4500T
Owner’s Manual
Keys 4500T Treadmill
Customer Service
(888) 340-0482
Keys Fitness Products
4009 Distribution Drive
Suite 250
Garland, TX 75041
www.keysfitness.com
Model Name : 4500T/4500T-CE
Serial Number :
Write down for future reference
Serial Number Decal Location
415-00016
09/05 Rev B
CAUTION! Read all precautions and
instructions in this manual before
using this equipment.
Table of Contents
2
Important Safety Information 3
Before You Start 4
Assembly 5-9
Moving Instructions 10
Power Requirements 11
Console Panel Functions 12
Program Operation 13-14
Program Profiles 15
Monitoring Your Heart Rate 16-17
Warm Up Exercises 18
Changing to MPH or KM 19
Calibration Sequence 20
Belt Adjustment 21
Maintenance Instructions 22
Error Messages 23
Troubleshooting 24
Parts List 25-26
Exploded View 27-28
Warranty Information 29
Important Safety Information
3
WARNING! Before using this treadmill or starting any exercise program, consult your physician. This is espe-
cially important for persons over the age of 35 and/or persons with pre-existing health problems. The man-
ufacturer or distributor assumes no responsibility for personal injury or property damage sustained by or
through the use of this product.
WARNING! To reduce the risk of electrical shock, burns, fire, or other possible injuries to the user, it is impor-
tant to review this manual and the following precautions before operation.
SAFETY PRECAUTIONS AND TIPS
1. It is the owner's responsibility to ensure that all users of this treadmill have read the Owner's Manual and
are familiar with warnings and safety precautions.
2. This treadmill has a user maximum capacity of 300 pounds.
3. The treadmill should only be used on a level surface and is intended for indoor use only. The treadmill
should not be placed in a garage, patio, or near water and should never be used while you are wet. Keys
Fitness recommends a treadmill mat be placed under the treadmill to protect floor or carpet and for easier
cleaning.
4. Follow safety information in regards to plugging in your treadmill. Keep the power cord away from the
incline wheels and do not run the power cord underneath your treadmill. Do not operate the treadmill with a
damaged or frayed power cord.
5. Wear comfortable, good-quality walking or running shoes and appropriate clothing. Do not use the treadmill
with bare feet, sandals, socks or stockings.
6. Always straddle the belt and allow it to start moving before stepping onto the belt.
7. Hold on to handrail when adjusting speed, incline, or other controls.
8. Always examine your treadmill before using to ensure all parts are in working order.
9. Allow the belt to fully stop before dismounting.
10. Pets should never be allowed near or on the treadmill.
11. Do not leave children unsupervised near or on the treadmill.
12. Never operate the treadmill where oxygen is being administered, or where aerosol products are being used.
13. Never insert any object or body parts into any opening.
14. For safety and to prevent damage to your treadmill, no more than one person should use the treadmill at a
time.
15. Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be
performed by an authorized service representative, unless authorized and/or instructed by the manufacturer.
16. Failure to follow these instructions will void the treadmill warranty.
17. Never leave the treadmill unattended while it is running.
Before You Start
4
Thank you for purchasing the Keys4500T Treadmill! This quality product you have chosen was designed to
meet your needs for cardiovascular exercise. Before you start, please read the Owner's Manual and become
familiar with the operation of your new treadmill.
Remember to take the time to perform the stretching exercises provided to avoid injury.
Do not stand on the walking belt while pressing the Power button or Start/Stop button.
Always adjust the speed of the treadmill in small increments as this treadmill is capable of high speeds.
If you are taking medication, consult your physician to see if the medication will affect your exercise heart
rate.
If you have heart problems, you are not active, and/or are over the age of 35 years, do not use the pre-set
treadmill programs or start an exercise program without first contacting and receiving approval from your
physician.
To avoid the risk of electrical shock, always keep the console dry. Do not spill liquids on the console. Keys
Fitness recommends a sealed water bottle for beverages consumed while using the treadmill.
Please review the following drawing below to familiarize yourself with the listed parts. This manual
covers several treadmills, so the one pictured below may not be identical to your particular model.
CONSOLE
RIGHT UPRIGHT
LEFT UPRIGHT
LATCH
POWER CABLE
TRANSPORT WHEEL
MOTOR COVER
RUNNING BELT
END CAP
SAFETY KEY
BASE
FENDER
Assembly
5
The Keys 4500T Treadmill will require assembly before operating. After opening the box, remove any pack-
ing material from the treadmill.
Do not throw away any packing materials until the unit is working properly.
