Assembly Instructions
Description: |
CB Radio Kit |
Model: |
Vulcan 1700 Voyager |
|
|
|
|
Part Number: |
K10400-037 |
Approximate |
60 min. |
|
|
Assembly Time: |
|
Installation of this accessory should be performed by a qualified technician with the proper tools and equipment.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to complete the installation. Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect installation.
|
Parts List |
|
Tools Required: |
|
Seq. |
Description |
Qty |
Tool Description |
|
1. |
CB Radio Module Assembly |
1 |
Drill Motor |
|
2. |
M6 x 30mm Bolts |
2 |
Scribe |
|
|
|
|
1/16” Drill Bit |
|
3. |
CB Antenna Cable |
1 |
||
|
|
|
7mm (1/4”) Drill Bit |
|
4. |
CB Antenna Base |
1 |
||
|
|
|
5mm Hex Head Driver |
|
5. |
M6 x 20mm Philips Head Bolt |
1 |
||
Socket Driver |
||||
6. |
CB Ground Strap |
1 |
||
10mm Socket |
||||
7. |
M6 Lock Nuts |
2 |
Philips Head Screwdriver |
|
8. |
Lock Washer |
1 |
|
|
9. |
Belleville Washer |
1 |
|
|
10. |
M6 Cap Nut |
1 |
|
|
11. |
Cable Ties, 6 inch |
8 |
|
|
12. |
Cable Tie, 14.5 inch |
1 |
|
|
13. |
CB Antenna Mast |
1 |
|
|
14. |
Star Washer |
1 |
|
Installation Instructions
Installation Preparation
Parts Removal
zz Set bike securely on side stand on level ground. Switch off ignition and remove key.
zz Refer to the VN1700 Voyager Service Manual and remove the fairing. Remove the front and rear seats, fairing and left fairing lower cover (black piece).
zz Open the trunk and remove the tray by pressing the center of the four lock rivets.
zz Remove the fuel tank mounting bolts and lift the tank to expose the frame.
Installation
Install CB Module
zz Mount the CB module using the two supplied 6 x 30mm bolts on the top and re-using the lower bolt. Tighten all three bolts firmly but do not over tighten as this may damage the plastic fairing lower.
zz Route the harness from the CB module behind the left engine guard and into the left side of the fairing. Find the matching multi-pin connector at the left side of the radio and connect to the CB module harness. Press the connectors together firmly to engage the waterproof seals. Secure the cables as needed with provided cable ties.
NOTE
oo If the optional XM Radio K10400-038 will also be installed, a K10400-042 Splitter Cable (sold separately) will also be needed to connect both XM and CB to the OE radio.
Install CB Antenna
zz Connect the threaded end of the CB antenna cable to the rightangle fitting on the CB module and firmly hand tighten.