Lava Electronics RVHD-2015 Installation Instructions Manual

AM:520-1719KHz FM:47-230MHz
UHF: 470-862MHz
Gain: 30dB

Tech Support: 909-235-6611

LAVA Electronics Inc. E-mail:[e-mail]

www.lavasat.com

RVHD-2015

OM NI PR O se ri es

Power Supply: DC 12V==50mA

Step 1: Decide locaon of power supply before mounng your antenna. Antenna
and power supply locaon will determine where and how you run the cables. DO
NOT install the antenna before you read this instrucon.
Step 2: Drill a hole thru the roof to run cable from the antenna into your vehicle. Or
if your vehicle have a cable hole already, run the cable thru hole to the antenna.
Step 3: Using 4 self-tapping screw to securely fasten antenna mount to the roof. Do
not over ghten the mounng bolts, damage to the mounng stand or roof may

occur.

Step 4: Use cable tool to drive the cable into the mounng bracket on the
underside of the antenna, aligning the end of the connector with the F connector
on the antenna. Turn cable tool unl the connector is ght and remove the cable

tool.

Step 5: Aer cable connector is made, slide antenna onto the mount. Gently pull
back any extra cable inside vehicle.
Step 6: Fasten antenna to mount using self-tapping screw and hex nuts. Tighten
firmly to prevent antenna from turning on mount or mast.
Step 7: Connect power supply MP-002 kits (not included in this package)

OM NI PR O se ri es

RVHD-2015

Tech Support: 909-235-6611

LAVA Electronics Inc. E-mail:[e-mail]

www.lavasat.com