Kettler STOCKHOLGM GT 07122-490, STOCKHOLGM GT 07162-490 User Manual

2.79 Mb
Loading...

Owners Manual

Table Tennis Table

“STOCKHOLM GT”

Model Number 07162-490/07122-490

USA

Adult Assembly Required

picture similar

KETTLER International Inc. · 1355 London Bridge Road · Virginia Beach, VA 23453 USA www.kettlerusa.com

info@kettlerusa.com

Important notes

Before assembling or using the table-tennis table, please read the following instructions carefully. They contain important information for use and maintenance of the equipment as well as for your personal safety. Keep these instructions in a safe place for maintenance purposes or for ordering spare parts.

All KETTLER products are designed in accordance with the latest safety regulations and undergo a constant process of quality control during manufacturing. The knowledge gained in this process is used to constantly improve and develop our products. In order to offer our customers the very best in product quality, we reserve the right to make technical changes at any time. In spite of this, should you have any cause for complaint, please contact KETTLER.

Note on Safety

The table-tennis table should be used only for its intended purpose, i.e. for playing with suitable table-tennis racquets and balls.

All other uses are prohibited and may be dangerous. The manufacturer cannot be held liable for damage or injury caused by improper use of the table.

Damaged or worn components may endanger your safety or shorten the lifespan of the table-tennis table. Replace worn or damaged components immediately and remove the table from use until this has been done. Use only spare parts manufactured by KETTLER.

The table-tennis table complies with all safety regulations. Incorrect repairs, alterations to the design (removal of original parts, addition of other components etc.) may endanger the safety of the user.

Handling the equipment

Do not use the table-tennis table until it has been fully and correctly assembled and checked.

Ensure that indoor table-tennis tables are not exposed to dampness or rain. Keep them well away from direct sources of heat. Should the surface become warped, lay the table on a level surface for a few days.

Set the table up on a level surface.

Do not cover it with plastic foil, under which condensation may form. To protect your outdoor table keep it closed and covered by the KETTLER table tennis cover (item # 7032-400) when not in use.

Instruct other persons (in particular children) using the table in its correct use, and draw their attention to any potential source of danger, especially when setting up or dismantling the table.

When setting up or dismantling the table, stay clear of its folding radius.

When folded up, the table-tennis table presents a large surface to the wind. For this reason, ensure that it is stored in a sheltered position.

The table-tennis table may be pushed only into the transport position because there is otherwise a danger of injury.

The unit complies with the standard EN 14468–1:2004.

Depending on frequency of use, check all screws, bolts etc. regularly to ensure that they are in good condition.

In case of enquiry, please contact your KETTLER dealer.

For practicing without a partner, the table halves can be folded up singly.

For more information on the sport of table-tennis, you are referred to the specialist literature on the subject.

Do not use corrosive or abrasive materials to clean the equipment. Ensure that such materials are not allowed to pollute the environment. In most cases, a slightly dampened cloth is sufficient.

Waste Disposal: KETTLER products are recyclable. At the end of its useful life please dispose of this article correctly and safely (local refuse sites).

Instructions for Assembly

The equipment must be assembled with due care by two adult persons.

Ensure that you have received all the parts required (see check list) and that they are undamaged. Should you have any cause for complaint, please contact your KETTLER dealer.

Before assembling the equipment, study the drawings carefully and carry out the operations in the order shown by the diagrams. The correct sequence is given in capital letters.

Please note that there is always a danger of injury when working with tools or doing manual work. Therefore please be careful when assembling this machine.

Ensure that your working area is free of possible sources of danger, for example don’t leave any tools lying around. Always dispose packaging material in such a way that it may not cause any danger. There is always a risk of suffocation if children

play with plastic bags!

The fastening material required for each assembly step is shown in the diagram inset. Use the fastening material exactly as instructed.

Bolt all the parts together loosely at first, and check that they have been assembled correctly. Tighten the locknuts by hand until resistance is felt, then use wrench to finally tighten nuts completely against resistance (locking device). Then check that all screw connections have been tightened firmly. Attention: once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced.

For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of tubing plugs).

