LG LRE3023ST, LRE3025ST, LRE3025SB, LRE3023SW, LRE3023SB User Manual

AÑOL ESP ENGLISH

INSTALLATION MANUAL

ELECTRIC RANGE

Please read these instructions thoroughly before installing and operating the range.

LRE3025ST LRE3023ST

LRE3025SB LRE3023SB

LRE3025SW LRE3023SW

Printed on 100% Recycled Paper

www.lg.com

2 TABLE OF CONTENTS

TABLE OF CONTENTS

3 SAFETY

3 Before You Begin

3 Important Safety Instructions

5Prepare to Install the Range

6PREPARE TO INSTALL RANGE

6Installation Drawings

7ELECTRICAL CONNECTIONS

7 Electrical Connection Requirements

7 Connect Range Cord

8 3-Wire Connection With a Power Supply Cord 9 4-Wire Connection With a Power Supply Cord 9 3-Wire Connection: Conduit

1 0 4-Wire Connection: Conduit

11 INSTALL THE RANGE

1 1 Anti-Tip Device Installation

1 1 Final Installation

SAFETY 3

BEFORE YOU BEGIN

Remove all tape and packing materials before using the range.

Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials.

You can download the installation and owner’s manual at: http://www.lg.com.

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all instructions before using your oven to prevent the risk of re, electric shock, personal injury, or damage when using the range. This guide does not cover all possible conditions that may occur. For further assistance contact your service agent or manufacturer.

This is the safety alert symbol. This symbol alerts you to potential hazards that can cause personal injury to you and others. All safety messages will follow the safety alert symbol with either the word “WARNING” or “CAUTION.”

WARNING

This symbol will alert you to hazards or unsafe practices which could cause serious bodily harm or death.

CAUTION

This symbol will alert you to hazards or unsafe practices which could cause bodily injury or property damage.

WARNING

•The information in this manual should be followed exactly.

-

•Donotstep or sit on the oven door. Install the Anti-Tip Brackets supplied with the range.

-The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.

-If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip device is properly reengaged when the range is pushed back against the wall.

-Install the Anti-Tip Brackets.

-A child or adult can be killed when the range is tipped.

-

-Anti-Tips will fasten the range by holding the range’s 2 legs of the rear side and the Anti-Tip Bracket Template lets you know proper locations of Anti-Tip Brackets easily.

-2) Engage the range to the Anti-Tip Brackets by putting the range’s 2 legs into each Anti-Tip Bracket.

-3) Re-engage the Anti-Tip Brackets if you can move the range except for range’s front direction.

-4) See installation instructions for details (refer to the page 11).

-Failure to do so can result in death or serious burns to children or adults.

•You should use two or more people to move and install range. (Excessive Weight Hazard)

-Failure to do so can result in back or other injury.

•You never pull or push any handles of door to move and install range.

-Failure to do so can result in serious damage to the door of the range.

•New branch-circuit installations (1996 NEC) for mobile homes, recreational vehicles, and installations where local codes do not allow grounding through the neutral wire require a 4-conductor UL listed range cord or 4 wire conduit connection.

ENGLISH

4 SAFETY

WARNING

•Power supply cord and plug should not be modi ed. If it will not t the outlet, have a proper outlet

•Using an extension cord to connect the power is prohibited. The way to connect the power cord and plug directly is strongly recommended.

•Electrical ground is required on this appliance.

•You should make sure that the power cord is not pinched by the range or heavy objects.

-Failure to do so can result in serious burns or electrical shock.

•You never remove the protection cover covering the rear of oven.

-Failure to do so can result in serious damage to power cord. The damage causes serious burns and electric shock.

•The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block. The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block.

-Failure to do so can result in electrical shock, severe personal injury or death.

•Only a 4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use with ranges with closed-loop connectors or open-end spade lugs with upturned ends shall be used. The middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the middle post of the main terminal block. The other two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block. The 4th ground wire must be connected to the frame of the range with the ground screw.

-Failure to do so can result in electrical shock, severe personal injury or death.

CAUTION

•You should put on gloves during the installation procedure.

-Failure to do so can result in bodily injury.

•You should make sure that the wall covering, countertop and cabinets around the range can withstand the heat (up to 194°F) generated by the range.

-Discoloration, delamination or melting may occur.

-This range has been designed to comply with the maximum allowable wood cabinet temperatures of 194°F.

•Cabinet storage space located above the surface units should be avoided.

•You should install a range hood that projects horizontally a minimum of 5 inches beyond the bottom of the cabinets. If cabinet Storage is to be provided.

-

•You should not install the range in the humid place. Splashing the range with water or any electrolyte can result in electrical shock.

-Failure to do so can result in serious burns.