Liebherr SBS 70I4, HRB 1120, HC 1001B, HF 861, HC 1070 User Manual

Design Guide 2014

Fully Integrated Models 24" and 48"

Welcome

Liebherr's engineering excellence in Germany provides the largest selection of freezers, refrigerators and wine refrigerators worldwide.

Liebherr appliances consistently specializes in the manufacturing of high quality freezers and refrigerators. With more than 300 basic models, we have the widest selection in the world. Liebherr appliances feature premium quality, numerous innovative product ideas and advanced design. Liebherr freezers and refrigerators are manufactured at three modern production plants:

Liebherr Marica in Bulgaria, Liebherr-Hausgeräte Ochsenhausen GmbH in Germany and the Liebherr-Hausgeräte Lienz GmbH in Austria.

We produce more than 2.2 million quality freezers, refrigerators and wine refrigerators each year, and these are sold all over the world. LiebherrHausgeräte Ochsenhausen GmbH in Germany makes over 900.000 appliances a year and employs 1.900 people. The Liebherr-Hausgeräte Lienz GmbH manufactures more than 500.000 freezers and refrigerators and employs 1.500 people.

The appliances for the North American market are produced in Austria and in Germany.

Liebherr is commited to the protection of the environment and recognizes it as a critical priority. To guarantee an optimum and consistent implementation, all ecological aspects were observed and integrated into the quality control of Liebherr in compliance with DIN EN ISO 9001.

Liebherr's Commitment to the Environment

The components of Liebherr products can be recycled when the necessary resources are applied. A concern for the environment and a desire to protect resources has lead to increased levels of recycling year after year. When Liebherr manufactures products, it is essential that the recyclable recovery rate of the materials we use constantly increases.

Recycling is a common goal among all manufacturers, municipalities and recycling companies to protect our environment. Protecting the environment and producing products which have a low impact on the environment, is one of Liebherr's core values. Whether you are replacing a unit or starting fresh, remember to dispose of your old appliance in an environmentally safe and friendly manner.

Introduction

LIEBHERR WARRANTY PLAN

FULL TWO YEAR WARRANTY - For two years from the date of original purchase, your Liebherr Warranty covers all parts and labor to repair or replace any part of the product which proves to be defective in materials or workmanship.

FULL FIVE YEAR WARRANTY - For five years from the date of original purchase, your Liebherr Warranty covers all parts and labor to repair or replace any components that prove to be defective in materials or workmanship in the sealed system. The "Sealed System" means only the compressor, condenser, evaporator, drier and all connecting tubing.

LIMITED 6TH THROUGH 12TH YEAR WARRANTY - From the 6th through 12th year from the date of original purchase, your Liebherr Warranty covers all parts that prove to be defective in materials or workmanship in the sealed system (parts only).

Customer Service

If your appliance is not working properly, or if the temperature display reads "F0" to "F5”, please call the numbers listed below.

Give the fault number displayed, together with the

Type Designation,

Service Number and

Appliance Number (Serial Number)

from the model plate, to ensure prompt, accurate servicing. The model plate is located inside the appliance.

Leave the appliance door closed until the customer service technician arrives to minimize any further cold loss.

For Service and Parts in the U.S.:

PlusOne Solutions, Inc.

3501 Quadrangle Blvd, Suite 120

Orlando, FL 32817

Phone:	[phone]
Fax:	[phone]
Toll Free:	1-866-LIEBHER or
	1-866-543-2437

[e-mail] www.liebherr-appliances.com

For Service and Parts in Canada:

Euro-Parts Canada

39822 Belgrave Road,

BELGRAVE, Ontario, N0G 1E0

Phone:	[phone]
Fax:	[phone]
Toll Free:	1-888-LIEBHER or
	1-888-543-2437

www.euro-parts.ca

Need help?

