P1 201309003 KER755_K70-75.pdf 4C( CMYK) ZB2319 2013.09.06
Owner’s manual
Keurig® K-Cup® K70/K75 Platinum Brewer
1
P2 201309003 KER755_K70-75.pdf 1C( K) ZB2319 2013.09.06
IMPORTANT SAFEGUARDS Safe Operation & Use
When using electrical appliances, basic safety precautions should be followed, including the following:
1.Read all instructions before using.
2.Do not touch hot surfaces. Use handles and knobs when available.
3.This appliance must be properly installed and located in accordance with these instructions before it is used.
4.The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electrical shock or injury to persons.
5.Do not place on or near a hot gas or electric burner, or in a heated oven.
6.Do not use outdoors.
7.To protect against fire, electric shock and injury do not immerse cords, plugs, or the appliance in water or any other liquid.
8.Do not overfill the Water Reservoir with water.
9.Use only water in this appliance! Do not put any other liquids or foods in the Water Reservoir except as instructed in the Cleaning Instructions in this guide.
10.Turn off and unplug the brewer before cleaning or maintenance. Allow to cool before putting on or taking off parts and before cleaning the appliance.
11.For best operation, plug the appliance into its own electrical outlet on a dedicated circuit to prevent flickering of lights, blowing of fuses or tripping a circuit breaker.
12. Do not operate any appliance with a damaged cord or plug or after
the appliance malfunctions or is damaged in any manner. Contact Keurig Customer Service to report any malfunction of or damage to the brewer.
13. Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
14.To disconnect, press the Power Switch on the brewer to “OFF” status and then remove the plug from the wall outlet.
15. Close supervision is necessary when any appliance is used by or near children.
16. Do not lift the brewer Handle while brewing is in progress.
17.Always keep the Water Reservoir Lid on the Water Reservoir unless you are refilling it.
18.This appliance is equipped with a power cord having a grounding wire with a grounding plug. The appliance must be grounded using a 3-hole properly grounded outlet. In the event of an
2
electrical short circuit, grounding reduces the risk of electrical shock.
19.If the outlet is a standard 2-prong wall outlet, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.
20.Do not, under any circumstances, cut or remove the third (ground) prong from the power cord or use an adapter.
21. Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
22.Do not use the appliance for other than its intended use.
Save These
Instructions.
WARNING TO USERS AND PARENTS 1. DONOTpermit children to use brewer unless there is adult supervision. Brewer dispenses very hot water.
2. SPECIALNOTICE FOR HOT COCOAUSERS: IMMEDIATELYAFTERUSING A HOT COCOA K-CUP®PACK, RUNa Hot Water Brew Cycle without a K-Cup® pack to avoid the possibility of clogging the exit needleD. ONOTassume the next user will do this.
P3 201309003 KER755_K70-75.pdf 1C( K) ZB2319 2013.09.06
CAUTION:There are two sharp needles that puncture the K-Cup ® pack, one above the K-Cup® Pack Holder and the other in the bottom of the K-Cup® Pack Holder. To avoid risk of injury, do not put your fingers in the K-Cup® Pack Assembly Housing.
CAUTION:There is extremely hot water in the K-Cup ® Pack Holder during the brew process. To avoid risk of injury, do not lift the Handle or open the K-Cup® Pack Assembly Housing during the brewing process.
CAUTION:Do not fill above MAX FILL line. If you fill the Water Reservoir above this point, you may occasionally get a larger brew than you selected for your first brew of the day. If you prefer to have your reservoir filled to the top, we recommend you use a large mug for your first brew of the day to avoid any risk of overflow.
CAUTION: Please always keep the brewer in its upright position to avoid potential injury and/or damage to your brewer.
SHORT CORD INSTRUCTIONS: A short power supply cord is provided to reduce the risk of becoming entangled in or tripping over a longer cord.
If an extension cord is used, (1) the marked electrical rating of the cord set or extension cord should be at least as great as the electrical rating of the appliance; (2) the cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over unintentionally; and (3) the extension cord must include a 3-prong grounding plug.
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.
