Korea Data Systems Co KL1920BM Users manual

Test Report No.: GETEC-E3-04-002

FCC Class B Certification

APPENDIX H

: USER’S MANUAL

EUT Type: 19” LCD Monitor

FCC ID : EVOKL1920BM

LCD Monitor

User’s Guide

Models
KL1920BM

TABLE OF CONTENTS

INTRODUCTION

FCC Compliance Statement ………………………………… ⅰ
Safety Instructions ……………………………………………. ⅲ
General Information ………………………………………….. 1
Equipment Check list ………………………………………… 2
Monitor Features ……………………………………………… 3

GETTING STARTED

Installation ……………………………………………………… 4
Control Buttons ……………………………………………….. 6
On-Screen Display …………………………………………… 7

ON-SCREEN CONTROLS

Menu Descriptions …………………………………………… 8

REFERENCE

Power Management …………………………………………. 11
Timing Guide …………………………………………………. 12
Pin Assignment ………………………………………………. 13
Specifications ………………………………………………… 14
Troubleshooting ……………………………………………… 15

FCC COMPLIANCE STATEMENT

Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part15 of FCC Rules. These llimits
Are designed to provide reasonable protection against radio frequency
Interference in a residential installation. This equipment generates, uses
And can radiate radio frequency energy. If not installed and used in
Accordance with the instructions, it may cause interference to radio
Communications. However,there is no guarantee that interference will
Not occur in a particular installation. If this equipment does cause
Interference to radio or television reception(this can be determined by
Turning this equipment off and on), the user is encouraged to try to
Correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to

which the receiver is connected.

INTRODUCTION

CAUTION TO THE USER:

The Federal Communications Commission warns that changes or
Modifications to the unit not expressly approved by the party responsible
For compliance could void the user’s authority to operate the equipment.
If necessary, the user should contact the dealer or an experienced
Radio/television technician for additional suggestions. The user may find
The Federal Communications Commission booklet, How to Identify and
Resolve Radio-TV Interference Problems, helpful. This booklet is
Available from the U.S.Government Printing Office, Washington, D.C.,
Stock No.004-000-00345-4.

NOTICE OF COMPLIANCE WITH CANADIAN
INTERFERENCE-CAUSING EQUIPMENT
REGULATIONS

ⅰ

SAFETY INSTRUCTIONS

■Handling

Due to its fragile glass panel, this monitor must be handled with
Caution and not be exposed to impact or shock.
Never touch the display area or rub it with a hard object or tool, as the
Panel is easily scratched.

■Cleaning

The display area is sensitive to scratching. Do not use ketone-type
Cleaners(i.e.acetone),ethyl alcohol, toluene, ethyl acid or methyl
Chloride to clean the panel. Doing so may result in permanent damage.

Water, IPA(Iso Prophyl Alcohol) and Hexane are safe cleaners.

INTRODUCTION

Do not allow oil or water to penetrate the display, this will cause
Staining and discoloration.
Avoid getting food particles and fingerprints on the display area at all
Times.

■Storage

Store the monitor in a dark place away from sunlight and ultraviolet
(UV)radiation, this may cause air bubbles to develop within the
glass panel.

Do not store the display in temperatures higher than 40℃/104℉ or
Humidity greater than 90%. Avoid condensation.

ⅲ

SAFETY INSTRUCTIONS

■Caution

1. Do not open any covers on the monitor. No user serviceable
parts are inside.

2. In an emergency, disconnect the AC power plug.

3. To avoid electrical shock, disconnect the power cord from the
monitor before connecting the signal cable to the computer.

4. Keep away from liquids and flame. Do not immerse this monitor
in water or any other liquid. Do not use this device in excessively
hot conditions.

INTRODUCTION

5. Handle the power cord with care. Do not bend the power cord
excessively or place heavy objects on it. Do not use a damaged
power cord, doing so can result in fire or electrical shock hazards.
When disconnecting the power cord, always grasp the plug, not
the cord.

6. The liquid crystals in the display panel contain several irritants. If
the panel is damaged or broken, do not allow the liquid to come
in contact with skin, eyes, or mouth. If you come in contact with
the liquid, flush the affected area with running water for at least
15minutes, then consult a doctor.

7. Handle this monitor with care when moving it. When lifting the
monitor, support it with one hand holding the stand, and one
hand holding the LCD screen.

8. Always disconnect the power cord when moving this monitor.

9. Do not lay this monitor in a horizontal position when operating.

ⅳ

GENE RAL INFORMAT ION

Your new LCD monitor incorporates the latest state-of the art color Liquid
Crystal Display(LCD) technology providing a wider viewing angle with
Higher contrast ratio.

Your new LCD monitor has many advantages : safe from electromagnetic
Wave, llights, sharps and slims. This makes the monitor extremely
Suitable in the environment of administration, transportation system
Research, etc.

Your new LCD monitor is designed for Analog, Digital inputs.
Your new LCD monitor does not emit any X-ray radiation and the magnetic

Emission greatly reduces the eyestrain. Moreover, our On Screen
Controls on the side of the panel provide flexibility with simple controls.
You can use these controls to adjust the display as you desire.

INTRODUCTION

Your new LCD monitor incorporates an active TFT module. It has a 1280
×1024 pixel resolution, high contrast, wide viewing angle and colors up
To 16.7M.

1