For design related inquiries not addressed in this Design Guide please email install. [e-mail]

Contents

General Remarks

Safety Warnings	I
Electrical Requirements & Safety	II
IceMaker (if equipped)	III
Area Requirements	IV
Safety Regulations	V

Fully Integrated Models 24" and 48" Models

HC 1070	1
Ventilation Requirements	3
Kitchen Cabinet Base Grille	4
Location Of The Electrical Outlet
Unit Dimensions	5
Kitchen Cabinet Doors	6
Definition of the Door Panel Heights	7
HC 1000B, HC 1001B	9
Ventilation Requirements	11
Kitchen Cabinet Base Grille	12
Location Of The Electrical Outlet
Unit Dimensions	13
Kitchen Cabinet Doors	14
Definition of the Door Panel Heights	15
HF 861 / HRB 1120, SBS 70I4	17
Ventilation Requirements	19
Kitchen Cabinet Base Grille	20
Location Of The Electrical Outlet
Unit Dimensions	21
Kitchen cabinet setup for the water filter	22
Kitchen Cabinet Doors	23
Definition of the Door Panel Heights	24

General Remarks

I. Safety Warnings

PLEASE READ AND FOLLOW THESE INSTRUCTIONS

This design guide contains Warning and Caution statements. This information is important for safe and efficient installation.

This design guide is not replacing the use and care manual which contains important information on how to use Liebherr appliances.

Always read and follow all Warning and Caution statements!

indicates a hazardous situation, which if not avoided, will result in death or serious injury.

indicates a hazardous situation, which if not avoided, could result in death or serious injury.

indicates a hazardous situation, which if not avoided, will result in minor or moderate injury.

NOTICE

indicates a hazardous situation, which if not avoided, could result in damage to property.

NOTE

indicates useful advice and tips.

Make sure incoming voltage is the same as the unit rating.

To reduce the risk of fire, electric shock, or personal injury, the installation work and electrical wiring must be done by a qualified electrician in accordance with all applicable codes and standards, including fire rated construction.

To the Installer

It is very important that the guidelines and instructions are followed in this design guide to ensure proper installation and operation of the unit. The Installation Guidelines section contains important information for making sure the installation is correct. Read and understand all the information and installation guidelines in this manual before the unit is installed.

It is also very important to know the Safety Information.

General Remarks

II. Electrical Requirements & Safety

A 115 Volt, 60 Hz, 15 Amp (20 Amp for side-by-side installation) fused electrical supply is required. Connect an undercounter wine cabinet to a 115 VAC, 10 amp

(15 Amp for side-by-side installations) circuit that is controlled by a circuit breaker or fuse.

We recommend using a dedicated circuit for these appliances to prevent electrical overload. Comply with the National Electrical Code as well as local codes and ordinances when installing the receptacle.

Do not ground to a gas pipe. Check with a qualified electrician if you are not sure the appliance is properly grounded. Do not have a fuse in the neutral or grounding circuit.

ELECTROCUTION HAZARD

Electrical Grounding Required. This appliance is equipped with a three-prong (grounding) polarized plug for your protection against possible shock hazards.

•DO NOT remove the round grounding prong from the plug.

•DO NOT use a two-prong grounding adapter.

•DO NOT use an extension cord to connect power to the unit.

•DO NOT use a power cord that is frayed or damged.

III. IceMaker (if equipped)

The icemaker is located in the freezer compartment. The appliance must be level for the icemaker to function properly.

If you have hard water, we recommend you install a water softener. Also, a filter must be installed if the water contains solids such as sand. All equipment and devices used to supply the water to the appliance must comply with the current regulations for your geographical area.

Safety Instructions and Warnings

•Do not attach the water source while the appliance is connected to an electrical outlet.

•The water quality must comply with the drinking water regulations for the geographical area where the appliance is located.

•The icemaker is designed exclusively to make ice cubes in quantities needed by a household and may only be operated with water appropriate for this purpose.

•All repairs and work on the icemaker may only be done by customer service personnel or other trained personnel.

Appliances with water connection:

•The water pressure must be between 21.8-87.0 psi (1.5-6 bar). Use a 1/4" OD copper line (not supplied) to connect the water supply to the solenoid valve.

•A shut-off valve, must be installed between the hose line and the main water supply so that the water supply can be stopped if necessary. Do not install the shut-off valve behind the refrigeration unit.

