Kenwood TTM322, TTM403, TTM324, TTM401, TTM400 User Manual

				Use the carriage lever to lift the
				toast to Peek & View™ at any
				time without cancelling the toasting
				cycle.
				before using your Kenwood
				appliance
			●	Read these instructions carefully
				and retain for future reference.
			● Remove all packaging and any
				labels.
			safety
			● Burnt food can catch fire, so:
			●	never leave your toaster on
				unattended;
			●	keep your toaster away from
				anything (eg curtains) that could
				catch fire;
			●	set the browning control lower for
				thin or dry bread;
			●	never warm food with a topping or
				filling (eg pizza): if it drips into the
				toaster, it could catch fire.
			●	Clean the crumb tray regularly:
				crumbs can smoke or burn.
			● To avoid electric shocks, never:
			●	let the toaster, cord or plug get wet;
				or
			●	put your hand or anything metal,
				eg a knife or foil, into the toaster.
			● Always unplug the toaster when not
				in use, before cleaning or
				attempting to clear jammed bread.
			● Never cover your toaster with a
				plate or anything else - it could
				overheat and catch fire.
			● Never let the cord hang down
				where a child could grab it.
			● We recommend that you do not
				use your toaster directly under wall
				cupboards.
			● Do not move the toaster whilst it is
				in operation.
			● Never touch hot surfaces especially
				the metal top area.

●Never use an unauthorised attachment or accessory.

●Never use a damaged toaster. Get it checked or repaired: see 'Service'.

●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

●Children should be supervised to ensure that they do not play with the appliance.

●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

before plugging in

●Make sure your electricity supply is the same as the one shown on the underside of your toaster.

●This appliance complies with European Economic Community Directive 89/336/EEC.

Important – UK only

●The wires in the cord are coloured as follows:

Green and Yellow = Earth, Blue = Neutral,

Brown = Live.

●The appliance must be protected by a 13A approved (BS1362) fuse.

●WARNING: THIS APPLIANCE MUST BE EARTHED.

Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.

before using for the first time

1Clip excess cord into the cord storage clips in the base .

●Operate the toaster once on a medium setting without bread. (The lever will not stay down unless the toaster is plugged in).

●As with all new heating elements, your toaster may emit a slight burning smell when it is first switched on. This is normal and not a cause for concern.

key

Peek & View™ carriage leverbrowning control

reheat button with indicator lightdefrost button with indicator lightcancel button with indicator lightcrumb tray

cord storage

to use your toaster

1Plug the toaster into the power supply.

2Move the browning control to the desired setting. Use a low setting for light toasting and for thin or dry bread.

3Insert the bread, muffins, bagels etc.

4 Lower the lever until it locks. The ‘cancel’ button will illuminate. (The lever will not stay down unless the toaster is plugged in).

●To toast frozen bread, once the bread is lowered press the ‘defrost’ button. The ‘defrost’ button will illuminate.

●To warm toast that’s popped up but gone cold, lower the toast then press the 'reheat' button. The ‘cancel’ and ‘reheat’ buttons will illuminate.

●Use the carriage lever to lift the toast to Peek & View™ at any time without cancelling the toasting cycle.

●To stop toasting during the cycle, press the ‘cancel’ button, the toast will pop up and the ‘cancel’ button light will go off.

5Your toast will pop up automatically, to raise it higher, lift the lever.

hints on using your toaster

●Select a lower setting for light browning, for toasting one slice only or for dry bread.

●When toasting a single slice of bread, you may notice a variation in toast colour from one side to the other - this is normal.

●Dry/stale bread toasts more quickly than fresh bread and thinly sliced bread toasts more quickly than thickly sliced bread. Therefore the browning control should be set at a lower setting than usual.

●For best results ensure that the bread slices are of an even thickness, freshness and size.

●In order to achieve uniform browning we recommend you wait a minimum of 30 seconds between each toasting so that the control can automatically reset. Alternatively select a lower setting when additional toasting is carried out.