KERO Neris 3 User Manual
Instructions MANUAL
Folding kayak NERIS-3
1. General description
NERIS-3 is a touring folding kayak ideal for flat Technical features:
water trips on rivers, lakes and water
reservoirs. It is also suitable for sea and ocean
kayaking along shore line.
The light weight and high compatibility are Weight 29 kg
the main advantages of the NERIS folding
kayak providing paddlers ease in transporting
and use.
The kayak assembly and disassembly time is
within 20-25 minutes. No additional tools are
required. The framing of the kayak provides
required stiffness and shape to have great
paddling experience.
Loading capacity 375 kg
Length 5,7 m
Width 0,88 m
Packaging size:
back pack (mm) 500 x 900 x 230
long pack (mm) 1100 x 280 x 280
Kayak capacity:
recreational trips: 2 adults + 2 child
touring expedition: 3 adults
or 3 adults + 1 child
1
2. Bags’ Content
1. Set of Crossribs - 5 psc.
2. Bow and Stern Assembly
3. Bow, Stern and Central A-shape
Keelbars - 4 psc.
4. Set of Stringers:
a - dual stringer plates - 6 psc
b - single long stringers - 6 psc
c - single short stringers - 6 psc
5. Set of Washboards - 8 psc.
6. Skin
7. Seats with backrests - 3 psc.
8. Back pack and Long pack
9. Repair Kit
1
2
3
4
5
2
3. Assembly Instructions
All NERIS folding kayaks are run through
presale test assembly. However, the first
kayak assembly may seem to be more
challenging then following one. The skin is
being stretched with each assembly and it
will be easier to put the skin on a frame.
Two people kayak assembly is
recommended. The kayak is to be
assembled on even and clean surface.
Avoid assembling the kayak on sand. It may
cause damage to joining parts and more
difficult assembly and disassembly in
future.
The main parts of the kayak are marked
with numbers and pointing arrows for ease
of assembly.
Marking points:
LB – Bow, Left
LS – Stern, Left
LC – Central, Left
RB – Bow, Right
RS – Stern, Right
RC – Central, Right
Step 1.
Attach A-Shape Keelbars to Bow and Stern
Assembly, positioning holes to see through..
Then attach Crossribs #1 and #5 to Bow Assembly
as marked with two arrows pointing each other.
Use a wing nut and bolt to secure the crossrib.
The Assembly upper and middle stringers are
connected by plates with keyhole slots to be
secured on sides of Crossribs #1 and #5..
3
Loading...