Place the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.
Locate the hardware pack and identify the following parts required for assembly.
Parts List:
1. Owner’s Manual
2. Base Assembly
3. Console Assembly
4. Left and Right Upright
5. Left and Right Fender
6. Safety Key (Reed Switch)
7. Console Assembly
8. Left and Right Junction Box
9. Philip Screw M6 *12 (Qty 6)
10. Allen Bolt M8 *15 (Qty 12)
11. Washer 9*22*2 (Qty 12)
12. Allen Wrench
Base
Left Upright
Philip Screw M6*12
6 pcs
Right Upright
Console
Safety Key
Manual
Allen Wrench
Right FenderLeft Fender
Left Junction Box
Right Junction Box
Philip Screw ST4.2*13
6 pcs
Allen Bolt M8*15
12 pcs
Washer 9*22*2
12 pcs
Assembly
6
Figure 1
Step 1
Place the left and right uprights
tube through the holes in the left
and right fenders.
Figure 1
Figure 2
Figure 2
Step 1
Slide the fenders up the upright
assembly and pull the console har-
ness through the hole in bottom of
the left upright tube.
Assembly requires the included allen wrench.
Do not plug in the power cord until all assembly steps are completed.
Left Upright
Left Fender
Right Upright
Right Fender
Left Upright
Left Fender
Console Harness
Assembly
7
Figure 3
Figure 4
Figure 3
Step 1
Connect the Console Harness
coming from Left Upright to Cable
Harness coming from Motor Cover.
Step 2
Attach Left Upright and Right
Upright to Base using Allen Bolts
M8x15 (Qty. 8) and Washer 9x22x2
mm (Qty. 8). Do not tighten bolts.
Figure 4
Step 1
Attach Console to Left and Right
Uprights using Washers (Qty 4) and
Allen Bolts (Qty 4).
Left Upright
Left Fender
Right Upright
Right Fender
Washer 9*22*2
Allen Bolt
M8*15
Console
Left Upright
Washer 9*22*2
Allen Bolt M8*15
Right Upright
Assembly
8
Figure 5
Step 1
Connect the Console Harness (left
side), Incline Harness (left side),
EKG Harness (left and right side),
and Speed Harness (right side) to
Harness coming from Console.
Step 2
Attach the Left Junction Box as
shown.
Step 3
Repeat for Right Junction Box.
Figure 5
Figure 6
Figure 6
Step 1
Secure Console and Junction
Boxes to Uprights using Philip
Screw ST4.2*13 (Qty 4).
Incline Harness
EKG Harness
Console Harness
Left Junction Box
Console
Left Junction Box
Right Upright
Left Upright
Philip Screw ST4.2*13
Assembly
9
Congratulations!!
You have completed the assembly of your new Keys 4500T Treadmill.
Figure 7
Step 1
Tighten all Hardware.
Step 2
Secure Right Fender using one
Philip Screw ST4.2*13 and one
Philip Screw M6*12.
Step 3
Repeat for Left Fender.
Figure 7
Philip Screw ST4.2*13
Philip Screw
M6*12
Philip Screw M6*12
Philip Screw ST4.2*13
Right Fender
Moving Instructions
10
CAUTION! TO AVOID THE RISK OF INJURY, NEVER ATTEMPT TO MOVE THE TREADMILL WHILE
IT IS IN THE UNFOLDED OPERATING POSITION. TO REDUCE THE POSSIBILITY OF INJURY
WHILE LIFTING, BEND YOUR LEGS AND KEEP YOUR BACK STRAIGHT. AS YOU RAISE THE
TREADMILL, LIFT USING YOUR LEGS, NOT YOUR BACK. IN ORDER TO RAISE OR LOWER THE
TREADMILL SAFELY, YOU MUST BE ABLE TO LIFT 45 POUNDS (20KG). IT IS SUGGESTED YOU
ALWAYS USE THE AID OF A SECOND PERSON WHEN MOVING THE TREADMILL.
With the treadmill in the folded locked position (safety latch is engaged), grasp the handrail and place one foot
on the center of the base crossbar as shown in the photo below. Next, with a firm grasp on the handrail, carefully tilt the treadmill back until it rolls freely on the wheels. Using extreme caution, move the treadmill to the
desired location. To set the treadmill down, place one foot on the center of the base crossbar and carefully
lower treadmill onto base in resting position. Do not attempt to move the treadmill over an uneven or rough
surface.
Note: The treadmill pictured below may not be identical to your particular model.
Loading...