•The connection to the water supply may only be made by a trained and licensed plumber.

•The manufacturer cannot accept liability for damage caused by equipment or water lines between the solenoid valve and the water supply.

Appliances with water tank:

•Fill the water tank with cold potable water only. Never use fluids containing sugar such as soft drinks, fruitjuices etc..

•Through the use of filtered, decarbonized water, drinking water with the best possible flavor is achieved, and this can be used for problem-free production of ice cubes. This water quality can be achieved using

a table water filter of the kind available in trade retail outlets.

General Remarks

IV. Area Requirements

V. Safety Regulations

Verify the following:

•Floors can support refrigerator’s weight plus approximately 1200 pounds (544 kg) of food weight. Not

all Liebherr products are designed for 1200 pounds (544 kg) of food. Some units are smaller and total weights may vary.

•Finished kitchen floor height is level. Refrigerator must be shimmed to the floor level, or levelled, to make sure, air vents are not obstructed.

•Remove anything attached to the rear or side walls that can obstruct refrigerator opening.

•Cutout dimensions are accurate.

•Electrical outlet is in correct location.

Do not install this unit next to any other refrigerator or freezer except another Liebherr model. Liebherr models are designed to allow side by side installation. They are equipped with a heating system to eliminate condensation when units are installed side by side. Installing this unit next to any other refrigerator or freezer can cause condensation or cause damage to the Liebherr unit.

NOTICE

To protect the refrigerator from possible damage, allow the appliance to stand 1/2 to 1 hour in place before turning the electricity on. This allows the refrigerant and system lubrication to reach equilibrium.

Blocking For Safety

The anti-tip brackets must be installed to prevent the unit from tipping after it is installed.

The appliance complies with UL250 and CAN/CSA-C 22,2 No. 63-93 (HF 851, HRB 1110) and respectively CAN/CSA-C22.2 No. 60335-1-11, 60335-2-24-06 and UL 60335-1, UL 60335-2-24 (HC 1070, HC 1000B, HC 1001B, HRB 1120) and is designed to cool, freeze, store food as well as make ice (if equipped). It is designed as a household appliance. If used commercially, the relevant regulations on commercial use must be observed.

The appliance is set to operate within specific ambient temperature limits according to its climate rating. These temperature limits should not be exceeded. The correct climate rating for your appliance is indicated on the model plate.

This is explained as follows:

Climate	Set for Ambient Temperatures of
Rating
SN	50°F to 90°F	(10°C to 32°C)
N	61°F to 90°F	(16°C to 32°C)
ST	61°F to 101°F (16°C to 38°C)
T	61°F to 110°F (16°C to 43°C)
SN-ST	50°F to 101°F (10°C to 38°C)
SN-T	50°F to 110°F (10°C to 43°C)

- The refrigerant circuit has been tested for leaks.

Fully Integrated

HC 1070, HC 1000B, HC 1001B, HF 861/HRB 1120 - SBS 70I4

24" Model: HC 1070

Integrated units are the most stylish option available - they're totally out of sight, fully concealed behind a cabinet door. Installed in a tall kitchen cupboard, the refrigerator door simply opens in unison with the cupboard door.

HC 1070

Energy Star:	qualified
Energy consumption p. a.:	475* kWh
	respectively 407** kWh
Energy Supply:	115V/60Hz
Total capacity:	9,32 cu ft (264 L)
Refrigerator:	6,92 cu ft (196 L)
Freezer:	2,4 cu ft (68 L)
Climate Rating:	SN-T
Door hinges:	right / reversable

• Automatic refrigerator and freezer compartment defrosting

• LED light column at both sides

• HC 1070 with soft closing system

• IceMaker with water tank

• Height-adjustable feet at front and levelling rails

*Measurement determined according to Appendix A to Subpart B of 10 CFR Part 430

**Measurement determined according to Appendix A1 to Subpart B of 10 CRF Part 430

1

Fully Integrated

HC 1070, HC 1000B, HC 1001B, HF 861/HRB 1120 - SBS 70I4

2