WARNINGTHIS PRODUCT CONTAINS CHEMICALS, INCLUDING LEAD, WHICH IS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
WARNING |
ELECTRIC SHOCK, DO NOT REMOVE THE |
|
|
|
WARNING: TO REDUCE THE RISK OF FIRE OR |
RISK OF FIRE OR |
! |
BOTTOM COVER. NO USER SERVICEABLE |
ELECTRIC SHOCK |
PARTS ARE INSIDE. REPAIR SHOULD BE DONE |
|
DO NOT OPEN |
BY AUTHORIZED SERVICE PERSONNEL ONLY. |
|
|
|
|
3
TABLE OF CONTENTS
KEURIG® GOURMET SINGLE CUP HOME BREWING SYSTEM K70/K75 Platinum Brewer — Using Your Brewer
SET-UP |
|
Helpful Hints......................................................................................... |
4 |
Unpacking............................................................................................. |
4 |
Features................................................................................................ |
5 |
SECTION 1 — SET-UP & FIRST BREW |
|
Set-Up & First Brew............................................................................ |
6 |
SECTION 2 — CONTROLS & INDICATORS |
|
Setting the Clock................................................................................ |
10 |
Programming On/Off Features....................................................... |
10 |
Programming Brew Temperature.................................................. |
12 |
Programming Brew Size.................................................................. |
13 |
SECTION 3 — CLEANING & MAINTENANCE |
|
Cleaning.............................................................................................. |
13 |
Descaling............................................................................................ |
14 |
Storage................................................................................................ |
16 |
SECTION 4 — TROUBLESHOOTING.................................................. |
17 |
SECTION 5 — WARRANTY................................................................. |
18 |
Record your Brewer Serial Number here. |
|
See Unpacking Instructions on page 4 for serial number location. |
|
Removing the serial number label from the brewer will void warranty. |
|
P4 201309003 KER755_K70-75.pdf 1C( K) ZB2319 2013.09.06
Set-Up
Helpful Hints
1.Plug brewer into its own grounded outlet.
If the electric circuit is overloaded with other appliances, your brewer may not function properly. The brewer should be operated on its own circuit, separate from other appliances.
2.Keep your brewer turned “ON.”
To brew a fresh cup of coffee, tea or hot cocoa anytime you want, keep your brewer turned “ON” all the time. However, the brewer is fully programmable so you can set it to turn on and off automatically to match your schedule.
Or, if you prefer, set the brewer to automatically turn off after a period of time. Follow the simple instructions on pages 10–13 to find the settings that are most convenient for you.
3.For the best tasting gourmet coffee, tea or hot cocoa, Keurig recommends using bottled or filtered water.
Water quality varies from place to place.
If you notice an undesirable taste in your cup of coffee, tea or hot cocoa (such as chlorine or other mineral tastes), we recommend you consider using bottled water or water from a filtration system. For best results, carefully
follow manufacturer’s instructions when using any water filtration system.
4.Customize the size, flavor & brew that’s perfect for you.
With the choice of over 250 varieties of K-Cup® packs and 5 brew sizes (Extra-Small Cup- 3.25 oz., Small Cup-5.25 oz., Small Mug-
7.25 oz., Large Mug-9.25 oz., and Travel Mug-11.25 oz.), your Keurig® brewer gives you endless options to customize the size, flavor and brew that’s perfect for you. For a strong, intense cup, select an Extra Bold K-Cup® pack (with up to 30% more ground coffee than regular varieties) and brew the size that’s right for you. The smaller the brew size, the more intense flavor in your cup. The larger the brew size, the less intense flavor in your cup.
5.Remove K-Cup® pack after use.
Please see page 7 for brewing instructions.
6.Brewing into a travel mug.
To brew into a travel mug, simply remove the Drip Tray Assembly and place the travel mug on the Drip Tray Base.
7.Descale brewer regularly.
Please see pages 14 and 15 for instructions.
Unpacking Instructions
1.Place brewer box on a large steady surface (such as a table or countertop) or on the floor. Open the box.
4
2.Remove enclosed literature.
3.Turn the box on its side with front of box face down.
4.Reach into the box and grasp the plastic bag that contains the brewer.
5.Carefully pull the plastic bag (and packaging materials) toward you and out of the box. The brewer will still be encased in the polyfoam and be on its side.
6.Remove the top polyfoam packaging material.
