Lennox ADK35CMPB, ADK35CPB, ADK40CPB, ADK40CBS, ADK22CMBS, ADK45CBS, ADK33CBS, ADK45CPB, ADK35CBS, ADK24CPB, ADK35CMBS, ADK24CBS, ADK33CPB, ADK35CBS User Manual

183.09 Kb
Loading...

 

LENNOX HEARTH PRODUCTS

 

KITS AND ACCESSORIES

 

 

P/N 750,021M

ARCH DOOR KITS WITH BRASS OR

REV. E 03/2008

BRUSHED STAINLESS STEEL TRIM

INSTALLATION INSTRUCTIONS FOR ARCH DOOR KITS WITH BRASS OR BRUSHED STAINLESS STEEL TRIM FOR USE WITH MERIT™, MERIT PLUS™, OR ElITE® Series gas fireplaces

KIT CONTENTS:

TOOLS REQUIRED:

 

 

1 ea. Arched Door

None

1 ea. Instruction Sheet

 

 

 

GENERAL INFORMATION

These arch door kits may be used with gas fireplace models listed in

Tables 1 & 2.

CAUTION

INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!

INSTALLATION INSTRUCTIONS

Part A: Elite Series Fireplaces

Step 1.Slightly lift and pull the existing top radiant panel/hood assembly away from the fireplace, or pull hood and slightly lift and pull the existing louver assembly away from the fireplace.

Step 2. Lift and pull the existing top and bottom bustle away from the fireplace.

Step 3.Open the bottom compartment door (either a radiant panel or louver assembly) by pushing in simultaneously the left and right top corners of the door (the door is hinged at the bottom).

Step 4.Remove the bottom compartment door by sliding the hinge pin, located at the door’s left side, to the right until it disengages from the left corner post hole. Pull the door diagonally to the left, away from the fireplace.

Step 5.Remove the modesty panel as follows: lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or disconnected.

Arched Door

Glass

Frame

Figure 1

Corner TabsAt

The Four Corners

Step 6.Open the glass door latche(s) located underneath the firebox.

Step 7.Remove the door from the fireplace by swinging the bottom of the door outward and lifting it up and away.

Step 8.Center the arch door over the glass frame as shown in Figure 1. Press the arch door onto the glass frame and bend the four corner tabs into the frame’s U-channel as shown in Figure 2.

CAT. NO.

MODEL

WHERE USED

 

 

 

81L34

ADK35CPB

EDV3530, ED3530

 

 

 

81L35

ADK40CPB

EDV4035, ED4035-2, LMDV-4035,

 

 

SSDV-4035, MPD4035, EDVST, EDST-2,

 

 

EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,

 

 

EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR,

 

 

EBCR-2, EBVCL, EBCL-2

 

 

 

81L36

ADK45CPB

EDV4540, ED4540-2, MPD4540

 

 

 

81L37

ADK24CPB

EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,

 

 

EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2,

 

 

EBVCL, EBCL-2

 

 

 

98L05

ADK33CPB

MDR3328, MDT3328, MPDT3328,

 

 

MPDR3328, LMDVR-3328

 

 

 

26M43

ADK35CMPB

MPD3530, MPD35ST, MPD35PF, MPB35ST,

 

 

LMDV-3530, ssDV-3530

 

 

 

H7026

ADK22CMPB

MPD35PF

 

 

 

Table 1 - Arch Door Kit with Brass Trim

 

 

 

CAT. NO.

MODEL

WHERE USED

98L68

ADK35CBS

EDV3530, ED3530

 

 

 

98L69

ADK40CBS

EDV4035, ED4035-2, LMDV-4035,

 

 

SSDV-4035, MPD4035, EDVST, EDST-2,

 

 

EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,

 

 

EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR,

 

 

EBCR-2, EBVCL, EBCL-2

 

 

 

98L70

ADK45CBS

EDV4540, ED4540-2, MPD4540

 

 

 

98L71

ADK24CBS

EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,

 

 

EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2,

 

 

EBVCL, EBCL-2

 

 

 

98L62

ADK33CBS

MDR3328, MDT3328, MPDT3328,

 

 

MPDR3328, LMDVT-3328, LMDVR-3328

 

 

 

26M44

ADK35CMBS

MPD3530, MPD35ST, MPD35PF, MPB35ST,

 

 

LMDV-3530, ssDV-3530

 

 

 

H7027

ADK22CMBS

MPD35PF

 

 

 

Table 2 - Arch Door Kit with Brushed Stainless Steel Trim

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

+ 1 hidden pages