”(4.45cm) above the bottom of fixture.

Mounting Accessories

Wall Mount End Set

FW7EWH = White

FW7EAL = Aluminum

Job Information

Type:

"JSQPSU 3PBE 'BMM 3JWFS ." t t 'BY

We reserve the right to change details of design, materials and finish.

XXX MJHIUPMJFS DPN ½ 1IJMJQT (SPVQ t E0808