7.Carefully lift brewer off of the bottom polyfoam and place it upright on a flat, steady surface.
8.Lift plastic bag off of brewer.
9.Record the serial number for this brewer on page 3 of this guide. The serial number can be found on the bottom of the brewer box or on the brewer behind the Drip Tray (when removed).
10.Place the brewer upright on a flat, steady surface. Remove tape holding Water Reservoir in place.
We recommend you save all packing materials in case future shipping of the product is necessary.
WARNING:
Keep all plastic bags away from children.
P5 201309003 KER755_K70-75.pdf 1C( K) ZB2319 2013.09.06
Features K70/K75 Platinum Brewer
A |
B |
|
|
F |
|
R |
|
|
|
|
|
|
|
|
|
|
|
|
I |
|
C |
|
|
O |
|
|
|
D |
|
|
E |
J |
H |
|
|
|
|
|
|||
|
|
|
G |
|
||
|
|
|
|
|
|
|
|
Q |
K |
|
|
S |
T |
|
|
|
L |
|
||
|
|
|
|
|
||
|
|
|
|
|
|
|
|
P |
|
|
|
|
U |
|
|
|
|
|
|
|
|
|
|
|
|
M |
V |
|
|
|
|
N |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Controls |
K70/K75 Platinum Brewer |
|
|
|
|
and Indicators |
|
A. Water Reservoir Lid |
F. Handle |
|
|
J. K-Cup® Pack |
O. Vent |
R. LCD Control Center |
B. Easy-Fill Lid |
G. Funnel |
|
|
Assembly Housing |
P. Power Cord |
S. Left Button |
C. MAX FILL |
H. K-Cup® Pack Holder |
|
K. Housing |
Q. Power Switch not |
T. Right Button |
|
D. Water Reservoir |
(G and H are the K-Cup® |
|
L. Drip Tray Plate |
shown (located rear |
U. MENU Button |
|
E. Water Reservoir |
Pack Holder Assembly) |
|
M. Drip Tray |
right side of brewer) |
V. BREW Button |
|
Lock Tab Slot |
I. Lid |
|
|
N. Drip Tray Base |
|
|
|
|
|
|
5 |
|
|
P6 201309003 KER755_K70-75.pdf 1C( K) ZB2319 2013.09.06
SECTION 1 Set-Up & First Brew
IMPORTANT: You cannot use your Keurig® brewer until it has been set up for its first use.
NOTE: If brewer has been exposed to temperatures below freezing, allow brewer at least two hours to reach room temperature before brewing. A frozen or extremely cold brewer will not operate.
Setting Up Your Brewer
1. Unwrap cord and plug the brewer into a fig. 1 grounded outlet. Remove all pieces of
packing tape and clear plastic sticker from LCD Control Center.
2. Place a large mug (10 oz. minimum) on the Drip
Tray Plate.
3. Remove the Water Reservoir from brewer by first removing Lid from the Water Reservoir (fig. 1), then lifting the Water Reservoir straight up and toward front of brewer (may be tight), (fig. 2 A). Rinse with fresh water.
4.Fill Water Reservoir with bottled or filtered water so that the water level is to and not beyond the MAX FILL line.
5.Place Water Reservoir base into the left side of the brewer and be sure the Water Reservoir Lock Tab engages with the brewer. Replace Lid on Water Reservoir. NOTE: Please ensure the Water Reservoir is seated properly, so that the back of the Water Reservoir is flush with the brewer (fig. 2 B and C).
fig. 2 |
Lock Tab |
A |
B |
C |
|
Seated Properly |
Not Seated Properly |
6. Press and release the Power Switch found fig. 3 directly behind the right side of the brewer.
Switch is spring loaded and will return to original position.
7. The LCD Control Center will illuminate and indicate “NOT READY.” NOTE: A K-Cup® pack should not be used for this sequence.
8. The brewer will automatically fill the internal tank with water and then the water will be
heated. This will take about 4 minutes. During the heating period, the LCD Control
Center will indicate “NOT READY” (fig. 3).
Do not lift the Handle during this heating period. Once the water is heated, “READY TO BREW” will be indicated and the BREW Button will be illuminated (fig. 4). NOTE: You may see
6
Loading...