Kambrook KBL110, KBL210 User Manual

0 (0)
Kambrook KBL110, KBL210 User Manual

Power Drive

 

1.5L Blender

Instruction Booklet

KBL110/KBL210

Important

Please retain your instruction book for future use.

In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 09 271 3980 (New Zealand). Alternatively, visit us on our website at www.kambrook.com.au

Contents

Kambrook Recommends

p4

Safety First

 

Your Kambrook Power Drive

p6

1.5L Blender

 

Using Your Blender

p7

Hints and Tips

p8

Care and Cleaning

p9

Recipes

p10

Warranty

p16

Kambrook Recommends Safety First

IMPORTANT: Please retain your instruction book for future use.

At Kambrook, we believe that safe performance is the first priority in any consumer product, so that you, our valued customer can confidently use and trust our products. We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions.

Important Safeguards For Your Kambrook

Power Drive Blender

Carefully read all instructions before operating the Kambrook Power Drive Blender for the first time and save for future reference.

Remove and safely discard any packaging material and promotional labels before using the blender for the first time.

To eliminate a choking hazard for young children, remove and safely discard the protective cover fitted to the power plug of this appliance.

Do not place the blender near the edge of a bench or table during operation. Ensure the surface is level, clean and free of water and other substances. Vibration during operation may cause the appliance to move.

Do not use the blender on a sink drain board.

Do not place the blender on or near a hot gas or electric burner, or where it could touch a heated oven.

Handle the blender and attachments with care – remember the blades are razor-sharp and should be kept out of the reach of children.

Always ensure the blender is completely assembled before operating. The blender will not operate unless properly assembled.

Do not use attachments other than those provided with the blender.

Do not attempt to operate the blender by any method other than those described in this booklet.

Always secure the blade assembly onto the blender jug before attaching to the motor base.

Ensure the Speed Selection dial is in the ‘OFF’ position and the blender is switched off at the power outlet and the power cord is unplugged before attaching the blender jug.

Always operate the blender with the blender jug lid in position.

Keep fingers, hands, knives and other utensils away from moving blades.

Do not place hands or fingers into the blender jug unless the motor and

blades have come to a complete stop. Ensure the Speed Selection dial is in the ‘OFF’ position and the appliance is switched off at the power outlet and the power cord is unplugged before removing the lid from the blender.

Ensure the motor and the blades have completely stopped before disassembling. Ensure the Speed Selection Dial is in the ‘OFF’ position and the appliance is switched off at the power outlet and the power cord is unplugged from the power

4

outlet before attempting to move the blender, when not in use, if left

unattended and before disassembling, cleaning or storing.

Care should be taken when removing the food from the blender jug by ensuring the motor and the blades have completely stopped before disassembling. Ensure the Speed Selector Dial is turned to the ‘OFF’ position, the appliance is switched off at the power outlet and unplugged, before removing the lid from the blender jug.

The blender jug should then be unlocked from the motor body and the food carefully removed before attempting to remove the blade assembly.

Do not operate the blender continuously for periods longer than 1 minute on any setting or if processing a heavy load. None of the recipes in this book are considered a heavy load. If

the blender is operated continuously for too long, it should be allowed to rest for 30 minutes before recommencing.

Do not process hot or boiling liquids – allow liquids to cool before placing into the blender jug.

Do not move the blender whilst in operation.

Do not leave the blender unattended when in use.

Do not place any part of the blender in the dishwasher or microwave oven.

Do not place anything on top of the blender jug when the lid is on, when in use and when stored.

Do not allow children to use the blender without supervision.

Keep the blender clean. Follow the cleaning instructions provided in this book.

Important Safeguards For All

Electrical Appliances

Fully unwind the power cord before use.

Do not let the power cord hang over the edge of a bench or table, touch hot surfaces or become knotted.

To protect against electric shock do not immerse the power cord, power plug or motor base in water or any other liquid.

The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

It is recommended to regularly inspect the appliance. To avoid a hazard do not use the appliance if power cord, power plug or appliance becomes damaged in any way. Return the entire appliance to the nearest authorised Kambrook Service Centre for examination and/or repair.

Any maintenance other than cleaning should be performed at an authorised Kambrook Service Centre.

This appliance is for household use only. Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.

The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It

is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.

5

Loading...
+ 11 hidden pages