Kenmore Elite 79041249800, 79041242800, 79041243800, 79041233800, 79041239800 Installation Guide

...
0 (0)
iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
Cooktop Dimensions
Cooktop Cutout Dimensions
iMPORTANT INSTALLATION-INFORMATION
All electric cooktops run off a single phase, three-wire or four-wire cable, 240/208 volt, 60 hertz, AC only electrical supply with ground.
Pleasenote minimum distances between cooktop and adjacent and overhead cabinetry is 30" (76.2 cm).
* 30" (76.2 cm) min. for unprotected cabinet
24" (61 cm) min. for protected surface
C
4" X 8" (10.2 cm x 20.3 cm)
opening at the right rear
to route armored cable
if a panel is present
G
Figure I - 30" Model shown only
:ii !ii i!i!i'!i'!i'i! ii!i!iill
30"CeramicModel 36"CeramicModel
303A(78.1) 21Y2(54.6) (8.3) 29(73:6) 363A(93,3) 21Y2(54.6) (8,3) 35(88,9)
DTH _
M
30"CeramicModel 29%(75.2) 30(76.2) 20¼(51.4) 20Y2(52.1) 6(15.2) 36"CeramicModel 35%(90,5) 36(914) 20¼(51,4) 20Y2(52,1) 6(152)
All dimensions are in inches (cm). * Allow 2" (5 cm) space below cooktop to clear the electric cable and allow for
installation of the junction box on the wall at the back of the cooktop.
Printedin United States
P/N 318205406 (0806) Rev. A
19¼(48.9) 19¼(48.9)
English - pages 1-6
Espahol - pages 7-12
Overhead Cabinet Should Not Exceed a Maximum
Depth of 13" (33 cm)
30" (76.2 cm) Min. Clearance Between the
Top of the Cooking
Platform and the Bottom
of an Unprotected Wood or Metal Cabinet _,_
24" (61 cm) Min. when Bottom of Wood or
Metal Cabinet is Protected by Not Less
Than 1/8" Flame
Retardant Millboard Covered With Not Less Than No. 28 MGS Sheet
Steel, 0.015" (0.4 mm) Stainless Steel, 0.024" (0.6 mm) Aluminum or
0.020" (0.5 mm) Copper
18"
(45.7 cm)
G
4-
Distance Between "--,,L_,.----------
Edge of Cutout
and Nearest 10" Combustible Surface ( 25.4 cm)
Above Countertop
12"
(30.5 cm)
J Min. From
Edge of
Cooktop to
Nearest
Combustible Wall (Either
Side of Unit).
Approximate Location
2 1/2" (6.4 cm) Min. From
Edge of Cutout to Front Edge of Countertop
Letters on this figure refer to chart on front page except for J& K.
_To eliminate the risk of burns or fire by reaching over heated surfaces, cabinet storage space located above the cooktop should be avoided. If cabinet storage is provided, risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.
Figure 2 - COUNTERTOP CUTOUT OPENING
of Junction Box
30" CeramicGlass 71/2"(19.1cm) 2" (5.1cm) 36" CeramicGlass 71/2"(19.1cm) 2" (5.1cm)
2
It is not recommended to use drawer underneath cooktop.
Empty space is needed for installation purpose.
important Notes to the Installer
1. Read all instructions contained in these installation instructions before installing the cooktop.
2. Remove all packing material before connecting the electrical supply to the cooktop.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
Important Note to the Consumer Keep these instructions with your Use and Care Guide for
future reference.
IMPORTANT SAFETY INSTRUCTIONS
Be sure your cooktop is installed and grounded
properly by a qualified installer or service technician.
These cooktops must be electrically grounded in
accordance with local codes or, in their absence, with the National Electrical Code ANSI/NFPA No.
70--latest edition in the United States, or with CSA Standard C22.1, Canadian Electrical Code, Part 1, in Canada.
2. A circuit breaker of 40 Amp is recommended. NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance with the National Electrical Code ANSI/NFPA No. 70-
latest edition, and local codes and ordinances.
