Owner’s Manual
Health Trainer 65T Treadmill
Customer Service
(888) 340-0482
Keys Fitness Products
4009 Distribution Drive
Suite 250
Garland, TX 75041
www.keysfitness.com
CAUTION! Read all precautions and instructions in this manual before using this equipment.
|
Model Name : HT65T.1/HT65T.1-CE |
|
|
Serial Number : |
|
415-00019 |
Write down for future reference |
|
|
|
|
02/06 Rev B |
Serial Number Decal Location |
|
|
Table of Contents
Important Safety Information |
3 |
Before You Start |
4 |
Assembly |
5-9 |
Moving Instructions |
10 |
Power Requirements |
11 |
Console Panel Functions |
12 |
Program Operation |
13-14 |
Program Profiles |
15 |
Monitoring Your Heart Rate |
16-17 |
Warm Up Exercises |
18 |
Changing to MPH or KM |
19 |
Calibration Sequence |
20 |
Belt Adjustment |
21 |
Maintenance Instructions |
22 |
Error Messages |
23 |
Troubleshooting |
24 |
Parts List |
25-26 |
Exploded View |
27-28 |
Warranty Information |
29 |
2
Important Safety Information
WARNING! Before using this treadmill or starting any exercise program, consult your physician. This is especially important for persons over the age of 35 and/or persons with pre-existing health problems. The manufacturer or distributor assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
WARNING! To reduce the risk of electrical shock, burns, fire, or other possible injuries to the user, it is important to review this manual and the following precautions before operation.
SAFETY PRECAUTIONS AND TIPS
1.It is the owner's responsibility to ensure that all users of this treadmill have read the Owner's Manual and are familiar with warnings and safety precautions.
2.This treadmill has a user maximum capacity of 275 pounds.
3.The treadmill should only be used on a level surface and is intended for indoor use only. The treadmill should not be placed in a garage, patio, or near water and should never be used while you are wet. Keys Fitness recommends a treadmill mat be placed under the treadmill to protect floor or carpet and for easier cleaning.
4.Follow safety information in regards to plugging in your treadmill. Keep the power cord away from the incline wheels and do not run the power cord underneath your treadmill. Do not operate the treadmill with a damaged or frayed power cord.
5.Wear comfortable, good-quality walking or running shoes and appropriate clothing. Do not use the treadmill with bare feet, sandals, socks or stockings.
6.Always straddle the belt and allow it to start moving before stepping onto the belt.
7.Hold on to handrail when adjusting speed, incline, or other controls.
8.Always examine your treadmill before using to ensure all parts are in working order.
9.Allow the belt to fully stop before dismounting.
10.Pets should never be allowed near or on the treadmill.
11.Do not leave children unsupervised near or on the treadmill.
12.Never operate the treadmill where oxygen is being administered, or where aerosol products are being used.
13.Never insert any object or body parts into any opening.
14.For safety and to prevent damage to your treadmill, no more than one person should use the treadmill at a time.
15.Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be performed by an authorized service representative, unless authorized and/or instructed by the manufacturer.
16.Failure to follow these instructions will void the treadmill warranty.
17.Never leave the treadmill unattended while it is running.
3
Before You Start
Thank you for purchasing the Health Trainer 65T Treadmill! This quality product you have chosen was designed to meet your needs for cardiovascular exercise. Before you start, please read the Owner's Manual and become familiar with the operation of your new treadmill.
Remember to take the time to perform the stretching exercises provided to avoid injury.
Do not stand on the walking belt while pressing the Power button or Start/Stop button.
Always adjust the speed of the treadmill in small increments as this treadmill is capable of high speeds.
If you are taking medication, consult your physician to see if the medication will affect your exercise heart rate.
If you have heart problems, you are not active, and/or are over the age of 35 years, do not use the pre-set treadmill programs or start an exercise program without first contacting and receiving approval from your physician.
To avoid the risk of electrical shock, always keep the console dry. Do not spill liquids on the console. Keys Fitness recommends a sealed water bottle for beverages consumed while using the treadmill.
Please review the following drawing below to familiarize yourself with the listed parts. This manual covers several treadmills, so the one pictured below may not be identical to your particular model.
CONSOLE
LATCH |
SAFETY SWITCH |
|
|
LEFT UPRIGHT |
RIGHT UPRIGHT |
|
|
MOTOR COVER |
|
RUNNING BELT
TRANSPORT WHEEL
4
Assembly
The Health Trainer 65T Treadmill will require assembly before operating. After opening the box, remove any packing material from the treadmill.
Do not throw away any packing materials until the unit is working properly.
Place the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.
Locate the hardware pack and identify the following parts required for assembly.
Parts List:
1. |
Owner’s Manual |
7. |
Left and Right Outside Handle Covers |
2. |
Base Assembly |
8. |
Left and Right Inside Handle Covers |
3. |
Console Assembly |
9. Allen Wrench |
|
4. |
Left and Right Upright |
10. Philip Screw M6x12 (Qty. 6) |
|
5. |
Safety Key (Reed Switch) |
11. Philip Screw ST4.2x13 (Qty. 8) |
|
6. |
Left and Right Fender |
12. Allen Bolt M8x15 (Qty. 8) |
|
|
|
13. Washer 9x22x2 mm (Qty. 8) |
2
3
|
4 |
4 |
|
|
|
5 |
|
|
|
|
|
|
|
|
7 |
|
6 |
9 |
8 |
|
|
6 |
|
|
|
1 |
7 |
|
|
|
|
|
|
|
8 |
10 |
11 |
12 |
13 |
|
5
Assembly
Assembly requires the included allen wrench.
Do not plug in the power cord until all assembly
steps are completed.
Step 1:
Place the left and right fenders through the tube of the left and right uprights as shown in Figure 1.
Step 2:
Slide the fenders up the upright assembly and pull the console harness through the hole in bottom of the left upright tube as shown in Figure 2.
Figure 1 |
UPRIGHT |
FENDER |
Figure 2 |
CONSOLE HARNESS |
6 |
Assembly
Step 3:
Connect the console harness from inside the left upright to the console harness from the base assembly as shown in Figure 3.
Next, attach left upright and right upright to base using allen bolts M8x15 (Qty. 8) and washer 9x22x2 mm (Qty. 8). Do not tighten bolts all the
way at this time.
Figure 3
ALLEN BOLT
CONSOLE HARNESS |
WASHER |
|
Step 4:
Attach the console assembly by connecting the console harness, incline harness, EKG harness, and speed harness as shown in Figure 4.
Next, attach the console assembly to the left and right uprights using phillip screw M6x12 (Qty. 4).
Figure 4 |
CONSOLE |
PHILLIP SCREW |
WIRE HARNESS |
UPRIGHTS |
7 |
Assembly
Step 5:
Attach left inside handle cover and left outside handle cover to left upright using philip screw ST4.2x13 (Qty. 3) as shown in Figure 5.
Repeat assembly step for right side handle covers.
Step 6:
Tighten all allen bolts (Qty. 8) installed in Step 3. Note: Move the fenders up to access the allen bolts.
Next, attach both left and right fenders to base using philip screw ST4.2x13 (Qty. 2) and philip screw M6x12 (Qty. 2).
Move the treadmill to its final location (see section titled “Moving Instructions”). Adjust the leveler feet so that treadmill does not wobble while in use.
Figure 5 |
|
PHILLIP SCREW |
|
Figure 6 |
|
PHILLIP SCREW |
|
FENDER |
LEVELER |
|
FOOT |
8 |
|
Assembly |
Congratulations!! |
You have completed the assembly of your new Health Trainer 65T Treadmill.
9