Kramer VS-88FO Installing and Removing the SFP-IN/OUT-40km

We welcome your questions, comments, and
regarding this product scan the QR

P/N:

2900- 300240

Rev:

1

Installing and Removing the

SFP-IN/OUT-40km Fiber Optic

Module

Thank you for purchasing the Kramer SFP-IN/OUT-40km Fiber Optic Module that is used
with Kramer’s VS-88FO 8x8 3G HD-SDI Fiber Optic Matrix Switcher.

To install an SFP module:

1. Make sure the bail (removal handle) is closed

in an upward position as shown in #1.

2. Insert the SFP module in an open slot and

push it inward until it clicks.

3. Remove the protective SFP cap from the end

of the SFP (#2).

To remove an SFP module:

1. Pull the bail downward to release the SFP

(#3).

2. Pull the SFP module out by the bail (#4).

3. If needed, replace the protective cap over the

fiber connectors.

Note: When transporting or storing an unconnected device, replace the SFP caps to protect against dust.

For the latest information on our products and a list of Kramer distributors, visit our Web

site where updates to this sheet may be found.

feedback. Web site:

E-mail:

[e-mail]

www.kramerelectronics.com

KRAMER ELECTRONICS LTD.

P/N: 2900-300240 REV 1

For more detailed information

code: