Kenmore Elite 79033269600, 79033263600, 79033263601, 79033243601, 79033249600 Installation Guide

...

0 (0)

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.

iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.

READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.

If the information in this manual is not followed exactly, a fire or explosion may result

causing property damage, personal injury or death. FOR YOUR SAFETY:

-- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or

the gas supplier.

30" Min.

Gas Cooktop Dimensions

21/2"

(76.2 cm) _la

Gas Cooktop (6.4 cm) Cutout Dimensions , tt

Figure 1

i_!_iiii__i_i_i_!iii!_i_i_¸i_i_i!_!_!_i_i_i_i_i_i_!ii_!!!!!_i_i_i_i_i_i_i_i_i_i_i_i_i_!_!_!_!_!!!!_ii_

30"GasCooktop 30 (76.2) 213A(55.2) 4_A(10.8) 27(68.6) 19 (48.3) 36"GasCooktop 36 (91.4) 213A(55.2) 4_A(10.8) 33_/4(84.5) 19(48.3)

30"GasCooktop 27Y4(69.2) 273A(70.5) 19_/8(48.6) 19s/8(49.8) 8 (20.3) 36"GasCooktop 33_/4(84.5) 333A(85.7) 19_/8(48.6) 19s/8(49.8) 8 (20.3)

All dimensions are stated in inches and (cm). Dimension H includes a 5" (12.7 cm) space underneath the cooktop for connection to gas supply line. NOTE: Wiring diagrams for this cooktop are enclosed in this booklet

Printed in United States

318201470 (0606) Rev.A

Espar_ol- p_qginas 10-18

Wiring Diagram 19-20

English - pages 1-9

Important Notes to the Installer

I. Read all instructions contained in these installation

instructions before installing the cooktop.

2. Remove all packing material before connecting the electrical supply to the cooktop.

3. Observe all governing codes and ordinances.

4. Be sure to leavethese instructions with the consumer.

5. Note: For operation at 2000 ft. elevations above see level, appliance rating shall be reduced by 4 percent

for each additional 1000 ft.

Important Note to the Consumer

Keep these instructions with your Useand Care Guide for future reference.

IMPORTANT SAFETY

INSTRUCTIONS

Installation of this cooktop must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1/NFPA 54 in the United States, or in Canada, with the Canadian Fuel Gas Code, CAN/CGA

B149 and CAN/CGA B149.2.

When installed in a manufactured (mobile) home

installation must conform with the Manufactured Home Construction and Safety Standard, title 24 CFR,part

3280 [Formerly the Federal Standard for Mobile Home Construction and Safety, title 24, HUD (part 280)] or, when such standard is not applicable, the Standard for Manufactured Home Installation, ANSI/NCSBCS A225.1 or with local codes where applicable.

This cooktop has been design certified by CSA International. As with any appliance using gas and generating heat, there are certain safety precautions you

should follow. You will find them in the Useand Care Guide, read it carefully.

• Be sure your cooktop is instaJJed and grounded properly by a qualified installer or service

technician. This cooktop must be electrically grounded in

accordance with local codes or, in their absence, with the National ElectricaJ Code ANSI/NFPA No.

70--latest edition in the United States, or in Canada, with the Canadian Electrical Code, CSA

C22.1 Part 1.

• The burners can be lit manually during an electrical power outage. To light a burner, hold a lit match to the burner head, then slowly turn the

Surface Control knob to MTE. Use caution when lighting burners manually.

• Do not store items of interest to children in cabinets above the cooktop. Children could be

seriously burned climbing on the cooktop to reach items.

• To eliminate the need to reach over the surface burners, cabinet storage space above the burners

should be avoided.

• Adjust surface burner flame size so it does not extend beyond the edge of the cooking utensil

Excessive flame is hazardous.

• Never use your cooktop for warming or heating the room. Prolonged use of the cooktop without adequate ventilation can be hazardous.

• Do not store or use gasoline or other flammable vapors and liquids near this or any other appliance. Explosions or fires could result.

The electrical power to the cooktop

must be shut off while gas line connections are being made. FaiJure to do so could resuJt in serious injury or death.

13" (33 cm)

Max. Depth For Cabinet

Installed Above Cooktop.

18" Min,

(45.7 cm)

11/2"(3.8 cm)Minimum Distance Between RearEdge of Cutout

and Nearest Combustible Surface

Above Countertop,

Clearance

30" (76.2 cm) Min, Clearance

Between the

Top of the

Cooking Platform and

Unprotected

Wood or Metal

Cabinet

24" cm)

_To eliminate the risk of burns or fire from reaching over heated

surfaces, cabinet storage space located above the cooktop should be avoided. If cabinet storage is provided, risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the

cabinets.

