HD 6/13-4 M HD 7/10-4 M
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
www.kaercher.com |
|
|
|
|
|
|
5.962-555 07/07 |
2
English
Please read and comply with these instructions prior to the
initial operation of your appliance. Retain these operating instructions for future reference or for subsequent possessors.
.Unit components
Please fold out illustration page at the front
1 Nozzle rest
2Handle
3High-pressure outlet
4Water connection
5Manometer
6Oil level display
7Oil reservoir
8Hood
9Unit switch
10Fastening screw for hood
11Hose rest
12Handgun support
13Nozzle
14Marking of the nozzle
15Spray lance
16Pressure/flow control
17Hand-held spray gun
18Safety catch of hand-held spray gun
19Lever of hand-held spray gun
20High-pressure hose
21Push-handle
22Cable holder
23Detergent metering valve
24Detergent suction hose with filter and screw cap
25Bottle holder for detergent
For your safety
Before you use the cleaner for the first time, read these operating instructions and take special note of the accompanying booklet "Safety Instructions for High-Pressure Cleaners" No. 5.951-949.
Symbols on the machine
High-pressure jets can be dan-
gerous if improperly used. The
jet must not be directed at persons, animals, live electrical equipment or at the appliance itself.
The appliance is not suited for use in the drinking water supply network. It is necessary to install a
suitable system separator from Kaercher, if the device is to be used in the drinking water supply network.
Use of the cleaner
Use this unit exclusively for
–cleaning with high-pressure jet and detergent (e.g. cleaning of machines, vehicles, buildings, tools),
–cleaning with high-pressure jet without detergent (e.g. cleaning facades, terraces, gardening equipment).
For stubborn dirt we recommend the dirt blaster as an optional accessory (for HD ...
Plus included in the delivery).
3
English
Safety features |
|
Preparing the unit for use |
|
|
|
Overflow valve with pressure switch
On reducing the flow rate with the pressure and flow control, the relief valve opens and part of the water runs back to the suction side of the pump.
If the lever of the hand-held spray gun is released, the pressure switch switches the pump off. If the lever is retracted, the pressure switch switches the pump on again.
Safety valve
The safety valve opens when the admissible operating excess pressure is exceeded; the water flows back to the pump suction side.
Overflow valve, pressure switch and safety valve are present in the factory and are sealed.
Adjustments are made only by Customer Service.
Protection of the environment, disposal
The packaging material can be recycled. Please do not place the pakkaging into the ordinary refuse for disposal, but arrange for the proper recycling.
Old appliances contain valuable materials that can be recycled. Please arrange for the proper recycling of old appliances. Batteries, oil, and similar substances must not enter the environment. Please dispose of your old appliances using appropriate collection systems.
Unpack the unit
–When unpacking the unit, check the contents of the packaging. If there has been any damage in transit inform the dealer.
–Do not dispose of the packaging with the household rubbish, hand it in at the appropriate collection point for recycling.
Check the oil level
Read the oil level displayed while unit is at a standstill. The oil level must be above the two indicators.
Activate the oil reservoir vent
Unscrew the fastening screw of the hood and remove the hood.
Cut off the tip on the cover to the oil reservoir.
Fasten the unit cover.
Mount the accessories
Mount nozzle on the spray lance (see markings on the top of the setting ring).
Fit the spray lance to the hand-held spray gun with pressure and flow control.
Screw on high-pressure hose to the highpressure outlet.
Switching on the unit
Electrical connection
Caution!
The appliance may only be connected to alternating current. The voltage must correspond with the type plate on the appliance.
Caution!
Use if required an extension cable with sufficient cable cross-section (refer technical details)and always fully unroll the cable from the cable drum.
4