Fax +32 2 359 95 50
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change the page numbering. Keep the language integrity. Print only what is inside the frame,
Blender
Batidora de Vaso
Blender
USK BL 16909
USK BL 16911
USK BL 33029
120V~60Hz 500W
Front cover page (first page)
Assembly page 1/24
Fax +32 2 359 95 50
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change the page numbering. Keep the language integrity. Print only what is inside the frame,
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the following:
1.READ ALL INSTRUCTIONS
2.Check that your mains voltage corresponds to that stated on the rating plate of the appliance before using the appliance.
3.To protect against electrical shock do not immerse cord, plug, or the motor unit in water or other liquid.
4.Close supervision is necessary when the appliance is used by or near children.
5.Unplug from outlet when not in use and before putting on or taking off parts or before cleaning.
6.Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair, or adjustment.
7.The use of accessory attachments, including the pouring jar, not recommended by the appliance manufacturer may cause injuries.
8.Do not use outdoors.
9.Do not let cord hang over edge of table or counter or touch hot surfaces.
10.Do not place on or near a hot gas or electric burner, or in a heated oven.
11.Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect remove the plug from the wall outlet.
12.Do not use appliance for other than intended use.
13.This kind of appliance cannot function continuously, it is not a professional type of appliance. It is necessary to make temporary stops. Check the section "Important information" in the instruction manual.
14.It is absolutely necessary to keep this appliance clean at all times as it comes into direct contact with food.
15.The pouring jar should be assembled correctly on the motor base before you plug it into the mains. The appliance is equipped with
2USK BL 16909/16911 - 110127
Assembly page 2/24
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change
Fax +32 2 359 95 50 the page numbering. Keep the language integrity. Print only what is inside the frame,
a safety, which prevents the pouring jar from working if it is not assembled correctly.
16.The appliance is designed for the preparation of small quantities of food, which have to be consumed rather quickly. It is not designed for the preparation of large quantities at once.
17.Keep hands and utensils out of container while blending to reduce the risk of severe personal injury and/or damage to blender. A rubber spatula may be used but must be used only when blender is not running.
18.Do not use a broken, chipped or cracked blender jar.
19.To reduce the risk of injury, never place the cutting unit blades on base without jar properly attached.
20.Blades are sharp, handle with care.
21.Always operate the blender with cover in place.
22.Always close the jar with the lid before starting mixing. When mixing hot liquid, do not fill more than 2/3 of the jar and be very careful in order to avoid splashing of hot liquid, otherwise you can get burned. Do not forget to close the feeding hole of the pouring jar with the cap.
23.Screw on blade assembly firmly. Injury can result if moving blades accidentally become exposed.
24.Do not leave blender unattended while it is operating.
25.To disconnect cord, turn the speed selector to "0" , then remove the plug from wall outlet.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
POLARIZED PLUG INSTRUCTIONS
Some appliances are equipped with a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit into the polarized outlet only one way. If the plug does not properly fit into the outlet at first, reverse it. If it still does not fit, contact a competent qualified electrician. Do not attempt to modify the plug in any way.
3 |
USK BL 16909/16911 - 110127 |
Assembly page 3/24
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change
Fax +32 2 359 95 50 the page numbering. Keep the language integrity. Print only what is inside the frame,
For appliances equipped with a standard plug, simply insert the plug into the outlet without paying attention to the way you plug it.
SHORT CORD INSTRUCTIONS
A short power supply cord is provided to reduce the hazards resulting from becoming entangled in, or tripping over a longer cord. Extension cords may be used if care is exercised in their use.
•The electrical rating of the extension cord should be at least that of the appliance. If the electrical rating of the extension cord is too low, it could overheat and burn.
•The resulting extended cord should be arranged so that it will not drape over the counter top or tabletop where it can be pulled on by children or tripped over.
PART DESCRIPTION
4 |
USK BL 16909/16911 - 110127 |
Assembly page 4/24
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change
Fax +32 2 359 95 50 the page numbering. Keep the language integrity. Print only what is inside the frame,
1. |
Locking cap with feeding |
5. |
Stainless steel blades |
|
opening |
6. |
Blade fixing ring |
2. |
Lid |
7. |
Motor block |
3. |
Tempered glass mixing jar |
8. |
Switch (P / 0 / 1 /2) |
4. |
Sealing ring |
9. |
Jar assembly |
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to follow this instruction carefully may result in damage to the motor. The maximum continuous usage time is 1 minute. After 1 minute of continuous use, you should insert a break of at least 10 minutes.
ASSEMBLY OF THE BLENDER AND USE
CAUTION!
If the blade is disassembled from the bottom of the jar, check the cleaning section for mounting instructions before continuing.
•Put pouring jar on the motor block and make sure it is correctly inserted.
•Remove the lid of the blender.
•Fill the pouring jar with the chosen ingredients.
•Close the lid.
•Plug in the appliance.
•Choose the mixing speed with the button on the motor base. The position 0 corresponds to the stopping of the appliance, the position 1 to the slow speed and the position 2 to the fast one.
•The position "P" (Pulse) is particular because the button has to be kept manually. This position is generally used to crush ice in order to avoid damages on the blades, but it can also be used to complete the mixing.
