Land Pride ZT60, ZXT60, 357-131A, Z44, ZT72 User Manual 2

...
0 (0)

Mulching Baffle Kit

Land Pride Zero Turn Mower Manual No. 357-129M

Z44 & Z52 LP Razor; ZXT54 & ZXT60 Pro and ZT60 & ZT72 LP Accu-Z

Before You Start

When you see this symbol, the subsequent

!instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it!

IMPORTANT: Before you begin, read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information.

Your Land Pride Mulching Baffle Kit is exclusively designed for your Land Pride Zero Turn mower. Please read these installation instructions and the vehicle Operator’s Manual thoroughly before beginning. Especially read information relating to safety concerns. Also included in the Operator’s Manual is important information on operation, adjustment, troubleshooting, and maintenance for this attachment (some manual sections do not apply to all accessories).

A separate Parts Manual for replacement parts can be purchased from your dealer or available free of charge at www.landpride.com. Have model and serial numbers handy when placing an order.

Manual Part Numbers:

Operator’s Manual (Z44 & Z52) . . . . . . . 357-044M

Parts Manual (Z44 & Z52) . . . . . . . . . . . 357-044P

Operator’s Manual (ZXT54 & ZXT60) . . 357-271M

Parts Manual (ZXT54 & ZXT60) . . . . . . 357-271P

Operator’s Manual (ZT60& ZT72) . . . . . 357-103M

Parts Manual (ZT60 & ZT72) . . . . . . . . . 357-103P

General Information

These assembly instructions apply to the following Mulching Baffle Kits listed below:

357-083A Z44 MULCH BAFFLE KIT . . . . . . . . . . . . . . Pg. 1 357-084A Z52 MULCH BAFFLE KIT . . . . . . . . . . . . . . Pg. 1 357-278A ZXT54 MULCH BAFFLE KIT . . . . . . . . . . . . Pg. 5 357-135A ZXT60 MULCH BAFFLE KIT . . . . . . . . . . . . Pg. 4 357-130A ZT60 MULCH BAFFLE KIT (S/N 505070-) . Pg. 3 357-135A ZT60 MULCH BAFFLE KIT (S/N 505071+) . Pg. 4 357-131A ZT72 MULCH BAFFLE KIT (S/N 510757-) . Pg. 3 357-136A ZT72 MULCH BAFFLE KIT (S/N 510758+) . Pg. 4

Tools required

Basic hand tools

Definitions

Right-hand and left-hand as used in this manual is determined by facing the direction the machine will operate while in use unless otherwise stated.

Z44 & Z52 Assembly Instructions

For Kit No’s. 357-083A & 357-084A

A detailed listing of parts for each accessory kit is provided on page 2. Use the list that is for your Baffle Kit as a checklist to inventory parts received. Please contact your local Land Pride dealer for any missing hardware.

1.Park mower on a flat surface, place control levers in park brake position, shut off engine and remove spark plug wire from spark plug.

2.Remove deck cover and raise front end of mower enough to allow room to install baffles.

NOTE: Be sure to properly block up mower so it can not move after it is raised.

NOTE: (Z52 S/N 472620 to 504958) A mounting hole must be relocated for model Z52 mower

(Kit No. 357-084A). See page 2 for instructions on drilling the “Z52 Relocated Baffle Hole”.

Refer to Figure 1:

3.Locate pilot holes which have knock-outs in the deck top. Punch-out these holes. Make sure knock-outs are completely removed.

4.Mount baffles (#1 & #2) to the deck with 3/8"-16 x 3/4" round head square neck bolt (#3), flat washers (#5) and 3/8" hex nuts (#4). Tighten nuts to 20 ft-lbs.

5.Lower unit to ground and reconnect spark plug wire.

26616

Z44 & Z52 Mulching Baffle Kit]

Figure 1

© Copyright 2006

Pr inted

6/23/08

1

Land Pride ZT60, ZXT60, 357-131A, Z44, ZT72 User Manual 2

Land Pride

Z44 & Z52 Assembly Instructions

Z52 Relocated Baffle Hole

Refer to Figure 2:

If the serial number of your model Z52 mower is between 472620 and 504958 inclusive, then your Mulching Baffle Kit No. 357-084A will require relocating a knock-out as shown in Figure 2.

6.Measure 1 3/16" from face of stiffener plate towards the center of the deck and 10 21/32" from second face

of stiffener plate towards the front of the deck as shown.

7.Center punch this location and drill one 13/32" diameter hole.

NOTE: Do not use the old pilot hole location when installing baffle.

1 3/16"

10 21/32"

 

 

 

DRILL 13/32" DIA. HOLE

Z52 LAND PRIDE DECK

 

 

S/N 472620 to 504958

 

 

 

 

VIEWING DECK FROM THE TOP

 

 

 

 

Old Knock-Out Location

 

 

 

 

 

 

Z52 Baffle Mulch Kit Hole Relocation

Figure 2

357-083A Z44 MULCHING BAFFLE KIT (BLADES NOT INCLUDED)

Your kit includes:

Item

Qty.

Part No.

Part Description

1

1

357-087H

ZR44" MULCH BAFFLE 12.6" CHORD LENGTHG

2

2

357-085H

ZR44" MULCH COMMON BAFFLE 13.3" CHORD LG

3

1

802-149C

RHSNB 3/8-16X3/4 GR5

4

4

803-014C

NUT HEX 3/8-16 PLT

5

4

804-012C

WASHER FLAT 3/8 SAE PLT

 

1

357-129M

MULCHING BAFFLE KIT MANUAL Z MOWER

357-084A Z52 MULCHING BAFFLE KIT (BLADES NOT INCLUDED)

Your kit includes:

Item

Qty.

Part No.

Part Description

1

1

357-088H

ZR52" MULCH BAFFLE 13.1" CHORD LENGTHG

2

2

357-086H

ZR52" MULCH COMMON BAFFLE 14.3" CHORD LG

3

1

802-149C

RHSNB 3/8-16X3/4 GR5

4

4

803-014C

NUT HEX 3/8-16 PLT

5

4

804-012C

WASHER FLAT 3/8 SAE PLT

 

1

357-129M

MULCHING BAFFLE KIT MANUAL Z MOWER

Mulching Blade Ordering

Information

Mower Model

Requires 3 Blades

Z44 890-934C 15.5" Mulch Blade

Z52 839-270C 18" Mulch Blade

2

Manual No. 357-129M

■ 6/23/08

Loading...
+ 4 hidden pages