Please keep original packaging of this article, so that it may be used for transport at a later date, if necessary.

List of spare parts

When ordering spare parts, always state the full article number, sparepart number, the quantity required and the S/N of the product (see spare parts drawing).

Example order: Art. no. 07122-490 / spare-part no. 10100016 / 2 pieces / S/N......

Important: spare part prices do not include fastening material; if fasten-

ing material (bolts, nuts, washers etc.) is required, this should be clearly stated on the order by adding the words „with fastening material“.

For parts and service ONLY call 866.804.0440 or send email to parts@kettlerusa.com

KETTLER International Inc. · 1355 London Bridge Road · Virginia Beach, VA 23453 USA

2

KETTLER LIMITED WARRANTY

THERE ARE NO WARRANTIES, EXPRESSED OR IMPLIED, MADE BY EITHER THE DISTRIBUTOR OR THE MANUFACTURER ON KETTLER PRODUCTS, EXCEPT THE MANUFACTURER’S LIMITED WARRANTY AGAINST DEFECTS IN MATERIAL SET OUT BELOW:

This KETTLER Limited Warranty applies to products sold through the KETTLER Authorized Dealer Network to the original retail purchaser and authenticated by proof of purchase from a retailer located in the United States. Any shipments made under this warranty will be shipped to the United States only. Any shipment outside of the United States will be at the sole cost of the customer. This KETTLER Limited Warranty is a manufacturer’s warranty and is not changed or modified by additional warranties extended by individual retailers at the point of sale. Manufacturer warrants this product to be free from defects in material at the time of the product’s tender of delivery for a period of 3 years for residential use and 1 year for non-residential use. This Limited Warranty is not transferable and does not cover normal wear and tear (including, but not limited to, damage and wear to tires, power shocks, drive belts and other non-durable parts). The liability of the manufacturer under this Limited Warranty shall not include any liability for direct, indirect, or consequential damages resulting from the defect. This Limited Warranty is void if the product is damaged by accident, unreasonable use, improper service, failure to follow instructions provided, modification from its original state, or other causes determined not arising out of defects in material. This warranty gives you specific legal rights. Should this product become defective due to material within the warranty period, contact KETTLER Parts & Service Dept. by phone at 866.804.0440, fax at 757.563.9273, or e-mail at parts@kettlerusa.com.

THIS LIMITED WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, AND OF ANY OTHER OBLIGATIONS OR LIABILITY ON THE PART OF THE MANUFACTURER. KETTLER NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH SUCH PRODUCTS.

Checklist

 

 

 

 

 

 

 

2x

 

2x

 

 

 

 

(7162-490)

 

(7122-490)

 

 

1x

 

 

 

 

 

 

 

 

 

 

 

 

2x

 

 

 

 

 

 

2x

 

 

 

 

 

 

2x

 

 

 

 

2x

2x

4x

 

 

 

 

 

 

 

 

 

 

4x

2x

 

 

 

 

 

 

 

 

 

 

 

3x

 

 

 

 

 

 

2x

 

 

 

 

 

2x

1x

 

 

 

 

 

 

 

4x M8x125

4x M8x110

8x M8

2x

4x

4x

4x M6x100

4x M5x65

4x

6x M6

4x

2x

6x

 

 

 

ø12

 

 

 

6x M8x60

2x M6x58

8x

4x M5

4x

2x

2x

 

 

 

ø12,5

 

 

 

 

 

 

 

4x

M6x 3mm

 

4x M6x45

4x M6x49

24x

4x M6

2x

2x

 

 

 

ø16

 

 

 

 

6x 3,9x13

10x

2x

4x

M6x 5mm

2x

 

2x

 

 

 

ø25

 

 

 

For outdoor table-tennis tables only

4x

You also need the following tools (Not included):

SW13

SW10

2x

2x

1x

1x

3

1

2x

2

2x

2x ACTUAL SIZE

4x

2x

ø25

ø25

4

3

2x

1x

4x ACTUAL SIZE

1x

4

2x

1x

4x ACTUAL SIZE

1x

5

+ 11 hidden pages