Kidde 3SF23-9HIR, 3SF23-9HIRE, 2SF23-9HIR, 2SF23-9HIRE, 3SF23-9HI User Manual

...
4 (1)
Kidde 3SF23-9HIR, 3SF23-9HIRE, 2SF23-9HIR, 2SF23-9HIRE, 3SF23-9HI User Manual

Smoke and Heat alarm

Owner’s Manual

230V Interconnectable Mains Operated Alarms For models:

1SF23/9HI, 1SF23/9HIR, 1SF23/9HIRE, 2SF23/9HI, 2SF23/9HIR, 2SF23/9HIRE, 3SF23/9HI, 3SF23/9HIR, 3SF23/9HIRE

Your home is protected with a KIDDE Fyrnetics alarm/s

Please read through our guide in full. It should be retained for future reference.

Cut out page 6 and pin up near your Consumer Unit/Fuse Box.

Kidde Fyrnetics recommends for maximum protection that both ionisation and optical (photo-electric) smoke alarms be installed. Ionisation technology is faster at detecting fast flaming fires that give off little smoke. Optical (photo-electric) technology is faster at responding to slow, smouldering smoky fires. Heat alarms are installed in environments where excessive steam, dust etc. make smoke alarms impractical e.g. kitchens/boiler rooms/lofts.

Electrical rating 230V AC, 50Hz 80mA max per alarm

(maximum 80mA for originating unit with 24 alarms interconnected).

*

Lic No: 7861

BS 5446: Pt. 1: 2002

*Kite mark is not applicable to 300 series models.

Kidde Safety Europe, Mathisen Way, Colnbrook, SL3 0HB, UK.

www.kiddefyrnetics.co.uk

© Kidde Fyrnetics 2001

INSTALLER LEAVE IN SAFE PLACE FOR HOUSEHOLDER

SAVE THIS MANUAL FOR FUTURE REFERENCE

Contents

Section

1.

Alarm Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.2

Section

2.

Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.2

Section

3.

Types of Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.2

Section

4.

How to Operate/Test the Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.3

Section

5.

Battery Checking/Changing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.4

Section

6.

Checking Battery Back-up on Rechargeable/Long Life Models . . .

.8

Section

7.

Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.8

Section

8.

What to do in an Emergency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.8

Section

9.

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.9

Section 10.

Useful Hints . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

.9

 

 

 

Section 11.

Good Safety Habits

(Cut off Section)

. . . . . . . . . . . . . . . . . . . . . . . . .

.6

 

 

What to do when the Alarm Sounds

 

 

 

 

Section 12.

(Cut off Section)

.6

Section 13.

Limitation of Smoke/Heat Alarms . . . . . . . . . . . . . . . . . . . . . . . . . . . .

10

Section 14.

Service and Guarantee . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

10

Read this manual thoroughly and follow its instructions regards regular maintenance. – it could save your life.

1

1. Alarm Range Interconnectable 230V Hard Wired Alarms

1SF23/9HIR: Mains ionisation alarm with sealed in rechargeable back-up cells

1SF23/9HI: Mains ionisation alarm with alkaline back-up cell

2SF23/9HIR: Mains optical alarm with sealed in rechargeable back-up cells

2SF23/9HI: Mains optical alarm with alkaline back-up cell

3SF23/9HIR: Mains heat alarm with sealed in rechargeable back-up cells

3SF23/9HI: Mains heat alarm with alkaline back-up cell

2. Important Information

This alarm is designed for installation by a qualified electrician, in accordance with the latest I.E.E. Regulations and in regard to relevant Building Regulations/BS Codes of Practice.

Hard wired smoke or heat alarms require a constant 230V AC supply.

Battery Back-up models additionally require a healthy battery too.

A healthy mains supply is indicated by a constant green L.E.D. (mains) indicator.

Test the alarm weekly by pressing (and holding) the test button. The alarm and all those interconnected to it will sound.

Vacuum your alarms regularly to reduce the likelihood of nuisance alarms, caused by dust contamination.

Never paint or expose alarm to water – this is a 230V alarm.

(If painting or building work is being carried out close to alarm, temporarily cover with a plastic bag, or the dust cover supplied.)

If the alarm chirps every 30-40 seconds, it indicates the battery needs replacing.

(If you are in rented property, advise your Landlord.)

Smoke and heat alarms will only function if properly selected, located, installed and maintained as per KIDDE Fyrnetics instruction manuals.

3. Types of Alarm

a. Power Supply

DC alarms

9V battery powered units, but will only function if battery is in good condition

– check regularly. (BS5839 Pt6: Grade F).

AC alarms

230V mains – for professional installation.

(Minimum required by UK Building Regulations in new homes.) Interconnectable to other Kidde Fyrnetic AC Alarms, so all will sound when one is triggered.

Will not function if mains power lost. (BS5839 Pt6: Grade E).

AC/DC alarms

230V mains – for professional installation. Interconnectable to other Kidde Fyrnetic AC Alarms, so all will sound when one is triggered. If mains power is lost, will operate via battery power if batteries are fresh/properly installed. Some models use replaceable 9V (PP3 type) batteries, others sealed-in rechargeable/Long Life batteries. (BS5839 Pt6: Grade D)

2

b. Alarm Types

Ionisation (Ion) alarms are the most common type and provide early detection, especially against fast flaming fires. Most suitable for dining and living room areas. Ion alarms contain 0.9 microcurie of Americium 241, a radioactive material. UK Home Office and BS5839 Pt6 recommend however, that optical alarms are also used especially in locations where steam or cooking fumes, from a nearby room could cause nuisance alarms.

No one type of alarm is considered suitable for all locations.

 

 

 

 

 

Clear Air

 

 

 

 

 

 

Smoke

-

 

 

 

 

 

 

-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

+

 

 

 

 

 

 

 

+

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Smoke

 

 

 

+ + -

 

 

 

 

 

 

 

Particles

+ -

Radio Active

Material

Optical (Photo-Electric) alarms are increasingly used and are less prone to nuisance alarms from cooking fumes. They are therefore the recommended type in BS5839 Pt6, for fitting near kitchen areas and on escape routes/circulation spaces.

Clear Air

Light

Lens

Photosensitive

Source

Cell

 

Smoke

Heat alarms are for use in areas where Ion or Optical smoke alarms would be unsuitable e.g. kitchens, boiler rooms, garages. However, they must always be used interconnected to smoke alarms – do not use in isolation. (They will typically go into alarm when the temperature reaches 57°C.) Suitable for new Building Regulations applicable 1/7/2000 regarding use in kitchens.

4. How to Operate/Test the Alarm

a. Operation and L.E.D. Status

When your alarm is correctly installed to the mains supply, the green L.E.D. light will be on. The red L.E.D. will blink every 30-40 seconds to indicate the sensor is operating correctly. If the alarm senses products of combustion, it’s 85dB horn will be activated. The red L.E.D. will flash rapidly on the alarm sensing smoke/heat.

(Other interconnected alarms will also sound to warn those in other parts of the property.) This will continue until the sensor chamber is clear.

In the case of a heat alarm, it will be triggered when the temperature reaches 57°C and return to it’s standby mode when the temperature drops to normal levels. On optical alarms if the red L.E.D. blinks every 30-40 seconds and the alarm chirps inbetween, it indicates failure of the sensing chamber.

Regularly check and ensure that the green L.E.D. is lit – if not, check the consumer unit/circuit breaker connection. As with previous point above, if in doubt, consult an electrician or your Landlord.

3

Loading...
+ 7 hidden pages