HEARTH PRODUCTS KITS AND ACCESSORIES
750,216M
REV. N/C 03/2006
BLOWER KIT LBLK-100
INSTALLATION INSTRUCTIONS FOR BLOWER KIT
LBLK-100 (CATALOG NO. H4678) FOR USE WITH ELDV SERIES FIREPLACES
GENERAL INFORMATION
This blower kit may be used with ELDV series fireplaces. The LBLK100 blower kit is used with a field supplied ON/OFF power switch. The blower is installed beneath the firebox. Room air is drawn in through the bottom area of the fireplace, heated as it passes across the firebox, and discharged through the upper open area at the top of the fireplace. The LBLK-100 blower kit contains one blower, one power cord and these instructions.
INSTALLATION INSTRUCTIONS
Step 1. Turn off the fireplace and allow it to cool before proceeding.
Step 2. If the appliance is connected to 120 volt power, disconnect the power.
Step 3. Shut off the gas supply to the fireplace.
Step 4. Remove the bottom panel of the fireplace by pulling it forward. (see Figure 1 ).
Step 5. Remove the door assembly by opening the two latches (located under the door assembly) securing the glass door (see Figure 1 ).
Logs |
Door Asembly |
Step 6. Remove the logs from the fireplace (see Figure 1 ). Handle logs carefully to prevent breakage.
Step 7. Remove the grate asembly, burner baffle, burner asembly (Figure 2 ) and the blower cover panel (Figure 3 ).
Step 8. Connect the provided power cord to the terminals on the blower.
Blower Cover Panel |
Burner Assembly |
Grate Assembly |
Burner Baffle |
Figure 2
Blower Cover Panel
|
Bottom Panel |
Figure 1 |
Figure 3 |
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. |
1 |
Step 9. - Installing The LBLK-100 Blower
9A. First, tilt the left side of the blower into the cutout (see Figure 4 ).
Left Side Of Blower Assembly Tilted Into Access Cutout
Blower Access Cutout
Figure 4
Step 9B. Next, rest the blower on the cabinet bottom (see Figure 5 ).
Blower Access Cutout
LBLK-100 Blower Resting On Cabinet Bottom
Figure 5
Step 9C. Now gently slide the blower assembly towards the back of the fireplace (see Figure 6 ).
Step 9D. Rotate the blower assembly so the base rests on the cabinet bottom (see Figure 7 ).
Cabinet Bottom
Figure 6
Cabinet Bottom |
Blower Assembly Base |
Figure 7 |
|
|
|
Step 9E. Place the blower assembly in its final position at the back of the cabinet bottom, resting on the blower mounting tabs (see Figure 8 ). Bend the mounting tabs over the blower base to secure.
Blower Assembly
Blower Mounting Tab |
Blower Base |
Figure 8
2 |
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. |