Drawers Cannot Be Used with This Cooktop Since Burner Box Extends

3s/32'' (8.02 cm) Below Surface of Countertop.

30'_Cooktop 30'_(76.2 cm) 7'_(17.8 cm) 36'_Cooktop 36'_(91.4 cm) 7'_(17.8 cm)

Figure 2 - CABINET DESIGN

7"(17.8 cm) 7"(17.8 cm)

Typical Gas Cooktop Installation Over

an Electric Built-in Oven Installed Under the Counter

I_---- 18" (45.7 cm) Max.-----_

Wall

Manifold Pi

Flexible Connector

Oven Cabinet

Cabinet sides or

filler panel

5" ,(16.5 cm)

Flare (12.7cm) Min. Union

_J Flare _j Union

61_2"

120V/60Hz

Grounded

Outlet

Pressure Regulator

Manual Shutoff Valve

(To be accessible for shut-off valve opera-

tion)

4" (10.2 cm)

Right Side of

Cabinet

Typical Under Counter Installation of an Electric Built-in

Oven with a Cooktop Mounted Above

Side filler panels are necessary to isolate the unit from adjoining

cabinets. Panelheight should allow

for installation of approved cooktop

models. See "Typical Gas Cooktop Installation Over an ElectricBuilt-in

Oven Installed Under the Counter" on previous page.

32" Min.** (81.3 cm)

36"

(91.4 cm)

All mounting hardware must be used to secure

the built-in oven to the cabinets. Refer to the built-in oven installa- tion instructions.

208/240 Volt grounded junction

box for built-in

Junction box must

be located approx. 3" to the left of

the built-in oven cutout,

This cooktop may be installed over

certain built-in elec- tric oven models.

* If no cooktop is installed directly

over the oven unit, 5" (12.7 cm)

maximum is allowed.

** 32" (81.3 cm) min. from top of

cabinet to top of runners must be

maintained.

Use 3/4" (1.9 cm) plywood, installed on two runners, flush with toe plate. Must be capable of supporting 150 Ibs.

Cut an opening in wood base minimum 9" (22.9 cm) x 9" (22.9 cm), 2" (5.1 cm) from left side filler panel, to route armoured cable to junction box.

4 1/2" (11.4 cm)

Max.*

CUTOUT DIMENSIONS (inches)

OVEN SIZE E F G

Min. Max, Min. Max.

30" 27¼" 28s/8 '' 281/2" 29" 231/2"

(76.2 cm) (69.2 cm) - (72.7 cm) (72.4cm) - (73.7 cm) (59.7 cm)

27" 27¼" 28s/8 '' 247/8 '' 25¼" 231/2"

(68.6cm) (69.2cm) - (72.7cm) (63.1cm) (64.1cm) (59.7cm)

Wall Outlet Location

12"_

To clamp down, insert an angle bracket into the slot on each side of the unit as shown.Run thumb screw up through the bracket, up against the bottom of the counter. Tighten until the unit draws down and issecure.

Provide an Adequate Gas Supply

This cooktop is designed to operate on natural gas at 4" of manifold pressure only.

10"

A pressure regulator is connected in series with the manifold on the cooktop and must remain in series with the supply line.

Recommended area for

12OV grounded outlet

on rear wall.

_.._F UEN_T 22"

: NOTE: If an outlet I is not available,

have one installed by

i a qualified technician. _,

OF UNIT

Figure 3

Cooktop Installation

1. Visually inspect the cooktop for damage.

2. Set the cooktop into the countertop cutout.

NOTE: Do not use caulking compound; cooktop should be removable for service when needed.

Clamp Down Information

Once the cooktop is installed in the counter opening, you must clamp the unit down as shown.

Countertop

Cooktop _ t

, _ _ ,

For proper operation, the maximum inlet pressure to the regulator must be no more than 14" of water column (W.C.) pressure.

For checking the regulator, the inlet pressure must be at least 1" (or 2.5 kPa) greater than the regulator manifold pressure setting. The regulator is set for 4" of manifold pressure, the inlet pressure must be at least 5".

The gas supply line to the range should be I/2" or 3/4" pipe.

LP/Propane Gas Conversion

This appliance can be used with Natural gas or LP/ Propane gas. It is shipped from the factory for use with

natural gas.

A kit for converting to LPgas is supplied with your cooktop. The kit is marked "FOR LP/PROPANEGAS CONVERSION".

The conversion must be performed by a qualified service technician in accordance with the kit instructions and all

local codes and requirements. Failure to follow instructions could result in serious injury or property

damage. The qualified agency performing this work assumes responsibility for the conversion.

Failure to make the appropriate

conversion can result in serious personal injury and property damage.

Angle ......__Ll_

Bracket_

Figure 4

_ Thumb

Screw

+ 14 hidden pages