An extension cord must not be used with this appliance. Such use may result in a fire, electrical shock, or other personal injury.
3. The appliance should be connected to the fused
disconnect (or circuit breaker) box through flexible armored or nonmetallic sheathed cable. The flexible
armored cable extending from this appliance should be connected directly to the grounded junction box. The junction box should be located as shown in Figure 2 with as much slack as possible remaining in the cable between the box and the appliance, so it can be moved if servicing is ever necessary.
4. A suitable strain relief must be provided to attach
the flexible armored cable to the junction box.
Unpacking Instructions
_The electrical power to the cooktop must be shut off while line connections are being
made. Failure to do so could result in serious injury or death.
Provide Electrical Connection Install the junction box under the cabinet and run 120/
240 or 120/208 Volt, AC wire from the main circuit panel. DO NOT connect the wire to the circuit panel at
this time.
Electrical Requirements Observe all governing codes and local ordinances.
1. A 3-wire or 4-wire single phase 120/240 or 120/208 Volt, 60 Hz AC only electrical supply is required on a separate circuit fused on both sides of the line (time-delay fuse or circuit breaker is recommended).
DO NOT fuse neutral.
,, //
and Serial Plate
rlgr"-ure3 (UnderCooktop)
,
Leave corner supports on cooktop until completion
of Electrical Connection.
2.
Be sure the bottle of cleaner conditioner packed in the literature bag is left where the user can find it easily. It is important that the ceramic-glass smoothtop be pretreated before use. SeeCooktop Cleaning and Maintenance section in the Use
and Care Guide.
//
3
Electrical Connection Connect the flexible armored cable that extends from
the surface unit to the junction box using a suitable strain relief at the point the armored cable enters the
junction box. Then make the electrical connection as
follows.
If your cooktop has a 4-wire cable to be connected
to a 3-wire grounded junction box (see figure 5):
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box: connect appliance and power supply cable wires as shown in figure 5.
Electrical ground is required on this appliance.
This appliance is equipped with a
copper conductor flexible cable. If connection is made to aluminum house wiring, use only special connectors which are approved for joining cooper
and aluminum wires in accordance with the National Electrical Code and local codes and
ordinances. Improper connection of aluminum house wiring to copper leads can result in a short
circuit or fire. Follow the connector manufacturer recommended procedure closely.
This appliance is manufactured with a frame connected green (or bare copper) ground wire.
DO NOT ground to a gas supply pipe.
DO NOT connect to electrical power supply until appliance is permanently grounded. Connect the ground wire before turning on the power.
Where local codes permit connecting the appliance- grounding conductor to the neutral (white) wire:
If your cooktop has a 3-wire cable to be connected to a 3-wire grounded junction box (see figure 4):
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box: connect appliance and power supply cable wires as shown in figure 4.
Cable from Power Supply
Cable from Power Supply
White Wire p-----_ (Neutral) _ __,_,B) acK
,q wires-
v_/Rel_=_Red
L----_ I ___//_/_ I_____Junctio n
B°x
wi o
Ground Wire J ted CINdutirtal) (Bare or Green Wire) Connector (or CSA listed)
Cable from appliance
Figure 5
3-WIRE GROUNDED JUNCTION BOX
You may not ground the cooktop
through the neutral (white) wire if cooktop is
used in a new branch circuit installation (1996 NEC), mobile home, recreational vehicle, or where
local codes do not permit grounding through the neutral (white) wire. When grounding through
the neutral (white) wire is prohibited, you must
use a 4-wire power supply cable. See Figure 6 & 7. Failure to heed this warning may result in electrocution or other serious personal injury.
White Wire _'_-7'.._J_ (Neutral) [_
Wire_---_,_Red
Ground Wire / "_-J_ (Bare or Green Wire)
Cable from appliance
Figure 4
3-WIRE GROUNDED JUNCTION BOX
ck
ires
-Junction Box
U.L.-Listed Conduit Connector (or CSA
listed)
4
Loading...
+ 8 hidden pages