•It is also possible to add liquids or other ingredients anytime without stopping the appliance. You only have to remove the cap, which closes the feeding opening by turning and raising it straight up.
5 |
USK BL 16909/16911 - 110127 |
Assembly page 5/24
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change
Fax +32 2 359 95 50 the page numbering. Keep the language integrity. Print only what is inside the frame,
•Once you have finished the preparation, stop the appliance (position 0) and unplug the appliance.
•Remove the jar from the base. Then remove the lid and pour the liquid in the desired receptacle.
IMPORTANT: Always close the jar with the lid before starting mixing.
When mixing hot liquid, do not fill more than 2/3 of the jar and be very careful in order to avoid splashing of hot liquid, otherwise you can get burned. Do not forget to close the feeding hole of the pouring jar with the cap.
CAUTION: IN ORDER NOT TO DAMAGE THE RUBBER PART ROTATING THE BLADE, PLEASE WAIT UNTIL THE MOTOR HAS STOPPED COMPLETELY BEFORE REMOVING THE JAR FROM THE MOTOR BLOCK.
HOW TO CLEAN
•Always unplug from outlet before cleaning.
•For a quick rinsing of the pouring jar (for example between two preparations), you can use clear water and switch on your appliance for a few seconds. In this case, do not use any detergent.
•For a full cleaning, remove the jar from the motor block and turn the blade fixing ring on the bottom of the jar anti-clockwise to detach the sealing ring and the blade (this will make the cleaning easier). Then you can clean these parts with soapy water and rinse thoroughly with clear water. Dry before assembling. To attach the blades, put the sealing ring around the blades, insert them in the bottom of the jar and tighten the fixing ring by turning it clockwise (tighten vigorously in order to avoid leaks). Caution, do not lose the seal during this operation.
•You can wipe the motor block with a soft damp cloth.
CAUTION: AVOID CLEANING THE BLADES IN THE DISHWASHER TO AVOID RUST ISSUES OF SOME OF THE PARTS. DRY THE PARTS UNDER THE BLADES AFTER HANDWASH.
6 |
USK BL 16909/16911 - 110127 |
Assembly page 6/24
Fax +32 2 359 95 50
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change the page numbering. Keep the language integrity. Print only what is inside the frame,
WARRANTY
We suggest that you complete and return the enclosed Product Registration Card promptly to facilitate verification of the date of original purchase. However, return of the Product Registration Card is not a condition of these warranties. You can also fill this warranty card online, at the following address: www.KALORIK.com
This KALORIK product is warranted in the U.S.A. for 1 year from the date of purchase against defects in material and workmanship. This warranty is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance.
During this period, the KALORIK product that, upon inspection by KALORIK, is proved defective, will be repaired or replaced, at Kalorik’s option, without charge to the customer. If a replacement product is sent, it will carry the remaining warranty of the original product.
This warranty does not apply to any defect arising from a buyer's or user's misuse of the product, negligence, failure to follow KALORIK instructions noted in the user’s manual, use on current or voltage other than that stamped on the product, wear and tear, alteration or repair not authorized by KALORIK, or use for commercial purposes. There is no warranty for glass parts, glass containers, filter basket, blades and agitators, and accessories in general. There is also no warranty for parts lost by the user.
ANY WARRANTY OF MERCHANTABILITY OR FITNESS WITH RESPECT TO THIS PRODUCT IS ALSO LIMITED TO THE ONE YEAR LIMITED WARRANTY PERIOD.
Some states do not allow limitation on how long an implied warranty lasts or do not allow the exclusion of incidental or consequential damages, so the above limitations may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
7USK BL 16909/16911 - 110127
Assembly page 7/24
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change
Fax +32 2 359 95 50 the page numbering. Keep the language integrity. Print only what is inside the frame,
If the appliance should become defective within the warranty period and more than 30 days after date of purchase, do not return the appliance to the store: often, our Consumer Service Representatives can help solve the problem without having the product serviced. If servicing is needed, a Representative can confirm whether the product is under warranty and direct you to the nearest service location.
If this is the case, bring the product, or send it, postage prepaid by the user (all Kalorik customers are responsible for the initial shipment back to the warranty center), along with proof of purchase and indicating a return authorization number given by our Consumer Service Representatives, to the authorized KALORIK Service Center (please visit our website at www.KALORIK.com or call our Customer Service Department for the address of our authorized KALORIK Service Center).
If you send the product, please include a letter explaining the nature of the claimed defect.
If you have additional questions, please call our Consumer Service Department (please see below for complete contact information), Monday through Friday from 9:00am - 6:00pm (EST). Please note hours are subject to change.
If you would like to write, please send your letter to:
KALORIK Consumer Service Department
Team International Group of America Inc.
1400 N.W 159th Street, Suite 102
Miami Gardens, FL 33169 USA
Or call:
Toll Free: +1 888-521-TEAM / +1 888-KALORIK
Only letters can be accepted at this address above. Shipments and packages that do not have a return authorization number will be refused.
8 |
USK BL 16909/16911 - 110127 |
Assembly page 8/24
Loading...